CoChat

Four direct measurements of the fine-structure constant 13 billion years ago

Open access

The DOI matches its Crossref record; 63 of the 63 references it cites were found in a registry or an index.

Abstract

Fine-structure constant measurements 13 Ga ago, plus lower redshift data, test space-time variation of a fundamental constant.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1126/sciadv.aay9672

Cites

63 of 63 references verified0 citation errors · 0 not checkable

Statistics

Figures

Fig. 1 Transitions used (black histogram) and absorption system model (thick green continuous line) from gvpfit for the zabs = 5.50726 system. The model shown is the thermal fit. In all fits, model profiles included isotopic structures assuming relative terrestrial abundances for all species. Individual absorption components are illustrated by the thinner continuous orange lines. The gray line near the bottom of each panel shows the 1σ uncertainty on each spectral pixel. The upper black histogram illustrates the normalized residuals. The horizontal red dotted line is a reference line (arbitrarily offset for clarity) representing the expected mean of zero for the normalized residuals. The horizontal red continuous lines illustrate the expected 1σ deviations. Components labeled “a” and “b” indicate reference transitions, and uppercase letters “A” and “B” indicate parameters tied to the reference transitions (www.ast.cam.ac.uk/~rfc/vpfit11.1.pdf). Where cosmic rays have fallen on the quasar spectrum, pixels have been clipped (as can be seen by the gaps in the black histograms). The Mg II 2796 line fell in a region of the spectrum with an incompletely removed telluric line so was excluded from the fitting process. Plots for the other many-multiplet absorption systems observed in this spectrum are provided in the Supplementary Materials.
Fig. 1 Transitions used (black histogram) and absorption system model (thick green continuous line) from gvpfit for the zabs = 5.50726 system. The model shown is the thermal fit. In all fits, model profiles included isotopic structures assuming relative terrestrial abundances for all species. Individual absorption components are illustrated by the thinner continuous orange lines. The gray line near the bottom of each panel shows the 1σ uncertainty on each spectral pixel. The upper black histogram illustrates the normalized residuals. The horizontal red dotted line is a reference line (arbitrarily offset for clarity) representing the expected mean of zero for the normalized residuals. The horizontal red continuous lines illustrate the expected 1σ deviations. Components labeled “a” and “b” indicate reference transitions, and uppercase letters “A” and “B” indicate parameters tied to the reference transitions (www.ast.cam.ac.uk/~rfc/vpfit11.1.pdf). Where cosmic rays have fallen on the quasar spectrum, pixels have been clipped (as can be seen by the gaps in the black histograms). The Mg II 2796 line fell in a region of the spectrum with an incompletely removed telluric line so was excluded from the fitting process. Plots for the other many-multiplet absorption systems observed in this spectrum are provided in the Supplementary Materials.CC BY-NC · PubMed Central
Fig. 2 Illustration of the gvpfit procedures used in obtaining the Δα/α measurement for the zabs = 5.50726 absorption system. The four fitting stages are indicated by the four different shaded regions (stage 1: consistent structure required; stage 2: consistent structure requirement removed; stage 3: find interlopers; stage 4: final tied parameter fit; see text for details). Each point illustrates the lowest χ2 point at each generation. Model complexity increases with generation number. The error bars are artificially small in stage 3 because some parameters were fixed during the initial interloper fit. The red point in each stage indicates the model with the smallest AICc for that stage. The continuous black line illustrates the AICc. The final model for this system is indicated by the red point at generation 32 in stage 4. The “plateauing” of points within each stage occurs simply because this absorption system is relatively simple, with only two components, such that when gvpfit attempts to insert additional components at various trial positions within the absorbing region, the AICc value always increases, and that model is thus rejected.
Fig. 2 Illustration of the gvpfit procedures used in obtaining the Δα/α measurement for the zabs = 5.50726 absorption system. The four fitting stages are indicated by the four different shaded regions (stage 1: consistent structure required; stage 2: consistent structure requirement removed; stage 3: find interlopers; stage 4: final tied parameter fit; see text for details). Each point illustrates the lowest χ2 point at each generation. Model complexity increases with generation number. The error bars are artificially small in stage 3 because some parameters were fixed during the initial interloper fit. The red point in each stage indicates the model with the smallest AICc for that stage. The continuous black line illustrates the AICc. The final model for this system is indicated by the red point at generation 32 in stage 4. The “plateauing” of points within each stage occurs simply because this absorption system is relatively simple, with only two components, such that when gvpfit attempts to insert additional components at various trial positions within the absorbing region, the AICc value always increases, and that model is thus rejected.CC BY-NC · PubMed Central
Fig. 3 Direct measurements of Δα/α, taken from quasar absorption measurements (30, 43, 58). Where measurements reported in (58) were reanalyses of the same systems from (30), the former was used. Error bars include systematic contributions (although we note the heterogeneous nature of this combined dataset and point out that systematic errors were not all estimated in a consistent manner so error bars are not necessarily directly comparable in all cases). The point in black at z = 5.87 illustrates the weighted mean of the four measurements described in this paper. Its horizontal bar indicates the redshift range spanned by those four measurements. The red shaded area shows the redshift range from the quasar emission redshift (zem = 7.085) down to the lowest possible redshift for a Δα/α measurement (zabs = 5.443), assuming that we retain the lowest rest-wavelength anchor line, Si II 1526 Å̊. Ga, billion years.
Fig. 3 Direct measurements of Δα/α, taken from quasar absorption measurements (30, 43, 58). Where measurements reported in (58) were reanalyses of the same systems from (30), the former was used. Error bars include systematic contributions (although we note the heterogeneous nature of this combined dataset and point out that systematic errors were not all estimated in a consistent manner so error bars are not necessarily directly comparable in all cases). The point in black at z = 5.87 illustrates the weighted mean of the four measurements described in this paper. Its horizontal bar indicates the redshift range spanned by those four measurements. The red shaded area shows the redshift range from the quasar emission redshift (zem = 7.085) down to the lowest possible redshift for a Δα/α measurement (zabs = 5.443), assuming that we retain the lowest rest-wavelength anchor line, Si II 1526 Å̊. Ga, billion years.CC BY-NC · PubMed Central
Fig. 4 Illustration of the α dependence of the transitions observed in the four absorption systems measured in this paper. The percentage change in α covers an unrealistically large range to show the shift trends. The lower x axis is rest wavelength, and the upper is the observed-frame wavelength at redshift z = 5.87 (the mean redshift for all three absorption systems in this analysis). Some transitions (Si II 1526 Å, Al II 1670 Å, and Mg II 2796/2803 Å) are insensitive to changes in α (“anchors”), while the Fe II transitions all show a substantially greater sensitivity, with Fe II 1608 Å shifting in the opposite direction to Fe II 2344, 2383, 2586, and 2600 Å. The sensitivity of an observed frequency ωz at redshift z to a change in α is given by ωz=ω0+q(αz²/α0²−1)≈2δα/α, where α0 and ω0 are the terrestrial values and q is the sensitivity coefficient for that transition.
Fig. 4 Illustration of the α dependence of the transitions observed in the four absorption systems measured in this paper. The percentage change in α covers an unrealistically large range to show the shift trends. The lower x axis is rest wavelength, and the upper is the observed-frame wavelength at redshift z = 5.87 (the mean redshift for all three absorption systems in this analysis). Some transitions (Si II 1526 Å, Al II 1670 Å, and Mg II 2796/2803 Å) are insensitive to changes in α (“anchors”), while the Fe II transitions all show a substantially greater sensitivity, with Fe II 1608 Å shifting in the opposite direction to Fe II 2344, 2383, 2586, and 2600 Å. The sensitivity of an observed frequency ωz at redshift z to a change in α is given by ωz=ω0+q(αz²/α0²−1)≈2δα/α, where α0 and ω0 are the terrestrial values and q is the sensitivity coefficient for that transition.CC BY-NC · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Research works printed but not linked: 2

