Numerical Analysis of a Dental Zirconium Restoration and the Stresses That Occur in Dental Tissues
Open accessAbstract
When it is about restorative dental materials, aesthetics is traditionally preferred. This has led to the selection of materials very visually similar to the enamel, but unfortunately, their mechanical properties are not similar. This often translates into disadvantages than advantages. In the present work, a comparison is made of the stresses that occur during dental occlusion (dental bit) in a healthy dental organ and those that are generated in a dental organ with a dental zirconium restoration. Numerical simulation was carried out by means of the Finite Element Method, in computational biomodels, from Cone-Beam Tomography, to obtain the stresses generated during dental occlusion. It was found that the normal and von Mises stresses generated are substantially greater in the molar with restoration compared to those produced in the healthy molar. In addition, the normal function of the enamel and dentin to disperse these stresses to prevent them from reaching the pulp is altered. Therefore, it is necessary to analyze the indiscriminate use of this restoration material and consider other aspects, in addition to aesthetics and biocompatibility for the choice of restorative materials such as biomechanical compatibility.
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The attributes of linear, homogeneous, continuous, isotropic materials and a semicontrolled mesh with high-order tetrahedral elements are commonly used in biomodelling and numerical analysis on biological tissues and organs.
“All these attributes are commonly used when performing biomodelling and numerical analysis on biological tissues and organs [22, 37, 43–50].”
From Numerical Analysis of the ACL, with Sprains of Different Degrees after Trauma (2021) · cites this paper as [44]
The Materials and Methods section describes modelling dental tissues and zirconium as linear, elastic, continuous, isotropic, and homogeneous. It mentions mesh refinement but does not specify a semicontrolled mesh or high-order tetrahedral elements, nor establish that these choices are commonly used across biological tissues and organs. Page numbers were not available in our copy. (LLM, conf=0.82)
Experimental — accuracy not yet measured
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Cites
Raigrodski, A. J., Chiche, G. J., Potiket, N., et al. (2006) · Journal of Prosthetic Dentistry · doi:10.1016/j.prosdent.2006.08.010 · Cited by 502 · see citing works
Prospective clinical study of zirconia posterior fixed partial dentures: 3-year follow-up.
Sailer, I., Fehér, A., Filser, F., Lüthy, H., Gauckler, L. J., SCHARER, P., & Hämmerle, C. H. F. (2006) · PubMed · Cited by 317 · see citing works
Comparison of mechanical property and role between enamel and dentin in the human teeth
Chun, K., Choi, H., & Lee, J. (2014) · Journal of Dental Biomechanics · doi:10.1177/1758736014520809 · Cited by 255 · see citing works
On the brittleness of enamel and selected dental materials
Park, S., Quinn, J. B., Romberg, E., et al. (2008) · Dental Materials · doi:10.1016/j.dental.2008.03.007 · Cited by 150 · see citing works
Zirconia posterior fixed partial dentures: a prospective clinical 3-year follow-up.
Schmitt, J., Holst, S., Wichmann, M. G., et al. (2010) · PubMed · Cited by 121 · see citing works
HIP zirconia fixed partial dentures--clinical results after 3 years of clinical service.
Edelhoff, D., Beuer, F., Florian, W., et al. (2008) · PubMed · Cited by 120 · see citing works
Peláez, J., Cogolludo, P. G., Serrano, B., Serrano, J. F. L., & Suárez, M. J. (2012) · PubMed · Cited by 118 · see citing works
Øilo, M., Hardang, A. D., Ulsund, A. H., et al. (2014) · European Journal Of Oral Sciences · doi:10.1111/eos.12127 · Cited by 82 · see citing works
Optical behavior of dental zirconia and dentin analyzed by Kubelka–Munk theory
Pecho, Ó. E., Ghinea, R. I., Ionescu, A. M., et al. (2014) · Dental Materials · doi:10.1016/j.dental.2014.11.012 · Cited by 81 · see citing works
Beger, B., Goetz, H., Morlock, M. M., et al. (2018) · International Journal of Implant Dentistry · doi:10.1186/s40729-018-0124-8 · Cited by 30 · see citing works
Hernández-Vázquez, R. A., Romero-Ángeles, B., Urriolagoitia-Sosa, G., Vázquez-Feijoo, J. A., Vázquez-López, Á. J., & Urriolagoitia-Calderón, G. (2018) · Applied Bionics and Biomechanics · doi:10.1155/2018/4196343 · Cited by 28 · see citing works
Self-citationThe effect of zirconia framework design on the failure of all-ceramic crown under static loading
Urapepon, S., & Taenguthai, P. (2015) · The Journal of Advanced Prosthodontics · doi:10.4047/jap.2015.7.2.146 · Cited by 25 · see citing works
Ceramic Laminate Veneers: Materials Advances and Selection
