A Linear Dynamic Range Receiver With Timing Discrimination for Pulsed TOF Imaging LADAR Application
The DOI matches its Crossref record; 22 of the 22 references it cites were found in a registry or an index.
Abstract
This paper presents a linear and wide dynamic range (DR) receiver for pulsed time-of-flight imaging laser detection and ranging application, which can capture the pulsed echo intensity. The alternative leading edge timing discrimination scheme with two threshold voltages by differential voltage shift is utilized to compensate the walk error, and thus accurately obtain timing information. The proposed receiver was implemented and fabricated in a 0.18-μm CMOS technology. The receiver achieves a high differential transimpedance gain of 106 dBQ, a wide differential output swing of about 1.8 V, an input-referred noise current of 4.55 pA/Hz0.5and a minimum detectable signal of about 0.28 μArms at SNR = 5, leading to a linear DR of 66 dB with a 3.3-V power supply. The area of the receiver chip is equal to 0.95 × 0.95 mm2.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Ref. [18] realized a resistive feedback TIA with a replica circuit followed by a cascaded variable-gain amplifier for the gain control mechanism.It also employed a timing discriminator with differential voltage shifters to compensate for the walk errors.However, it required a large power consumption.”
From A CMOS Optoelectronic Transimpedance Amplifier Using Concurrent Automatic Gain Control for LiDAR Sensors (2024) · cites this paper as [18]
Citations
Cites
Nissinen, J., Nissinen, I., & Kostamovaara, J. (2009) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2009.2017006 · Cited by 105 · cited 3×
“Although [1], [4], [19], and [21] have a wider DRand lower walk error than the proposed receiver, however, the above-mentioned work cannot linearly capture the pulsed echo intensity signal for imaging LADAR application.”
Extrinsic Calibration of 2-D Laser Rangefinder and Camera From Single Shot Based on Minimal Solution
Hu, Z., Li, Y., Li, N., & Zhao, B. (2016) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2016.2518248 · Cited by 90
A High-Sensitivity and Low-Walk Error LADAR Receiver for Military Application
Cho, H.-S., Kim, C.-H., & Lee, S.-G. (2014) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2014.2327282 · Cited by 88 · cited 4×
“To linearly capture the intensity signal of the pulsed echo, the proposed receiver with AGC scheme shows better flexibility and compatibility, and higher cost-effectiveness than the prior arts [8], [18], and [21] with external voltage source and programmable digital codes, respectively.”
InfluentialZhuang, Y., Jiang, N., Hu, H., & Yan, F. (2012) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2012.2216475 · Cited by 84 · cited 1×
“THE laser detection and ranging (LADAR) system is widely used today in industrial fields [1]–[6], including auxiliary driving, intelligent robot, and unmanned aerial vehicle.”
Palojärvi, P., Ruotsalainen, T., & Kostamovaara, J. (2005) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2005.848022 · Cited by 78 · cited 1×
“To identify the arrival timing point of the pulsed echo, the simplest scheme is the leading edge timing discrimination [14].”
An Integrated Laser Radar Receiver Channel Utilizing a Time-Domain Walk Error Compensation Scheme
Kurtti, S., & Kostamovaara, J. (2011) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2010.2047663 · Cited by 71 · cited 3×
“Although [1], [4], [19], and [21] have a wider DRand lower walk error than the proposed receiver, however, the above-mentioned work cannot linearly capture the pulsed echo intensity signal for imaging LADAR application.”
Wideband Receiver for a Three-Dimensional Ranging LADAR System
Ngo, T.-H., Kim, C.-H., Kwon, Y. J., Ko, J. S., Kim, D.-B., & Park, H.-H. (2013) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2012.2215800 · Cited by 68 · cited 4×
“To preserve the edges of pulsed echo, the optimum relationship between BW and the rise time (tr ) of the processed pulsed signal is approximately expressed as follows [8]:”
InfluentialA Wide Dynamic Range CMOS Laser Radar Receiver With a Time-Domain Walk Error Compensation Scheme
Kurtti, S., Nissinen, J., & Kostamovaara, J. (2017) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2016.2619762 · Cited by 66
Optimization of Optical Receiver Parameters for Pulsed Laser-Tracking Systems
Manojlović, L. M., & Barbaric, Z. P. (2008) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2008.2005259 · Cited by 42 · cited 1×
“The analog frontend circuits of the receiver channel mainly consist of a TIA core to amplify the pulsed current and suppress the noise from APD [11], a timing discrimination to mark the timing point and an output buffer to match load impedance.”
