The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Modeling Basin‐ and Plume‐Scale Processes of CO 2 Storage for Full‐Scale Deployment
Abstract
Integrated modeling of basin‐ and plume‐scale processes induced by full‐scale deployment of CO 2 storage was applied to the Mt. Simon Aquifer in the Illinois Basin. A three‐dimensional mesh was generated with local refinement around 20 injection sites, with approximately 30 km spacing. A total annual injection rate of 100 Mt CO 2 over 50 years was used. The CO 2 ‐brine flow at the plume scale and the single‐phase flow at the basin scale were simulated. Simulation results show the overall shape of a CO 2 plume consisting of a typical gravity‐override subplume in the bottom injection zone of high injectivity and a pyramid‐shaped subplume in the overlying multilayered Mt. Simon, indicating the important role of a secondary seal with relatively low‐permeability and high‐entry capillary pressure. The secondary‐seal effect is manifested by retarded upward CO 2 migration as a result of multiple secondary seals, coupled with lateral preferential CO 2 viscous fingering through high‐permeability layers. The plume width varies from 9.0 to 13.5 km at 200 years, indicating the slow CO 2 migration and no plume interference between storage sites. On the basin scale, pressure perturbations propagate quickly away from injection centers, interfere after less than 1 year, and eventually reach basin margins. The simulated pressure buildup of 35 bar in the injection area is not expected to affect caprock geomechanical integrity. Moderate pressure buildup is observed in Mt. Simon in northern Illinois. However, its impact on groundwater resources is less than the hydraulic drawdown induced by long‐term extensive pumping from overlying freshwater aquifers.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A Closed‐form Equation for Predicting the Hydraulic Conductivity of Unsaturated Soils
van Genuchten, M. T. (1980) · Soil Science Society of America Journal · doi:10.2136/sssaj1980.03615995004400050002x · Cited by 27,578
Cited by
Earthquake triggering and large-scale geologic storage of carbon dioxide
Zoback, M. D., & Gorelick, S. M. (2012) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.1202473109 · Cited by 947
Ajayi, T., Gomes, J. S., & Bera, A. (2019) · Petroleum Science · doi:10.1007/s12182-019-0340-8 · Cited by 684
Celia, M. A., Bachu, S., Nordbotten, J. M., & Bandilla, K. W. (2015) · Water Resources Research · doi:10.1002/2015wr017609 · Cited by 465
Impact of reservoir wettability and heterogeneity on CO 2 -plume migration and trapping capacity
Al-Khdheeawi, E. A., Vialle, S., Barifcani, A., Sarmadivaleh, M., & Iglauer, S. (2017) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2017.01.012 · Cited by 255
The Nanoscale Basis of CO2 Trapping for Geologic Storage
Bourg, I. C., Beckingham, L. E., & DePaolo, D. J. (2015) · Environmental Science & Technology · doi:10.1021/acs.est.5b03003 · Cited by 163
Metadata
- Authors
- Zhou, Q., Birkholzer, J. T., Mehnert, E., Lin, Y., & Zhang, K.
- Venue
- Groundwater
- Publisher
- Wiley
- Published
- 2010-06-22
- Volume
- 48
- Issue
- 4
- Pages
- 494-514
- ISSN
- 0017-467X (ISSN-L)
- 1745-6584
- OpenAlex
- W2163131601
- Cited by
- 198
- References
- 1
- FWCI
- 8.26
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Modeling Basin‐ and Plume‐Scale Processes of CO 2 Storage for Full‐Scale Deployment. https://app.cochat.ai/papers/10.1111/j.1745-6584.2009.00657.x
- The paper
- Zhou, Q., Birkholzer, J. T., Mehnert, E., Lin, Y., & Zhang, K. (2010). Modeling Basin‐ and Plume‐Scale Processes of CO 2 Storage for Full‐Scale Deployment. Groundwater. https://doi.org/10.1111/j.1745-6584.2009.00657.x
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.