Sensorless Direct Torque and Flux-Controlled IPM Synchronous Motor Drive at Very Low Speed Without Signal Injection
The DOI matches its Crossref record; 31 of the 31 references it cites were found in a registry or an index.
Abstract
This paper proposes a novel speed-sensorless direct torque and flux control scheme for an interior permanent-magnet synchronous motor drive. The drive uses a new stator flux observer based on the extended rotor flux concept. Due to the simultaneous implementation of stationary and rotating reference frames, the proposed observer does not require any speed adaptation and is inherently sensorless. Unlike speed adaptive observers, the proposed observer is immune to speed estimation errors; thus, its performance at very low speed is improved significantly. A novel stator resistance estimator is incorporated into the sensorless drive to compensate the effects of stator resistance variation. The global asymptotic stabilities of both the flux observer and stator resistance estimator are guaranteed by the Lyapunov stability analysis. Simulation and experimental results at very low speeds, including 0 and 5 r/min, confirm the effectiveness of the proposed method.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Classical speed/position observers based on stator flux estimation, including extended observer [279] or sliding mode observer (SMO) [280], can be used for speed residuum generation.”
From Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges (2022) · cites this paper as [279]
Citations
Cites
Analysis of direct torque control in permanent magnet synchronous motor drives
Zhong, L., Rahman, M. F., Hu, W. Y., & Lim, K. W. (1997) · IEEE Transactions on Power Electronics · doi:10.1109/63.575680 · Cited by 951 · cited 1×
“In the late 1990s, the direct torque control (DTC) was successfully implemented on IPMSMs, as reported in [1]–[3].”
Self-citationCorley, M. J., & Lorenz, R. D. (1998) · IEEE Transactions on Industry Applications · doi:10.1109/28.703973 · Cited by 844 · cited 3×
“These methods can be classified into α−β frame rotating injection [20], [21], d−q frame pulsating injection [22], [23], and d−q frame rotating injection [24], [25].”
MethodSensorless full-digital PMSM drive with EKF estimation of speed and rotor position
Bolognani, S., Oboe, R., & Zigliotto, M. (1999) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.744410 · Cited by 610 · cited 1×
“On the other hand, EKF-based DTC induction motor drives with stable operation at very low speed including 1 r/min were proposed in [11] and [12].”
MethodActive Flux Concept for Motion-Sensorless Unified AC Drives
Boldea, I., Paicu, M. C., & Andreescu, G.-D. (2008) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2008.2002394 · Cited by 433 · cited 1×
“Another observer based on a similar concept was explained in [26].”
BackgroundIchikawa, S., Tomita, M., Doki, S., & Okuma, S. (2006) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2006.870875 · Cited by 383 · cited 2×
“Due to its many advantages, adaptive observers [13]–[19] in various reference frames are commonly used.”
BackgroundHoltz, J., & Quan, J. (2002) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2002.800779 · Cited by 376 · cited 3×
“To sustain very low speed sensorless operation, accurate dead time is mandatory [ 28 ].”
BackgroundMethodInfluentialTang, L., Zhong, L., Rahman, M. F., & Hu, Y. (2004) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.823170 · Cited by 365 · cited 2×
“Open-loop back electromotive force (EMF)-based estimators have been described in [4]–[9].”
BackgroundSelf-citationHoltz, J., & Quan, J. (2002) · Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248) · doi:10.1109/ias.2001.955988 · Cited by 354
Speed-Sensorless Estimation for Induction Motors Using Extended Kalman Filters
Barut, M., Bogosyan, S., & Gokasan, M. (2007) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2006.885123 · Cited by 329 · cited 1×
“On the other hand, EKF-based DTC induction motor drives with stable operation at very low speed including 1 r/min were proposed in [11] and [12].”
MethodRahman, M. F., Zhong, L., & Lim, K. W. (1998) · IEEE Transactions on Industry Applications · doi:10.1109/28.738985 · Cited by 298
Self-citation
Cited by
Zhang, Y., & Zhu, J. (2011) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2010.2059047 · Cited by 389
“In the SVM-based DTC schemes, rotary coordinate transformation is often needed [5]–[12], which is more computationally intensive than the conventional DTC [13].”
BackgroundFoo, G. H. B., Zhang, X., & Vilathgamuwa, D. M. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2013.2244537 · Cited by 369
“Generally, position sensor failure can easily be identified by means of a speed observer [10], [11].”
BackgroundSelf-citationFault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges
Orlowska-Kowalska, T., Wolkiewicz, M., Pietrzak, P., Skowron, M., Ewert, P., Tarchala, G., Krzysztofiak, M., & Kowalski, C. T. (2022) · IEEE Access · doi:10.1109/access.2022.3180153 · Cited by 328
“Classical speed/position observers based on stator flux estimation, including extended observer [279] or sliding mode observer (SMO) [280], can be used for speed residuum generation.”
BackgroundMethodZhang, X., & Hou, B. (2018) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2017.2691776 · Cited by 317
“tially [14], [15].”
A Review of Sliding Mode Observer Based Sensorless Control Methods for PMSM Drive
Zuo, Y., Lai, C., & Iyer, K. L. V. (2023) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2023.3287828 · Cited by 311
“For the model-based position sensorless control method of PMSMs, the extended electromotive force (EEMF) model [6] and the active flux (AF) model [7] (also defined as “extended rotor flux” model in [8] or “equivalent EMF” model in [9]) are the most popular models for PMSMs to obtain the related position information.”
BackgroundMethod
Metadata
- Authors
- Foo, G., & Rahman, M. F.
- Affiliations
- UNSW Sydney (AU)
- ORCID
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 2010-01
- Volume
- 57
- Issue
- 1
- Pages
- 395-403
- ISSN
- 0278-0046 (ISSN-L)
- OpenAlex
- W2141603443
- Cited by
- 198
- References
- 31
- Citations by year
- 2026: 4 · 2025: 4 · 2024: 7 · 2023: 6 · 2022: 9 · 2021: 10 · 2020: 8 · 2019: 14 · 2018: 12 · 2017: 11 · 2016: 12 · 2015: 12 · 2014: 11 · 2013: 20 · 2012: 22
- FWCI
- 15.34
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Industrial Electronics (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Sensorless Control of Electric Motors
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electric Motor Design and Analysis
- Physical Sciences › Engineering › Control and Systems Engineering › Control Systems and Identification
- Keywords
- sensorless control, direct torque control, flux control, interior permanent magnet synchronous motor, stator flux observer, stator resistance estimation, Lyapunov stability, global asymptotic stability
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Sensorless Direct Torque and Flux-Controlled IPM Synchronous Motor Drive at Very Low Speed Without Signal Injection. https://app.cochat.ai/papers/10.1109/tie.2009.2030815
- The paper
- Foo, G., & Rahman, M. F. (2010). Sensorless Direct Torque and Flux-Controlled IPM Synchronous Motor Drive at Very Low Speed Without Signal Injection. IEEE Transactions on Industrial Electronics. https://doi.org/10.1109/tie.2009.2030815
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.