Receiver channel with resonance-based timing detection for a laser range finder
Pehkonen, J., Palojärvi, P., & Kostamovaara, J. (2006) · IEEE Transactions on Circuits and Systems I Fundamental Theory and Applications · doi:10.1109/tcsi.2005.858758 · Cited by 42 · cited 1×
“For wide DR receiver applications, the prior schemes, which include constant fraction timing discrimination [15], resonance-based method [16], and wavelet transform-based modulus maxima approach [17], are not appropriate to our design due to the limitation of DR.”
Cited by
A CMOS Receiver–TDC Chip Set for Accurate Pulsed TOF Laser Ranging
Kurtti, S., Jansson, J.-P., & Kostamovaara, J. (2019) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2019.2918372 · Cited by 67
“In [25]–[26], the timing accuracy is less than ±75 mm within a dynamic range of approximately <1:10 000, whereas millimeter-level accuracy was achieved over a wider dynamic range in the present study, however at a cost of somewhat higher noise.”
BackgroundA Low Walk Error Analog Front-End Circuit With Intensity Compensation for Direct ToF LiDAR
Wang, X., Ma, R., Li, D., Zheng, H., Liu, M., & Zhu, Z. (2020) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2020.3022714 · Cited by 66
“In the design, assuming the surface of the target is Lambertian, the received optical power can be described as [17]”
BackgroundSelf-citationA Linear-Mode LiDAR Sensor Using a Multi-Channel CMOS Transimpedance Amplifier Array
Hong, C., Kim, S.-H., Kim, J.-H., & Park, S. M. (2018) · IEEE Sensors Journal · doi:10.1109/jsen.2018.2852794 · Cited by 64
“As a front-end circuit, a voltage-mode inverter (INV) TIA has been conventionally utilized [11]–[13].”
MethodA High Linearity TDC With a United-Reference Fractional Counter for LiDAR
Zhang, W., Ma, R., Wang, X., Zheng, H., & Zhu, Z. (2021) · IEEE Transactions on Circuits and Systems I Regular Papers · doi:10.1109/tcsi.2020.3045731 · Cited by 49
Self-citationLi, D., Liu, M., Ma, R., & Zhu, Z. (2019) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2019.2954173 · Cited by 43
“The output optical current of the photoelectric detector with targets of the Lambertian type can simply be derived through the well-known radar equation and responsibility of APD [15] i(R) = R0 PT τtρ Ar π R2 .”
InfluentialSelf-citation
Metadata
- Authors
- Zheng, H., Ma, R., Liu, M., & Zhu, Z.
- Affiliations
- Xidian University (CN)
- Venue
- IEEE Transactions on Instrumentation and Measurement
- Published
- 2018-11
- Volume
- 67
- Issue
- 11
- Pages
- 2684-2691
- ISSN
- 0018-9456 (ISSN-L)
- 1557-9662
- OpenAlex
- W2800360818
- Cited by
- 46
- References
- 22
- Citations by year
- 2026: 7 · 2025: 3 · 2024: 4 · 2023: 4 · 2022: 4 · 2021: 5 · 2020: 8 · 2019: 6 · 2018: 5
- FWCI
- 5.51
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Instrumentation and Measurement (publishedVersion)
- Funders
- National Natural Science Foundation of China (61625403)
- Topics
- Physical Sciences › Physics and Astronomy › Instrumentation › Advanced Optical Sensing Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Analog and Mixed-Signal Circuit Design
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Radio Frequency Integrated Circuit Design
- Keywords
- LADAR, minimum detectable signal, CMOS receiver, 0.18 μm CMOS
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A Linear Dynamic Range Receiver With Timing Discrimination for Pulsed TOF Imaging LADAR Application. https://app.cochat.ai/papers/10.1109/tim.2018.2826860
- The paper
- Zheng, H., Ma, R., Liu, M., & Zhu, Z. (2018). A Linear Dynamic Range Receiver With Timing Discrimination for Pulsed TOF Imaging LADAR Application. IEEE Transactions on Instrumentation and Measurement. https://doi.org/10.1109/tim.2018.2826860
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.