The DOI matches its Crossref record; 10 of the 10 references it cites were found in a registry or an index.
An Atomistic Description of Dealloying
Abstract
We describe the microscopic details of porosity formation during dealloying as illuminated by a kinetic Monte Carlo model incorporating site coordination-dependent surface diffusion of all alloy components, and site coordination-dependent dissolution of the less-noble atoms. Our simulation model reproduces the entire range of phenomena associated with selective dissolution. These phenomena include composition and geometric restrictions on dealloying (parting limits), a composition-dependent critical potential, a passivation regime, a regime of steady-state dissolution flux, and porosity formation. We find that an intrinsic critical potential exists as a well-defined threshold potential separating surface passivation and porosity formation behaviors, but this intrinsic critical potential typically sits at values well below the experimental measurements of the empirical critical potential. Finally, by detailed examination of the temperature dependence of the dissolution flux, and also of the types of surface sites contributing to the dissolution flux, we predict that the binding energy of a terrace atom may be straightforwardly extracted from analysis of experimental polarization curves. © 2004 The Electrochemical Society. All rights reserved.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Evolution of nanoporosity in dealloying
Erlebacher, J., Aziz, M. J., Karma, A., Dimitrov, N., & Sieradzki, K. (2001) · Nature · doi:10.1038/35068529 · Cited by 2,753
Self-citationMesoporous Platinum Films from Lyotropic Liquid Crystalline Phases
Attard, G. S., Bartlett, P. N., Coleman, N. R. B., Elliott, J. M., Owen, J. R., & Wang, J. H. (1997) · Science · doi:10.1126/science.278.5339.838 · Cited by 965
Nanoporous Metals with Controlled Multimodal Pore Size Distribution
Ding, Y., & Erlebacher, J. (2003) · Journal of the American Chemical Society · doi:10.1021/ja035318g · Cited by 455
Self-citationEstimating surface diffusion coefficients
Seebauer, E. G. (1995) · Progress in Surface Science · doi:10.1016/0079-6816(95)00039-2 · Cited by 372
Corrosion micromorphology of noble metal alloys and depletion gilding
Forty, A. J. (1979) · Nature · doi:10.1038/282597a0 · Cited by 365
The Dealloying Critical Potential
Sieradzki, K., Dimitrov, N., Movrin, D., McCall, C., Vasiljevic, N., & Erlebacher, J. (2002) · Journal of The Electrochemical Society · doi:10.1149/1.1492288 · Cited by 260
Self-citationKang, H. C., & Weinberg, W. H. (1989) · The Journal of Chemical Physics · doi:10.1063/1.455932 · Cited by 245
Curvature Effects in Alloy Dissolution
Sieradzki, K. (1993) · Journal of The Electrochemical Society · doi:10.1149/1.2220924 · Cited by 174
Fabrication of nanoporous gold nanowires
Ji, C., & Searson, P. C. (2002) · Applied Physics Letters · doi:10.1063/1.1526920 · Cited by 128
Mechanism of surface diffusion of gold adatoms in contact with an electrolytic solution
Doña-Rodríguez, J. M., & González-Velasco, J. R. (1993) · The Journal of Physical Chemistry · doi:10.1021/j100120a026 · Cited by 124
Cited by
Xia, X., Wang, Y., Ruditskiy, A., & Xia, Y. (2013) · Advanced Materials · doi:10.1002/adma.201302820 · Cited by 1,019
Nanoporous Gold Leaf: “Ancient Technology”/Advanced Material
Ding, Y., Kim, Y. ‐., & Erlebacher, J. (2004) · Advanced Materials · doi:10.1002/adma.200400792 · Cited by 781
Self-citationGeneration of 3D representative volume elements for heterogeneous materials: A review
Bargmann, S., Klusemann, B., Markmann, J., Schnabel, J. E., Schneider, K., Soyarslan, C., & Wilmers, J. (2018) · Progress in Materials Science · doi:10.1016/j.pmatsci.2018.02.003 · Cited by 546
Dealloying and Dealloyed Materials
McCue, I., Benn, E., Gaskey, B., & Erlebacher, J. (2016) · Annual Review of Materials Research · doi:10.1146/annurev-matsci-070115-031739 · Cited by 502
Self-citationGeneralized Fabrication of Nanoporous Metals (Au, Pd, Pt, Ag, and Cu) through Chemical Dealloying