  1. F. J. Dyson The fundamental constants and their time variation in Aspects of Quantum Theory A. Salam E. P. Wigner Eds. (Cambridge Univ. Press 1972) chap. 3 pp. 213–236.
  2. V. V. Flambaum E. V. Shuryak Nuclei and Mesoscopic Physic-WNMP 2007 P. Danielewicz P. Piecuch V. Zelevinsky Eds. (American Institute of Physics 2008) vol. 995 pp. 1–11.

Cited by

See all 16

Metadata

Authors
Wilczynska, M. R., Webb, J. K., Bainbridge, M., Barrow, J. D., Bosman, S. E. I., Carswell, R. F., Dąbrowski, M. P., Dumont, V., Lee, C.-C., Leite, A. C., Leszczyńska, K., Liske, J., Marosek, K., Martins, C. J. A. P., Milaković, D., Molaro, P., & Pasquini, L.
Affiliations
  • UNSW Sydney (AU)
  • University of Leicester (GB)
  • University of Cambridge (GB)
  • University College London (GB)
  • Institute of Physics, University of Szczecin, Wielkopolska 15, 70-451 Szczecin, Poland.
  • Lawrence Berkeley National Laboratory (US)
  • Universidade do Porto (PT)
  • University of Szczecin (PL)
  • Universität Hamburg (DE)
  • Maritime University of Szczecin (PL)
  • European Southern Observatory (DE)
  • Trieste Astronomical Observatory (IT)
Corresponding author
Webb, John K.
Venue
Science Advances
Published
2020-04-24
Volume
6
Issue
17
ISSN
2375-2548 (ISSN-L)
OpenAlex
W3011284198
Cited by
13
References
61
Citations by year
2024: 4 · 2023: 2 · 2021: 2 · 2020: 5
FWCI
1.00
Type
journal article
Language
en
Open access
Licence
cc-by-nc
Locations
  • Science Advances (publishedVersion, cc-by-nc)
  • PubMed Central (publishedVersion, cc-by-nc)
  • PubMed (publishedVersion)
  • arXiv (Cornell University) (submittedVersion)
  • OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) (submittedVersion)
  • Apollo (University of Cambridge) (submittedVersion, cc-by-nc)
  • arXiv (Cornell University)
  • Apollo
Funders
  • John Templeton Foundation
  • University of Cambridge
  • European Commission (HORIZON2020)
  • European Southern Observatory
  • Science and Technology Facilities Council
  • Fundação para a Ciência e a Tecnologia (01-0145, COMPETE, POCI-01-0145, POCI-01-0145-FEDER-, COMPETE_2020, POCI-01-, POCI-01-0145-FEDER- 028987, PD/00040/2012, SFRH/BD/113746/2015)
  • European Regional Development Fund (COMPETE, POCI-01, 01-0145, COMPETE2020, POCI-01-0145, POCI-01-0145-FEDER- 028987, POCI-01-0145- FEDER)
Topics
  • Physical Sciences › Physics and Astronomy › Astronomy and Astrophysics › Cosmology and Gravitation Theories
  • Physical Sciences › Physics and Astronomy › Statistical and Nonlinear Physics › Advanced Mathematical Theories and Applications
  • Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Scientific Research and Discoveries
Keywords
fine-structure constant, variation of fundamental constants, early universe, cosmological constraints, direct measurement

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.