A CMOS AFE With 37-nA rms Input-Referred Noise and Marked 96-dB Timing DR for Pulsed LiDAR
The DOI matches its Crossref record; 34 of the 34 references it cites were found in a registry or an index.
Abstract
This paper presents an analog front-end (AFE) circuit with marked timing point for pulsed time-of-flight LiDAR that employs either sampling- or event-based timing approach. The proposed AFE adopts a dual-mode structure for its pre-amplifier which can be configured as a charge-sensitive amplifier (CSA) or a gated active load-assisted TIA (GALA-TIA), depending on the intensity of input current. As a result, both the sensitivity and dynamic range (DR) of the AFE have been effectively improved. In addition, the zero-crossing point of the output signal has been marked as the timing point with a built-in pulse shaper, which allows the back-end circuits of LiDAR receiver discriminate the timing conveniently and accurately. The measured input-referred RMS noise current of the proposed AFE is 37 nA. With dual-mode control, a linear output DR of 80 dB and a wide timing DR of 96 dB with walk error no more than ±160 ps have been achieved. For single-shot measurement application, only CSA mode was enabled and the pulse widths of saturated output signals have been measured to compensate the walk errors, which realized a timing DR of 78 dB with accuracy of ±150 ps. The averaged power consumption is 66 mW and the total silicon area is$0.79\times 0.42\,\,mm^{2}$in 0.18-$\mu \text{m}$CMOS process.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Design of Analog CMOS Integrated Circuits
Razavi, B. (1999) · Cited by 6,609
Schwarz, B. (2010) · Nature Photonics · doi:10.1038/nphoton.2010.148 · Cited by 667 · cited 1×
“L IGHT detection and ranging (LiDAR) has been playing important role in human’s daily life, from 1-D (dimensional) rangefinders to 2-D profilers, and 3-D mapping (or 3-D imaging) [1].”
BackgroundLidar System Architectures and Circuits
Behroozpour, B., Sandborn, P. A. M., Wu, M. C., & Boser, B. E. (2017) · IEEE Communications Magazine · doi:10.1109/mcom.2017.1700030 · Cited by 499 · cited 1×
“wave (AMCW) LiDAR and frequency-modulated continuouswave (FMCW) LiDAR [9], [10], the pulsed time-of-flight”
BackgroundNoise Limits of CMOS Current Interfaces for Biosensors: A Review
Crescentini, M., Bennati, M., Carminati, M., & Tartagni, M. (2014) · IEEE Transactions on Biomedical Circuits and Systems · doi:10.1109/tbcas.2013.2262998 · Cited by 178 · cited 1×
“Since the feedback path of CSA is a noise-free capacitor, CSA shows great advantage in noise performance compared to TIA [29].”
BackgroundA 10-bit 5-Msample/s CMOS two-step flash ADC
Doernberg, J., Gray, P. R., & Hodges, D. A. (1989) · IEEE Journal of Solid-State Circuits · doi:10.1109/4.18582 · Cited by 121 · cited 3×
“718) per stage results in the largest GBP [34], in this design, the gains of the amplifier stages are”
BackgroundInfluentialNissinen, J., Nissinen, I., & Kostamovaara, J. (2009) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2009.2017006 · Cited by 105 · cited 2×
“For the single-shot measurement application scenarios, the width [18], [22] or slew rate [23] of the echo pulse, or both of them [12], [24] can be measured and utilized to compensate for the walk”
MethodA wide dynamic range receiver channel for a pulsed time-of-flight laser radar
Ruotsalainen, T., Palojärvi, P., & Kostamovaara, J. (2001) · IEEE Journal of Solid-State Circuits · doi:10.1109/4.938373 · Cited by 93 · cited 2×
“While in an event-based receiver, a larger input overdrive voltage for the timing comparator will result in less input slew rate-induced additional walk error [19].”
BackgroundYoshioka, K., Kubota, H., Fukushima, T., Kondo, S., Ta, T. T., Okuni, H., Watanabe, K., Hirono, M., Ojima, Y., Kimura, K., et al. (2018) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2018.2868315 · Cited by 92 · cited 4×
“to enlarge the DR of AFE since it can provide wide-DR linear voltage output [2]–[6], [11], [15]–[17].”
BackgroundMethodInfluentialA High-Sensitivity and Low-Walk Error LADAR Receiver for Military Application
Cho, H.-S., Kim, C.-H., & Lee, S.-G. (2014) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2014.2327282 · Cited by 88 · cited 8×
“than 1:12,000 (82 dB) [11] even with 4-level gain control [2].”
