The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
Design and implementation of an inverter output LC filter used for dv/dt reduction
Abstract
This paper presents the design and analysis of a LC output filter for use with IGBT-based motor drive inverters. The LC filter is used to limit the rate of rise of the inverter output voltage and reduce common mode noise to the motor. In typical applications where dv/dt is limited to 100-500 V//spl mu/s, the resonant frequency of the filter is above the switching frequency. A diode bridge must therefore be used to clamp the resonant voltage. Resistors are also used to help dissipate the energy stored in the resonant circuit. Crucial to the design of the filter is the handling of the additional losses in the filter. The paper describes the design considerations for such a filter for use in a 460 V induction motor drive. The losses in the circuit are estimated to show the limitations of the filter. Experimental results illustrate the control of dv/dt at the inverter terminals, and the reduced peak voltage at the motor end of a long cable.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
IEC and NEMA have suggested a maximum dv/dt of 500 V/μs in typical motor drive applications.
“IEC and NEMA have suggested a maximum dv/dt of 500 V/ µ s in typical motor drive applications [46].”
From A Review of Multilevel Inverter Topologies in Electric Vehicles: Current Status and Future Trends (2021) · cites this paper as [46]
High dv/dt increases eddy current and skin effect losses in the cores and the windings.
“High dv/dt also increases the eddy current and skin effect losses in the cores and the windings, respectively. [44]-[46].”
From A Review of Multilevel Inverter Topologies in Electric Vehicles: Current Status and Future Trends (2021) · cites this paper as [46]
Citations
Cites
Use of an LC filter to achieve a motor-friendly performance of the PWM voltage source inverter
Steinke, J. K. (1999) · IEEE Transactions on Energy Conversion · doi:10.1109/60.790930 · Cited by 262
Leakage current reduction for a high-frequency carrier inverter feeding an induction motor
Murai, Y., Kubota, T., & Kawase, Y. (1992) · IEEE Transactions on Industry Applications · doi:10.1109/28.148452 · Cited by 240
von Jouanne, A., Rendusara, D., Enjeti, P. N., et al. (2002) · Conference record · doi:10.1109/ias.1995.530281 · Cited by 184
A rugged soft commutated PWM inverter for AC drives
Chériti, A., Al‐Haddad, K., Dessaint, L., et al. (1992) · IEEE Transactions on Power Electronics · doi:10.1109/63.136256 · Cited by 64
A novel filter design for suppression of high voltage gradient in voltage-fed PWM inverter
Kim, S., & Sul, S. (1997) · IEEE Applied Power Electronics Conference and Exposition (APEC) · doi:10.1109/apec.1997.581442 · Cited by 62
Efficiency consideration of DC link soft-switching inverters for motor drive applications
Lai, J., Young, R. W., & McKeever, J. W. (2002) · PESC record · doi:10.1109/pesc.1994.373803 · Cited by 59
Use of a LC filter to achieve a motor friendly performance of the PWM voltage source inverter
Steinke, J. K., Stulz, C. A., & Pohjalainen, P. A. (2002) · IEEE International Electric Machines and Drives Conference (IEMDC) · doi:10.1109/iemdc.1997.604203 · Cited by 14
Flagged first, then by citations
Cited by
Sorted by citations
A Review of Multilevel Inverter Topologies in Electric Vehicles: Current Status and Future Trends
Poorfakhraei, A., Narimani, M., & Emadi, A. (2021) · IEEE Open Journal of Power Electronics · doi:10.1109/ojpel.2021.3063550 · Cited by 424
Mocevic, S., Yu, J., Fan, B., Sun, K., Xu, Y., Stewart, J., Rong, Y., Song, H., Mitrovic, V., Yan, N., et al. (2022) · iEnergy · doi:10.23919/ien.2022.0001 · Cited by 88
Metadata
- Authors
- Habetler, T. G., Naik, R., & Nondahl, T. A.
- Affiliations
- Georgia Institute of Technology (US)
- Rockwell Automation (United States) (US)
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2002-05
- Volume
- 17
- Issue
- 3
- Pages
- 327-331
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2144227881
- Cited by
- 181
- References
- 7
- Citations by year
- 2026: 3 · 2025: 2 · 2024: 6 · 2023: 13 · 2022: 11 · 2021: 9 · 2020: 10 · 2019: 13 · 2018: 7 · 2017: 5 · 2016: 8 · 2015: 10 · 2014: 9 · 2013: 10 · 2012: 5
- FWCI
- 4.54
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Power Electronics (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electromagnetic Compatibility and Noise Suppression
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Power Quality and Harmonics
- Keywords
- LC output filter, dv/dt reduction, IGBT inverter, motor drive inverter, common-mode noise, resonant frequency, filter loss, induction motor drive, inverter output voltage
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