Sadaqah, N. R. (2014) · Open Journal of Stomatology · doi:10.4236/ojst.2014.45038 · Cited by 21 · see citing works
Mechanobiological Analysis of Molar Teeth with Carious Lesions through the Finite Element Method
Hernández-Vázquez, R. A., Romero-Ángeles, B., Urriolagoitia-Sosa, G., Vázquez-Feijoo, J. A., Marquet-Rivera, R. A., & Urriolagoitia-Calderón, G. (2018) · Applied Bionics and Biomechanics · doi:10.1155/2018/1815830 · Cited by 12 · see citing works
Self-citationAlfaro, B. M., Ramírez, S. A., & Quea-Cahuana, E. (2015) · International journal of odontostomatology · doi:10.4067/s0718-381x2015000100013 · Cited by 6 · see citing works
Ramos, A., Muñiz‐Calvente, M., Pelayo, F., et al. (2015) · Boletín de la Sociedad Española de Cerámica y Vidrio · doi:10.1016/j.bsecv.2015.06.002 · Cited by 6 · see citing works
Loyola-González, P. O., Torassa, D., & Dominguez, A. (2016) · Revista clínica de periodoncia implantología y rehabilitación oral · doi:10.1016/j.piro.2015.10.003 · Cited by 6 · see citing works
Computational biomodelling and numerical analysis as means of diagnostic and odontological prognosis
Urriolagoitia-Sosa, G. (2018) · MOJ Applied Bionics and Biomechanics · doi:10.15406/mojabb.2018.02.00078 · Cited by 6 · see citing works
Self-citationFRAGILIDAD Y COMPORTAMIENTO MECÁNICO DEL ESMALTE DENTAL
Velásquez, C., Ossa, H. A., & Arola, D. D. (2012) · doi:10.24050/19099762.n12.2012.106 · Cited by 5 · see citing works
The importance of bio-fidelity in the biomodelling for a biomechanical analysis
Guillermo, U. S. (2018) · MOJ Applied Bionics and Biomechanics · doi:10.15406/mojabb.2018.02.00062 · Cited by 3 · see citing works
de Antioquia, U., Nini Tatiana Suárez, B., Restrepo, J. C. E., et al. (2015) · Revista Facultad de Odontología Universidad de Antioquia · doi:10.17533/udea.rfo.v27n1a2 · Cited by 2 · see citing works
Castro-Aguilar, E. G., Matta-Morales, C. O., & Orellana-Valdivieso, O. (2014) · Revista Estomatológica Herediana · doi:10.20453/reh.v24i4.2171 · Cited by 1 · see citing works
Flagged first, then by citations
Research works printed but not linked: 3
- [2]Hernández-Vázquez R. A. Análisis mecanobiológico de la distribución de esfuerzos debido a cargas masticatorias, sobre los órganos dentales 2018 México Doctoral Thesis, Instituto Politécnico Nacional
- [7]Ali S. Karthigeyan S. Deivanai M. Mani R. Zirconia: properties and application: a review Pakistan Oral & Dental Journal 2014 34 1 178 183
- [19]Nothdurft F. P. Rountree P. R. Pospiech P. R. Clinical long-term behavior of zirconia-based bridges (LAVA): five years results Journal of Dental Restoration 2006 85 Spec Iss C, article 0312
Cited by
Sorted by citations
Numerical Analysis of the ACL, with Sprains of Different Degrees after Trauma
Marquet-Rivera, R. A., Urriolagoitia-Sosa, G., Romero-Ángeles, B., Hernández-Vázquez, R. A., Mastache-Miranda, O. A., Cruz-López, S., Torres-Yáñez, A., & Urriolagoitia-Calderón, G. (2021) · Computational and Mathematical Methods in Medicine · doi:10.1155/2021/2109348 · Cited by 5 · see citing works
Self-citationHernández-Vázquez, R. A., Marquet-Rivera, R. A., Mastache-Miranda, O. A., Vázquez-López, A. J., Cruz-López, S., & Vázquez-Feijoo, J. A. (2021) · Applied Bionics and Biomechanics · doi:10.1155/2021/6658039 · Cited by 4 · see citing works
Self-citation
- Authors
- Hernández-Vázquez, R. A., Urriolagoitia-Sosa, G., Marquet-Rivera, R. A., Romero-Ángeles, B., Mastache-Miranda, O.-A., & Urriolagoitia-Calderón, G. G.
- Affiliations
- Instituto Politécnico Nacional (MX)
- Corresponding author
- Hernández-Vázquez, Rosa Alicia
- ORCID
- Venue
- Applied Bionics and Biomechanics
- Publisher
- Wiley
- Published
- 2019-09-05
- Volume
- 2019
- Pages
- 1-13
- ISSN
- 1176-2322 (ISSN-L)
- 1754-2103
- PMC
- PMC6748186
- OpenAlex
- W2971921730
- Cited by
- 5
- References
- 22
- Citations by year
- 2023: 2 · 2022: 1 · 2021: 2
- FWCI
- 0.87
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Locations
- Applied Bionics and Biomechanics (publishedVersion, cc-by)
- PubMed Central (publishedVersion, cc-by)
- PubMed (publishedVersion)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion)
- Funders
- Instituto Politécnico Nacional
- Consejo Nacional de Ciencia y Tecnología
- Topics
- Health Sciences › Dentistry › Orthodontics › Dental materials and restorations
- Health Sciences › Dentistry › Oral Surgery › Endodontics and Root Canal Treatments
- Health Sciences › Dentistry › Periodontics › Scientific and Engineering Research Topics
- Keywords
- zirconia dental restorations, dental occlusion, stress distribution, von Mises stress, molars, biomechanical compatibility, restorative materials, cone-beam computed tomography, finite element analysis, pulp protection, dentin, enamel
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