BackgroundMethodInfluentialAn Integrated Laser Radar Receiver Channel Utilizing a Time-Domain Walk Error Compensation Scheme
Kurtti, S., & Kostamovaara, J. (2011) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2010.2047663 · Cited by 71 · cited 2×
“For the single-shot measurement application scenarios, the width [18], [22] or slew rate [23] of the echo pulse, or both of them [12], [24] can be measured and utilized to compensate for the walk”
Method
Research works printed but not linked: 4
- 2018, Velodynes Hdl-64E: A High Definition Lidar Sensor for 3-D
- 2018, First Sensor AD500-9-TO52-S1 Datasheet
- 2021, Siglent
- 2020, Getting the Most Out of the EPC9126 Laser Driver
Cited by
A CMOS AFE Array With DC Input Current Cancellation for FMCW LiDAR
Zheng, X., Ye, M., Li, Z., Li, Y., Wang, Q., & Zhao, Y. (2024) · IEEE Transactions on Very Large Scale Integration (VLSI) Systems · doi:10.1109/tvlsi.2024.3350870 · Cited by 11
“ToF LiDAR, the current traditional method, measures the flight time t between the transmitted laser pulse and the echo pulse [7], [8], [9].”
BackgroundMethodInfluentialSelf-citationA Low-Cost Measurement Methodology for LiDAR Receiver Integrated Circuits
Joo, J.-E., Choi, S., Chon, Y., & Park, S. (2023) · Sensors · doi:10.3390/s23136002 · Cited by 5
“[11] improved timing dynamic range and sensitivity characteristics with dual-mode control.”
BackgroundChon, Y., Choi, S., & Park, S.-M. (2024) · Photonics · doi:10.3390/photonics11100974 · Cited by 3
“[19] presented a wideband receiver for a 3D ranging LiDAR system that exploited a series resistor array with PMOS switches, hence extending the dynamic range up to 64 dB.”
BackgroundA fully differential wideband analog front end for FMCW LiDAR application
Zheng, X., Ye, M., Wang, Q., Li, Y., & Zhao, Y. (2023) · Microelectronics Journal · doi:10.1016/j.mejo.2023.105948 · Cited by 3
Self-citationLi, K., Su, S., Huang, Z., Zhao, Y., & Guo, J. (2025) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2025.3552469 · Cited by 2
“In these tests, for wide input pulses the edge time is set as one-third of T FWHM , while for the 3-ns pulse, the edge time is set as 1.5 ns to emulate a commonly adopted laser shape [8], [10], [12], [20].”
InfluentialSelf-citation
Metadata
- Authors
- Li, K., Guo, J., & Zhao, Y.
- Affiliations
- Sun Yat-sen University (CN)
- Venue
- IEEE Transactions on Circuits and Systems I: Regular Papers
- Published
- 2022-09
- Volume
- 69
- Issue
- 9
- Pages
- 3565-3578
- ISSN
- 1549-8328 (ISSN-L)
- 1558-0806
- OpenAlex
- W4293768846
- Cited by
- 14
- References
- 34
- Citations by year
- 2026: 4 · 2025: 5 · 2024: 2 · 2023: 2 · 2022: 1
- FWCI
- 1.11
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- IEEE Transactions on Circuits and Systems I Regular Papers (publishedVersion)
- Funders
- National Natural Science Foundation of China (61874143)
- Joint Foundation of Key Laboratory, Shanghai Jiao Tong University–Xidian University, Ministry of Education
- Topics
- Physical Sciences › Physics and Astronomy › Instrumentation › Advanced Optical Sensing Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Analog and Mixed-Signal Circuit Design
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Radio Frequency Integrated Circuit Design
- Keywords
- analog front-end, pulsed lidar, time-of-flight LiDAR, charge sensitive amplifier, input-referred noise, pulse shaper, CMOS integrated circuit
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A CMOS AFE With 37-nA rms Input-Referred Noise and Marked 96-dB Timing DR for Pulsed LiDAR. https://app.cochat.ai/papers/10.1109/tcsi.2022.3181133
- The paper
- Li, K., Guo, J., & Zhao, Y. (2022). A CMOS AFE With 37-nA rms Input-Referred Noise and Marked 96-dB Timing DR for Pulsed LiDAR. IEEE Transactions on Circuits and Systems I: Regular Papers. https://doi.org/10.1109/tcsi.2022.3181133
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.