The DOI matches its Crossref record; 8 of the 11 references it cites were found in a registry or an index.
Quality Assurance Testing for Magnetization Quality Assessment of BLDC Motors Used in Compressors
Abstract
Quality assurance (QA) testing of mass-produced electrical appliances is critical for the reputation of manufacturer since defective units will have a negative impact on safety, reliability, efficiency, and performance of the end product. It has been observed at a brushless dc (BLDC) compressor motor manufacturing facility that improper magnetization of the rotor permanent magnet is one of the leading causes of motor defects. A new technique for postmanufacturing assessment of the magnetization quality of concentrated winding BLDC compressor motors for QA is proposed in this paper. The new method evaluates the data acquired during the test runs performed after motor assembly to observe anomalies in the zero-crossing pattern of the back-EMF voltages for screening motor units with defective magnetization. An experimental study on healthy and defective 250-W BLDC compressor motor units shows that the proposed technique provides sensitive detection of magnetization defects that existing tests were not capable of finding. The proposed algorithm does not require additional hardware for implementation since it can be added to the existing test-run inverter of the QA system as a software algorithm.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
ZCP detection in the BEMF waveform enables detection of very small DFs in the online mode.
“It was shown in this work that this method enables the detection of very small DFs in the online mode.”
From Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges (2022) · cites this paper as [115]
Citations
Cites
Design of Brushless Permanent-Magnet Motors
Hendershot, J. R., & Miller, T. (1995) · doi:10.1093/oso/9780198593898.001.0001 · Cited by 1,232
Kopp, N., Toliyat, H. A., & Kliman, G. B. (2010) · CRC Press eBooks · doi:10.1201/9781420030389 · Cited by 380
Detecting Rotor Faults in Low Power Permanent Magnet Synchronous Machines
le Roux, W., Harley, R. G., & Habetler, T. G. (2007) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2006.886620 · Cited by 274
Rajagopalan, S., Roux, W. L., Habetler, T. G., & Harley, R. G. (2007) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2007.904183 · Cited by 164
Lee, K., Kim, D.-K., Kim, B., & Kwon, B. (2008) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2007.912734 · Cited by 101
Self-citationHardware-In-the-Loop Simulation of Finite-Element Based Motor Drives with RT-LAB and JMAG
Abourida, S., Dufour, C., Bélanger, J., Yamada, T., & Arasawa, T. (2006) · IEEE International Symposium on Industrial Electronics (ISIE) · doi:10.1109/isie.2006.295959 · Cited by 70
García, J. R., Romeral, L., Ortega, J. A., & Urresty, J.-C. (2008) · IEEE International Symposium on Industrial Electronics (ISIE) · doi:10.1109/isie.2008.4677217 · Cited by 61
Post Assembly Magnetization Patterns in Rare-Earth Permanent-Magnet Motors
Dorrell, D. G., Hsieh, M., & Hsu, Y.-C. (2007) · IEEE Transactions on Magnetics · doi:10.1109/tmag.2007.893715 · Cited by 42
Flagged first, then by citations
3 of the 11 references couldn’t be matched to a known paper.
Research works printed but not linked: 4
- 1988, Method of magnetizing rotor of motor
- 2005, Apparatus and method of using the stator coils of an electric motor to magnetize permanent magnets of the motor rotor when the span of each stator coil is smaller than the width of each permanent magnet pole
- 2000, Magnetizing method for a permanent-magnet motor
- 2005, IEEE Guide for Diagnostic Field Testing of Electric Power Apparatus
Cited by
Sorted by citations
Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges
Orlowska-Kowalska, T., Wolkiewicz, M., Pietrzak, P., Skowron, M., Ewert, P., Tarchala, G., Krzysztofiak, M., & Kowalski, C. T. (2022) · IEEE Access · doi:10.1109/access.2022.3180153 · Cited by 328
Faiz, J., & Mazaheri-Tehrani, E. (2017) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2016.2608950 · Cited by 207
Lee, K., Park, S., & Jeong, S. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2316198 · Cited by 83
Self-citationBist, V., & Singh, B. (2015) · IET Power Electronics · doi:10.1049/iet-pel.2014.0981 · Cited by 24
Research on Fault Indicator for Integrated Fault Diagnosis System of PMSM Based on Stator Tooth Flux
Lv, K., Wang, D., Huang, W., & Hu, J. (2023) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2023.3334866 · Cited by 22
Modeling and Effects of In Situ Magnetization of Isotropic Ferrite Magnet Motors
Hsieh, M., Dorrell, D. G., Lin, C.-K., Chen, P., & Wung, P. Y. P. (2013) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2013.2271472 · Cited by 21
Choi, D., Kang, T.-J., Lee, S. B., Kim, J., & Kim, J. H. (2018) · IEEE Industry Applications Magazine · doi:10.1109/mias.2017.2740469 · Cited by 15
