The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Cycling Behavior of NCM523/Graphite Lithium-Ion Cells in the 3–4.4 V Range: Diagnostic Studies of Full Cells and Harvested Electrodes
Open accessAbstract
Energy density of full cells containing layered-oxide positive electrodes can be increased by raising the upper cutoff voltage above the present 4.2 V limit. In this article we examine aging behavior of cells, containing LiNi 0.5 Co 0.2 Mn 0.3 O 2 (NCM523)-based positive and graphite-based negative electrodes, which underwent up to ∼400 cycles in the 3–4.4 V range. Electrochemistry results from electrodes harvested from the cycled cells were obtained to identify causes of cell performance loss; these results were complemented with data from X-ray photoelectron spectroscopy (XPS) and secondary ion mass spectroscopy (SIMS) measurements. Our experiments indicate that the full cell capacity fade increases linearly with cycle number and results from irreversible lithium loss in the negative electrode solid electrolyte interphase (SEI) layer. The accompanying electrode potential shift reduces utilization of active material in both electrodes and causes the positive electrode to cycle at higher states-of-charge. Full cell impedance rise on aging arises primarily at the positive electrode and results mainly from changes at the electrode-electrolyte interface; the small growth in negative electrode impedance reflects changes in the SEI layer. Our results indicate that cell performance loss could be mitigated by modifying the electrode-electrolyte interfaces through use of appropriate electrode coatings and/or electrolyte additives.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thackeray, M. M., Wolverton, C., & Isaacs, E. D. (2012) · Energy & Environmental Science · doi:10.1039/c2ee21892e · Cited by 2,515
Pinson, M. B., & Bazant, M. Z. (2013) · Journal of The Electrochemical Society · doi:10.1149/2.044302jes · Cited by 946
Cited by
Degradation Mechanisms and Mitigation Strategies of Nickel-Rich NMC-Based Lithium-Ion Batteries
Li, T., Yuan, X.-Z., Zhang, L., Song, D., Shi, K., & Bock, C. (2020) · Electrochemical Energy Reviews · doi:10.1007/s41918-019-00053-3 · Cited by 753
Bulk fatigue induced by surface reconstruction in layered Ni-rich cathodes for Li-ion batteries
Xu, C., Märker, K., Lee, J., Mahadevegowda, A., Reeves, P. J., Day, S. J., Groh, M. F., Emge, S. P., Ducati, C., Layla Mehdi, B., et al. (2021) · Nature Materials · doi:10.1038/s41563-020-0767-8 · Cited by 707
Gilbert, J. A., Shkrob, I. A., & Abraham, D. P. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.1111702jes · Cited by 493
Self-citationWalther, F., Koerver, R., Fuchs, T., Ohno, S., Sann, J., Rohnke, M., Zeier, W. G., & Janek, J. (2019) · Chemistry of Materials · doi:10.1021/acs.chemmater.9b00770 · Cited by 433
Toward Low-Cost, High-Energy Density, and High-Power Density Lithium-Ion Batteries
Li, J., Du, Z., Ruther, R. E., AN, S. J., David, L. A., Hays, K., Wood, M., Phillip, N. D., Sheng, Y., Mao, C., et al. (2017) · JOM · doi:10.1007/s11837-017-2404-9 · Cited by 350
Metadata
- Authors
- Gilbert, J. A., Bareño, J., Spila, T., Trask, S. E., Miller, D. J., Polzin, B. J., Jansen, A. N., & Abraham, D. P.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2016-09-22
- Volume
- 164
- Issue
- 1
- Pages
- A6054-A6065
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W2522034864
- Cited by
- 175
- References
- 2
- FWCI
- 10.82
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.