The DOI matches its Crossref record.
Three‐Dimensional Thermal Modeling of Lithium‐Polymer Batteries under Galvanostatic Discharge and Dynamic Power Profile
Open accessAbstract
A three‐dimensional model is developed to simulate and compare heat generation and transport within a lithium polymer electrolyte battery under galvanostatic discharges and a dynamic power profile [the Simplified Federal Urban Driving Schedule (SFUDS)]. Emphasis is placed on the maintenance of the operational temperature and temperature uniformity within a battery by designing a suitable thermal management system. The results indicate that the anisotropic thermal conductivity within the battery is an important factor influencing thermal performance and should be taken into consideration in battery design. On the one hand, because of the low effective thermal conductivity across a laminated cell stack, steep temperature distributions may be caused if cooling channels or electric heaters are placed at the two ends of a cell stack. On the other hand, the relatively large average thermal conductivity along the width and height directions allows more efficient heat removal or addition, and thus facilitates the maintenance of uniform operating temperature. Under the SFUDS power profile, the time‐averaged heat generation rate is low, and therefore a high‐performance insulation material is required to maintain the operating temperature. The thermal model has been applied to study the effectiveness of different arrangements of cooling channels and electric heaters and to select suitable heating intensities and insulating materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Nonaqueous Liquid Electrolytes for Lithium-Based Rechargeable Batteries
Xu, K. (2004) · Chemical Reviews · doi:10.1021/cr030203g · Cited by 7,437
Thermal runaway caused fire and explosion of lithium ion battery
Wang, Q., Ping, P., Zhao, X., Chu, G., Sun, J., & Chen, C. (2012) · Journal of Power Sources · doi:10.1016/j.jpowsour.2012.02.038 · Cited by 3,103
A critical review of thermal issues in lithium-ion batteries
Bandhauer, T. M., Garimella, S., & Fuller, T. F. (2011) · Journal of The Electrochemical Society · doi:10.1149/1.3515880 · Cited by 2,192
Wang, Q., Jiang, B., Li, B., & Yan, Y. (2016) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2016.05.033 · Cited by 1,083
Safety focused modeling of lithium-ion batteries: A review
Abada, S., Marlair, G., Lecocq, A., Petit, M., Sauvant-Moynot, V., & Huet, F. (2016) · Journal of Power Sources · doi:10.1016/j.jpowsour.2015.11.100 · Cited by 819
Thermal-Electrochemical Modeling of Battery Systems
Gu, W. B., & Wang, C. Y. (2000) · Journal of The Electrochemical Society · doi:10.1149/1.1393625 · Cited by 746
Battery Energy Storage System (BESS) and Battery Management System (BMS) for Grid-Scale Applications
Lawder, M. T., Suthar, B., Northrop, P. W. C., De, S., Hoff, C. M., Leitermann, O., Crow, M. L., Santhanagopalan, S., & Subramanian, V. R. (2014) · Proceedings of the IEEE · doi:10.1109/jproc.2014.2317451 · Cited by 713
Thermal analysis of lithium-ion batteries
Chen, S. C., Wan, C. C., & Wang, Y. Y. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2004.05.064 · Cited by 708
Thermal Analysis of Lithium‐Ion Batteries
Chen, Y., & Evans, J. W. (1996) · Journal of The Electrochemical Society · doi:10.1149/1.1837095 · Cited by 545
Self-citationThermal modeling and design considerations of lithium-ion batteries
Al Hallaj, S., Maleki, H., Hong, J. S., & Selman, J. R. (1999) · Journal of Power Sources · doi:10.1016/s0378-7753(99)00178-0 · Cited by 454
Panchal, S., Khasow, R., Dincer, I., Agelin-Chaab, M., Fraser, R., & Fowler, M. (2017) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2017.05.010 · Cited by 397
Intercalation-Induced Stress and Heat Generation within Single Lithium-Ion Battery Cathode Particles
Zhang, X., Sastry, A. M., & Shyy, W. (2008) · Journal of The Electrochemical Society · doi:10.1149/1.2926617 · Cited by 334
On state-of-charge determination for lithium-ion batteries
Li, Z., Huang, J., Liaw, B. Y., & Zhang, J. (2017) · Journal of Power Sources · doi:10.1016/j.jpowsour.2017.03.001 · Cited by 317
Modeling for the scale-up of a lithium-ion polymer battery
Kim, U. S., Shin, C. B., & Kim, C.-S. (2009) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.10.019 · Cited by 308
Effect of electrode configuration on the thermal behavior of a lithium-polymer battery
Kim, U. S., Shin, C. B., & Kim, C.-S. (2008) · Journal of Power Sources · doi:10.1016/j.jpowsour.2007.09.054 · Cited by 292
Panchal, S., Dincer, I., Agelin-Chaab, M., Fraser, R., & Fowler, M. (2016) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2015.11.019 · Cited by 271
Panchal, S., Dincer, I., Agelin-Chaab, M., Fraser, R., & Fowler, M. (2016) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2016.05.126 · Cited by 261
Metadata
- Authors
- Chen, Y., & Evans, J. W.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 1994-11-01
- Volume
- 141
- Issue
- 11
- Pages
- 2947-2955
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W2108482099
- Cited by
- 177
- References
- 0
- FWCI
- 3.24
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.