Self-citationNavarro-Navarro, Á., Ruiz-Sarrió, J. E., Biot-Monterde, V., Daviu, J. A. A., Becker, V., & Urschel, S. (2023) · Machines · doi:10.3390/machines11020288 · Cited by 15
Darba, A., D'haese, P., Belie, F. D., & Melkebeek, J. A. A. (2015) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2015.2399623 · Cited by 13
Negri, G. H., Bartsch, A. G., Cavalca, M. S. M., de Oliveira, J., Nied, A., & Silveira, A. D. S. (2014) · IEEE International Conference on Industry Applications · doi:10.1109/induscon.2014.7059407 · Cited by 13
Gao, J., Gui, W., Xie, X., Wan, R., Yin, S., & Yang, C. (2025) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2025.3568276 · Cited by 12
Kalla, U. K., Rathore, K. S., Bhati, N., Palwalia, D. K., & Singh, B. (2021) · IET Renewable Power Generation · doi:10.1049/rpg2.12129 · Cited by 8
Effect of partial saturation of bonded neo magnet on the automotive accessory motor
Sheth, N. K., & Angara, R. C. S. B. (2016) · AIP Advances · doi:10.1063/1.4973496 · Cited by 5
Design of IPMSM for the Electrical Compressor in EV
Hwang, K.-Y., Park, G.-B., & Cho, H.-S. (2011) · SAE technical papers on CD-ROM/SAE technical paper series · doi:10.4271/2011-28-0063 · Cited by 5
Lee, K. (2015) · Journal of Power Electronics · doi:10.6113/jpe.2015.15.5.1264 · Cited by 3
Self-citationA novel demagnetization fault detection of brushless DC motors based on current time-series features
Faiz, J., & Mazaheri‐Tehrani, E. (2017) · IEEE International Symposium on Diagnostics for Electrical Machines, Power Electronics and Drives (SDEMPED) · doi:10.1109/demped.2017.8062350 · Cited by 3
Shen, H., Li, Y., Zhao, W., Zhu, C., & Kwon, B. (2018) · International Conference on Electrical Machines and Systems (ICEMS) · doi:10.23919/icems.2018.8549348 · Cited by 3
Multi-source data fusion for demagnetization fault diagnosis of PMSM based on SDP and CNN
Xiong, Z., Lv, M., & Liu, Z. (2025) · IEEE Data Driven Control and Learning Systems Conference (DDCLS) · doi:10.1109/ddcls66240.2025.11065276 · Cited by 2
Quality control of magnets during magnetization of internal permanent magnet rotors
Dinca, C., Schwarzer, D., & Schäfer, U. (2016) · International Conference on Electrical Machines (ICEM) · doi:10.1109/icelmach.2016.7732801 · Cited by 2
Analysis of Inverter Circulating Current and Magnetic Potential for Flux-Weakening Drive of BLDCM
Li, X., Wang, S., & Xia, L. (2023) · Electronics · doi:10.3390/electronics12112450 · Cited by 1
Zhang, J., Sun, H., Han, T., & Shi, X. (2026) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2026.3675101 · Cited by 1
Omi, Y., Yasuda, T., Kumagai, T., Watanabe, H., & Itoh, J. (2023) · European Conference on Power Electronics and Applications · doi:10.23919/epe23ecceeurope58414.2023.10264233 · Cited by 1
Impact Analysis of PM magnetization level on motor performance: simulations and experimental results
Staudt, T., Akinaga, T. H., Lopes, L. U., Maccari, F., & Wendhausen, P. A. P. (2017) · Journal of Microwaves Optoelectronics and Electromagnetic Applications · doi:10.1590/2179-10742017v16i1879 · Cited by 1
Automatic Inspection System for Electric Motors with Integrated Bus Interface
Lelkes, A. (2012) · Electrical and Electronic Engineering · doi:10.5923/j.eee.20120202.08
Stator insulation quality assurance testing for appliance motors with aluminum windings
Choi, D., Kang, T.-J., Lee, S. B., Kim, J., & Kim, J. (2016) · IEEE Energy Conversion Congress and Exposition (ECCE) · doi:10.1109/ecce.2016.7855465
Self-citationReduction Method of Stopping Vibration for Compressor in Home Appliances
Shioi, T., Kumagai, T., Kusaka, K., Jun-ichi, I., & Nagaoka, I. (2021) · European Conference on Power Electronics and Applications · doi:10.23919/epe21ecceeurope50061.2021.9570189
Quality Assurance Testing for Detecting Magnetization Defects in Surface PM Synchronous Machines
Lee, H., Yoon, Y., Orviz, M., Shin, S.-M., Tiemblo, J. G.-A., Laborda, D. F., Reigosa, D., & Lee, S. B. (2025) · IEEE Energy Conversion Congress and Exposition (ECCE) · doi:10.1109/ecce58356.2025.11259936
Self-citation
Metadata
- Authors
- Lee, K.-W., Hong, J., Lee, S. B., & Lee, S.
- Affiliations
- Korea University (KR)
- ORCID
- Lee, Sang Bin
- Venue
- IEEE Transactions on Industry Applications
- Published
- 2010-11
- Volume
- 46
- Issue
- 6
- Pages
- 2452-2458
- ISSN
- 0093-9994 (ISSN-L)
- 1939-9367
- OpenAlex
- W2172706713
- Cited by
- 27
- References
- 11
- Citations by year
- 2026: 1 · 2025: 3 · 2023: 4 · 2022: 1 · 2021: 2 · 2018: 2 · 2017: 2 · 2016: 4 · 2015: 3 · 2014: 2 · 2013: 1 · 2012: 1
- FWCI
- 0.76
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Industry Applications (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electric Motor Design and Analysis
- Physical Sciences › Engineering › Control and Systems Engineering › Machine Fault Diagnosis Techniques
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Sensorless Control of Electric Motors
- Keywords
- quality assurance testing, brushless DC motor, compressor motor
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