Zhang, Z., Wang, Y., Qi, Z., Zhang, W., Qin, J., & Frenzel, J. (2009) · The Journal of Physical Chemistry C · doi:10.1021/jp811445a · Cited by 455
Nong, H. N., Oh, H., Reier, T., Willinger, E., Willinger, M., Petkov, V., Teschner, D., & Strasser, P. (2015) · Angewandte Chemie International Edition · doi:10.1002/anie.201411072 · Cited by 453
Han, B., Carlton, C. E., Kongkanand, A., Kukreja, R. S., Theobald, B. R., Gan, L., O'Malley, R., Strasser, P., Wagner, F. T., & Shao-Horn, Y. (2015) · Energy & Environmental Science · doi:10.1039/c4ee02144d · Cited by 419
Tappan, B. C., Steiner, S. A., & Luther, E. P. (2010) · Angewandte Chemie International Edition · doi:10.1002/anie.200902994 · Cited by 407
Nanoporous Pt−Co Alloy Nanowires: Fabrication, Characterization, and Electrocatalytic Properties
Liu, L., Pippel, E., Scholz, R., & Gösele, U. (2009) · Nano Letters · doi:10.1021/nl902619q · Cited by 398
Ultrafine nanoporous gold by low-temperature dealloying and kinetics of nanopore formation
Qian, L. H., & Chen, M. W. (2007) · Applied Physics Letters · doi:10.1063/1.2773757 · Cited by 387
Mani, P., Srivastava, R., & Strasser, P. (2011) · Journal of Power Sources · doi:10.1016/j.jpowsour.2010.07.047 · Cited by 379
Kim, Y.-T., Lopes, P. P., Park, S.-A., Lee, A.-Y., Lim, J., Lee, H., Back, S., Jung, Y., Danilovic, N., Stamenkovic, V., et al. (2017) · Nature Communications · doi:10.1038/s41467-017-01734-7 · Cited by 367
Self-citationGan, L., Heggen, M., Rudi, S., & Strasser, P. (2012) · Nano Letters · doi:10.1021/nl302995z · Cited by 366
Chen, S., Gasteiger, H. A., Hayakawa, K., Tada, T., & Shao-Horn, Y. (2010) · Journal of The Electrochemical Society · doi:10.1149/1.3258275 · Cited by 360
Nanoporous gold: a new material for catalytic and sensor applications
Wittstock, A., Biener, J., & Bäumer, M. (2010) · Physical Chemistry Chemical Physics · doi:10.1039/c0cp00757a · Cited by 337
Stabilized Nanoporous Metals by Dealloying Ternary Alloy Precursors
Snyder, J., Asanithi, P., Dalton, A. B., & Erlebacher, J. (2008) · Advanced Materials · doi:10.1002/adma.200702760 · Cited by 325
Self-citationYao, R., Zhou, Y., Shi, H., Wan, W., Zhang, Q., Gu, L., Zhu, Y., Wen, Z., Lang, X., & Jiang, Q. (2021) · Advanced Functional Materials · doi:10.1002/adfm.202009613 · Cited by 321
Long‐Term Stability Challenges and Opportunities in Acidic Oxygen Evolution Electrocatalysis
Wang, Q., Cheng, Y., Tao, H. B., Liu, Y., Ma, X., Li, D., Yang, H. B., & Liu, B. (2023) · Angewandte Chemie International Edition · doi:10.1002/anie.202216645 · Cited by 316
A Perspective on Low-Temperature Water Electrolysis – Challenges in Alkaline and Acidic Technology
Schalenbach, M., Zeradjanin, A. R., Kasian, O., Cherevko, S., & Mayrhofer, K. J. J. (2018) · International Journal of Electrochemical Science · doi:10.20964/2018.02.26 · Cited by 305
Gan, L., Heggen, M., O’Malley, R., Theobald, B., & Strasser, P. (2013) · Nano Letters · doi:10.1021/nl304488q · Cited by 295
Snyder, J., McCue, I., Livi, K., & Erlebacher, J. (2012) · Journal of the American Chemical Society · doi:10.1021/ja3019498 · Cited by 285
Self-citationTan, Y. H., Davis, J. A., Fujikawa, K., Ganesh, N. V., Demchenko, A. V., & Stine, K. J. (2012) · Journal of Materials Chemistry · doi:10.1039/c2jm16633j · Cited by 285
Chen, S., Sheng, W., Yabuuchi, N., Ferreira, P. J., Allard, L. F., & Shao-Horn, Y. (2009) · The Journal of Physical Chemistry C · doi:10.1021/jp807143e · Cited by 273
Initial corrosion observed on the atomic scale
Renner, F. U., Stierle, A., Dosch, H., Kolb, D. M., Lee, T.-L., & Zegenhagen, J. (2006) · Nature · doi:10.1038/nature04465 · Cited by 269
Electrochemical and Structural Study of a Chemically Dealloyed PtCu Oxygen Reduction Catalyst
Dutta, I., Carpenter, M. K., Balogh, M. P., Ziegelbauer, J. M., Moylan, T. E., Atwan, M. H., & Irish, N. P. (2010) · The Journal of Physical Chemistry C · doi:10.1021/jp106042z · Cited by 121
Metadata
- Authors
- Erlebacher, J.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2004
- Volume
- 151
- Issue
- 10
- Pages
- C614
- ISSN
- 0013-4651 (ISSN-L)
- OpenAlex
- W1492281746
- Cited by
- 637
- References
- 10
- FWCI
- 7.50
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.