The DOI matches its Crossref record; 31 of the 31 references it cites were found in a registry or an index.
Direct Torque Control of an IPM-Synchronous Motor Drive at Very Low Speed Using a Sliding-Mode Stator Flux Observer
Abstract
Direct torque control of interior permanent-magnet synchronous motors is known to deliver fast torque and flux dynamic responses. However, the poor flux estimation at very low speeds has been its largest drawback. A multitude of flux observers have been proposed for flux estimation, but most of them fail to fare in the low-speed region. This paper proposes a sliding-mode stator flux observer for improved flux estimation at very low speeds. Unlike conventional flux observers, this observer does not require any speed adaptation mechanism and is immune to speed estimation error. A novel stator resistance estimator is incorporated into the sensorless drive to compensate the effects of stator resistance variation. Global asymptotic stability of both the flux observer and stator resistance estimator is guaranteed by the Lyapunov stability analysis. DC-offset effects are mitigated by introducing a small integral component in the observer gains. Simulation and experimental results at very low speeds, including 0 and 2 r/min, without signal injection confirm the effectiveness of the proposed method.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Classical speed/position observers based on stator flux estimation, including extended observer [279] or sliding mode observer (SMO) [280], can be used for speed residuum generation.”
From Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges (2022) · cites this paper as [280]
Citations
Cites
A New Quick-Response and High-Efficiency Control Strategy of an Induction Motor
Takahashi, I., & Noguchi, T. (1986) · IEEE Transactions on Industry Applications · doi:10.1109/tia.1986.4504799 · Cited by 3,407 · cited 2×
“S INCE the advent of direct torque control (DTC) for induction machines in the 1980s, as proposed by Depenbrock [1] and Takahashi and Noguchi [2], its research has been becoming ever more prevalent in the society.”
BackgroundDirect self-control (DSC) of inverter-fed induction machine
Depenbrock, M. (1988) · IEEE Transactions on Power Electronics · doi:10.1109/63.17963 · Cited by 1,705
Analysis of direct torque control in permanent magnet synchronous motor drives
Zhong, L., Rahman, M. F., Hu, W. Y., & Lim, K. W. (1997) · IEEE Transactions on Power Electronics · doi:10.1109/63.575680 · Cited by 951 · cited 3×
“They can be broadly classified as follows: 1) open-loop back-EMF-based estimators [3]–[6];”
BackgroundSelf-citationDSP-based speed adaptive flux observer of induction motor
Kubota, H., Matsuse, K., & Nakano, T. (1993) · IEEE Transactions on Industry Applications · doi:10.1109/28.216542 · Cited by 908
Active Flux Concept for Motion-Sensorless Unified AC Drives
Boldea, I., Paicu, M. C., & Andreescu, G.-D. (2008) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2008.2002394 · Cited by 433 · cited 1×
“This observer uses the active flux concept [24]–[26] that makes sensorless control simpler to be performed on an IPM machine.”
MethodHoltz, J., & Quan, J. (2002) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2002.800779 · Cited by 376
Foo, G., & Rahman, M. F. (2010) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2009.2030820 · Cited by 367 · cited 1×
“2) closed-loop adaptive observers based on advanced models [7]–[16]; 3) estimation based on high-frequency signal injection, exploiting the saliency property of an IPMSM [17]–[23].”
BackgroundSelf-citationTang, L., Zhong, L., Rahman, M. F., & Hu, Y. (2004) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.823170 · Cited by 365 · cited 1×
“The reference flux value was selected according to the maximum torque per ampere (MTPA) trajectory to increase the efficiency of the drive system [4].”
MethodSelf-citationHoltz, J., & Quan, J. (2002) · Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248) · doi:10.1109/ias.2001.955988 · Cited by 354
Speed-Sensorless Estimation for Induction Motors Using Extended Kalman Filters
Barut, M., Bogosyan, S., & Gokasan, M. (2007) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2006.885123 · Cited by 329 · cited 1×
“2) closed-loop adaptive observers based on advanced models [7]–[16]; 3) estimation based on high-frequency signal injection, exploiting the saliency property of an IPMSM [17]–[23].”
Background
Cited by
Zhang, X., Sun, L., Zhao, K., & Sun, L. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2012.2206610 · Cited by 725
“, robust control [4], [5], sliding-mode control (SMC) [6], [7], [10], [16], adaptive control [8], backstepping control [9], predictive control [11], intelligent control [13], [14], and so on.”
BackgroundFault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges
Orlowska-Kowalska, T., Wolkiewicz, M., Pietrzak, P., Skowron, M., Ewert, P., Tarchala, G., Krzysztofiak, M., & Kowalski, C. T. (2022) · IEEE Access · doi:10.1109/access.2022.3180153 · Cited by 328
“For more information, see https://creativecommons.org/licenses/by-nc-nd/4.0/ VOLUME XX, 2017 45 SMO is utilized to estimate the rotor position/speed using the restructured current only for a single phase CS fault.”
BackgroundMethodInfluentialZhu, H., Xiao, X., & Li, Y. (2012) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2011.2157278 · Cited by 201
Zhang, Y., & Zhu, J. (2011) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2129577 · Cited by 201
“including permanent magnet synchronous motor (PMSM) [3], [ 4 ], doubly fed induction generator (DFIG) [5], synchronous reluctance machine [6], etc.”
BackgroundFuzzy Sliding Mode Speed Controller for PM Synchronous Motors With a Load Torque Observer
Leu, V. Q., Choi, H. H., & Jung, J.-W. (2012) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2161488 · Cited by 200
“In recent years, various nonlinear control algorithms have been presented, such as adaptive control [5], [6], robust control [7], backstepping control [8], feedback linearization control [9], direct torque control [10]–[12], and intelligent control [13].”
Background
Metadata
- Authors
- Foo, G. H. B., & Rahman, M. F.
- Affiliations
- UNSW Sydney (AU)
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2010-04
- Volume
- 25
- Issue
- 4
- Pages
- 933-942
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2167076531
- Cited by
- 190
- References
- 31
- Citations by year
- 2026: 1 · 2025: 4 · 2024: 9 · 2023: 9 · 2022: 7 · 2021: 12 · 2020: 15 · 2019: 15 · 2018: 10 · 2017: 17 · 2016: 14 · 2015: 15 · 2014: 18 · 2013: 7 · 2012: 17
- FWCI
- 9.78
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Power Electronics (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Sensorless Control of Electric Motors
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electric Motor Design and Analysis
- Physical Sciences › Engineering › Control and Systems Engineering › Adaptive Control of Nonlinear Systems
- Keywords
- direct torque control, interior permanent magnet synchronous motor, sliding mode observer, stator flux estimation, sensorless drive, stator resistance estimation, DC offset compensation, Lyapunov stability, global asymptotic stability
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Direct Torque Control of an IPM-Synchronous Motor Drive at Very Low Speed Using a Sliding-Mode Stator Flux Observer. https://app.cochat.ai/papers/10.1109/tpel.2009.2036354
- The paper
- Foo, G. H. B., & Rahman, M. F. (2010). Direct Torque Control of an IPM-Synchronous Motor Drive at Very Low Speed Using a Sliding-Mode Stator Flux Observer. IEEE Transactions on Power Electronics. https://doi.org/10.1109/tpel.2009.2036354
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.