The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.
Piezoelectric wind energy harvester for low-power sensors
Abstract
There has been increasing interest in wireless sensor networks for a variety of outdoor applications including structural health monitoring and environmental monitoring. Replacement of batteries that power the nodes in these networks is maintenance intensive. A wind energy–harvesting device is proposed as an alternate power source for these wireless sensor nodes. The device is based on the galloping of a bar with triangular cross section attached to a cantilever beam. Piezoelectric sheets bonded to the beam convert the mechanical energy into electrical energy. A prototype device of size approximately 160 × 250 mm was fabricated and tested over a range of operating conditions in a wind tunnel, and the power dissipated across a load resistance was measured. A maximum power output of 53 mW was measured at a wind velocity of 11.6 mph. An analytical model incorporating the coupled electromechanical behavior of the piezoelectric sheets and quasi-steady aerodynamics was developed. The model showed good correlation with measurements, and it was concluded that a refined aerodynamic model may need to include apparent mass effects for more accurate predictions. The galloping piezoelectric energy-harvesting device has been shown to be a viable option for powering wireless sensor nodes in outdoor applications.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wireless sensor network survey
Yick, J., Mukherjee, B., & Ghosal, D. (2008) · Computer Networks · doi:10.1016/j.comnet.2008.04.002 · Cited by 6,255
Wireless sensor networks for habitat monitoring
Mainwaring, A., Culler, D., Polastre, J., Szewczyk, R., & Anderson, J. (2002) · Proceedings of the 1st ACM international workshop on Wireless sensor networks and applications · doi:10.1145/570738.570751 · Cited by 4,166
BISHOP, R. E. D. (1957) · Nature · doi:10.1038/179504a0 · Cited by 1,636
Erturk, A., & Inman, D. J. (2009) · Smart Materials and Structures · doi:10.1088/0964-1726/18/2/025009 · Cited by 1,417
Wireless sensors in agriculture and food industry—Recent development and future perspective
Wang, N., Zhang, N., & Wang, M. (2006) · Computers and Electronics in Agriculture · doi:10.1016/j.compag.2005.09.003 · Cited by 1,099
Piezoelectric Crystals and Their Applications to Ultrasonics
Mason, W. P., & Baerwald, H. (1951) · Physics Today · doi:10.1063/1.3067231 · Cited by 933
Energy Scavenging for Wireless Sensor Networks: with Special Focus on Vibrations
Roundy, S., Wright, P. K., & Rabaey, J. M. (2004) · Springer eBooks · doi:10.1007/978-1-4615-0485-6 · Cited by 790
DESIGN CONSIDERATIONS FOR MEMS-SCALE PIEZOELECTRIC MECHANICAL VIBRATION ENERGY HARVESTERS
DUTOIT, N. E., WARDLE, B. L., & KIM, S.-G. (2005) · Integrated Ferroelectrics · doi:10.1080/10584580590964574 · Cited by 759
Estimation of Electric Charge Output for Piezoelectric Energy Harvesting
Sodano, H. A., Park, G., & Inman, D. J. (2004) · Strain · doi:10.1111/j.1475-1305.2004.00120.x · Cited by 750
Ottman, G. K., Hofmann, H. F., & Lesieutre, G. A. (2003) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.809379 · Cited by 672
Modelling of Piezoelectric Actuator Dynamics for Active Structural Control
Hagood, N. W., Chung, W. H., & von Flotow, A. H. (1990) · Journal of Intelligent Material Systems and Structures · doi:10.1177/1045389x9000100305 · Cited by 641
Energy Scavenging for Wireless Sensor Networks: with Special Focus on Vibrations
Roundy, S., Wright, P. K., & Rabaey, J. M. (2012) · CERN Document Server (European Organization for Nuclear Research) · Cited by 552
Energy harvesting from transverse galloping
Barrero-Gil, A., Alonso, G., & Andres, A. P. S. (2010) · Journal of Sound and Vibration · doi:10.1016/j.jsv.2010.01.028 · Cited by 458
Health Monitoring of Civil Infrastructures Using Wireless Sensor Networks
Kim, S., Pakzad, S., Culler, D., Demmel, J., Fenves, G., Glaser, S., & Turon, M. (2007) · 2007 6th International Symposium on Information Processing in Sensor Networks · doi:10.1109/ipsn.2007.4379685 · Cited by 372
Umeda, M., Nakamura, K., & Ueha, S. (1996) · Japanese Journal of Applied Physics · doi:10.1143/jjap.35.3267 · Cited by 367
Modeling and Testing of a Novel Aeroelastic Flutter Energy Harvester
Bryant, M., & Garcia, E. (2011) · Journal of Vibration and Acoustics · doi:10.1115/1.4002788 · Cited by 322
Modeling and analysis of a bimorph piezoelectric cantilever beam for voltage generation
Ajitsaria, J., Choe, S. Y., Shen, D., & Kim, D. J. (2007) · Smart Materials and Structures · doi:10.1088/0964-1726/16/2/024 · Cited by 258
A self-powered mechanical strain energy sensor
Elvin, N. G., Elvin, A. A., & Spector, M. (2001) · Smart Materials and Structures · doi:10.1088/0964-1726/10/2/314 · Cited by 223
Piezoelectric energy harvesting from flow-induced vibration
Wang, D.-A., & Ko, H.-H. (2010) · Journal of Micromechanics and Microengineering · doi:10.1088/0960-1317/20/2/025019 · Cited by 148
A Novel Piezoelectric Based Wind Energy Harvester for Low-power Autonomous Wind Speed Sensor
Tan, Y. K., & Panda, S. K. (2007) · Annual Conference of the IEEE Industrial Electronics Society (IECON) · doi:10.1109/iecon.2007.4460120 · Cited by 77
Closed analytical solution for galloping aeroelastic self-oscillations
Казакевич, М. И., & Vasilenko, A. G. (1996) · Journal of Wind Engineering and Industrial Aerodynamics · doi:10.1016/s0167-6105(97)00053-6 · Cited by 27
Cited by
The role of advanced sensing in smart cities
Hancke, G., Silva, B., & Hancke, Jr. (2012) · Sensors · doi:10.3390/s130100393 · Cited by 626
Aeroelastic energy harvesting: A review
Abdelkefi, A. (2016) · International Journal of Engineering Science · doi:10.1016/j.ijengsci.2015.10.006 · Cited by 498
Mechanical modulations for enhancing energy harvesting: Principles, methods and applications
Zou, H.-X., Zhao, L.-C., Gao, Q.-H., Zuo, L., Liu, F.-R., Tan, T., Wei, K.-X., & Zhang, W.-M. (2019) · Applied Energy · doi:10.1016/j.apenergy.2019.113871 · Cited by 377
Energy Harvesting Research: The Road from Single Source to Multisource
Bai, Y., Jantunen, H., & Juuti, J. (2018) · Advanced Materials · doi:10.1002/adma.201707271 · Cited by 295
Renewable energy harvesting by vortex-induced motions: Review and benchmarking of technologies
Rostami, A. B., & Armandei, M. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2016.11.202 · Cited by 273
Metadata
- Authors
- Sirohi, J., & Mahadik, R.
- Venue
- Journal of Intelligent Material Systems and Structures
- Publisher
- SAGE Publications
- Published
- 2011-11-16
- Volume
- 22
- Issue
- 18
- Pages
- 2215-2228
- ISSN
- 1045-389X (ISSN-L)
- 1530-8138
- OpenAlex
- W2029731180
- Cited by
- 269
- References
- 21
- FWCI
- 28.46
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.