The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
A comparison of various lignin-extraction methods to enhance the accessibility and ease of enzymatic hydrolysis of the cellulosic component of steam-pretreated poplar
Open accessAbstract
BACKGROUND: Current single-stage delignification-pretreatment technologies to overcome lignocellulosic biomass recalcitrance are usually achieved at the expense of compromising the recovery of the polysaccharide components, particularly the hemicellulose fraction. One way to enhance overall sugar recovery is to tailor an efficient two-stage pretreatment that can pre-extract the more labile hemicellulose component before subjecting the cellulose-rich residual material to a second-stage delignification process. Previous work had shown that a mild steam pretreatment could recover >65% of the hemicellulose from poplar while limiting the acid-catalysed condensation of lignin. This potentially allowed for subsequent lignin extraction using various lignin solvents to produce a more accessible cellulosic substrate. RESULTS: A two-stage approach using steam and/or solvent pretreatment was assessed for its ability to separate hemicellulose and lignin from poplar wood chips while providing a cellulose-rich fraction that could be readily hydrolysed by cellulase enzymes. An initial steam-pretreatment stage was performed over a range of temperatures (160-200 °C) using an equivalent severity factor of 3.6. A higher steam temperature of 190 °C applied over a shorter residence time of 10 min effectively solubilized and recovered 75% of the hemicellulose while enhancing the ability of various solvents [deep eutectic solvent (DES), ethanol organosolv, soda/anthraquinone (soda/AQ) or a hydrotrope] to extract lignin in a second stage. When the second-stage treatments were compared, the mild DES treatment (lactic acid and betaine) at 130 °C, removed comparable amounts of lignin with higher selectivity than did the soda/AQ and organosolv pretreatments at 170 °C. However, the cellulose-rich substrates obtained after the second-stage organosolv and soda/AQ pretreatments showed the highest cellulose accessibility, as measured by the Simon's staining technique. They were also the most susceptible to subsequent enzymatic hydrolysis. CONCLUSIONS: The second-stage pretreatments varied in their ability to solubilize and extract the lignin component of steam-pretreated poplar while enhancing the enzymatic hydrolysis of the resulting cellulose-rich residual fractions. Although DES extraction was more selective in extracting lignin from the steam-pretreated substrates, the organosolv and soda/AQ post treatments disrupted the cellulose structure to a greater extent while enhancing the ease of enzymatic hydrolysis. Graphical abstractEffective hemicellulose removal via steam pretreatment followed by subsequent lignin extraction under acidic, alkaline or solvolytic conditions results in a highly accessible, more readily hydrolysed cellulose fraction.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Bozell, J. J., & Petersen, G. R. (2010) · Green Chemistry · doi:10.1039/b922014c · Cited by 4,566
Abbott, A. P., Boothby, D., Capper, G., Davies, D. L., & Rasheed, R. K. (2004) · Journal of the American Chemical Society · doi:10.1021/ja048266j · Cited by 4,340
Alvira, P., Tomás-Pejó, E., Ballesteros, M., & Negro, M. J. (2010) · Bioresource Technology · doi:10.1016/j.biortech.2009.11.093 · Cited by 3,912 · cited 1×
“The ease of hydrolysis of a pretreated biomass substrate has been shown to be affected by cellulose accessibility and by characteristics such as the crystallinity and degree of polymerization of the cellulose [46].”
BackgroundLow-transition-temperature mixtures (LTTMs): A new generation of designer solvents
Francisco, M., van den Bruinhorst, A., & Kroon, M. C. (2013) · Angewandte Chemie International Edition · doi:10.1002/anie.201207548 · Cited by 1,378
Fractionation of lignocellulosics by steam-aqueous pretreatments
Overend, R. P., & Chornet, E. (1987) · Philosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences · doi:10.1098/rsta.1987.0029 · Cited by 1,288 · cited 1×
“removal Earlier work has shown that low-severity steam pretreatment could result in good hemicellulose recovery and solubilization [13] and that specific severity factor could be achieved using either a shorter residence time at higher temperatures or by reducing the temperature and extending the residence time [33].”
BackgroundFrancisco, M., van den Bruinhorst, A., & Kroon, M. C. (2012) · Green Chemistry · doi:10.1039/c2gc35660k · Cited by 814 · cited 3×
“Therefore, prior to assessing all the four delignification methods, we first wanted to identify optimal conditions that would maximize the dissolution of lignin using a betaine and lactic acid DES that had been shown to have potential for lignin dissolution [19].”
BackgroundMethodInfluentialTan, S. S. Y., MacFarlane, D. R., Upfal, J., Edye, L. A., Doherty, W. O. S., Patti, A. F., Pringle, J. M., & Scott, J. L. (2009) · Green Chemistry · doi:10.1039/b815310h · Cited by 429
Pinkert, A., Goeke, D. F., Marsh, K. N., & Pang, S. (2011) · Green Chemistry · doi:10.1039/c1gc15671c · Cited by 199 · cited 2×
“However, it should be noted that each of these delignification methods limits the effective recovery of the hemicellulose component from the spent liquors [11, 25] and can result in some hemicellulose degradation [7].”
Background
Cited by
Satlewal, A., Agrawal, R., Bhagia, S., Sangoro, J., & Ragauskas, A. J. (2018) · Biotechnology Advances · doi:10.1016/j.biotechadv.2018.08.009 · Cited by 552
Current advancement on the isolation, characterization and application of lignin
Liao, J. J., Latif, N. H. A., Trache, D., Brosse, N., & Hussin, M. H. (2020) · International Journal of Biological Macromolecules · doi:10.1016/j.ijbiomac.2020.06.168 · Cited by 425
Wang, W., & Lee, D.-J. (2021) · Bioresource Technology · doi:10.1016/j.biortech.2021.125587 · Cited by 406
Velvizhi, G., Balakumar, K., Shetti, N. P., Ahmad, E., Kishore Pant, K., & Aminabhavi, T. M. (2022) · Bioresource Technology · doi:10.1016/j.biortech.2021.126151 · Cited by 301
Circular economy aspects of lignin: Towards a lignocellulose biorefinery
Garlapati, V. K., Chandel, A. K., Kumar, S. P. J., Sharma, S., Sevda, S., Ingle, A. P., & Pant, D. (2020) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2020.109977 · Cited by 260
Metadata
- Authors
- Tian, D., Chandra, R. P., Lee, J.-S., Lu, C., & Saddler, J. N.
- Venue
- Biotechnology for Biofuels
- Published
- 2017-06-19
- Volume
- 10
- Issue
- 1
- Pages
- 157-157
- ISSN
- 1754-6834 (ISSN-L)
- OpenAlex
- W2680080861
- Cited by
- 184
- References
- 8
- FWCI
- 6.75
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A comparison of various lignin-extraction methods to enhance the accessibility and ease of enzymatic hydrolysis of the cellulosic component of steam-pretreated poplar. https://app.cochat.ai/papers/10.1186/s13068-017-0846-5
- The paper
- Tian, D., Chandra, R. P., Lee, J.-S., Lu, C., & Saddler, J. N. (2017). A comparison of various lignin-extraction methods to enhance the accessibility and ease of enzymatic hydrolysis of the cellulosic component of steam-pretreated poplar. Biotechnology for Biofuels. https://doi.org/10.1186/s13068-017-0846-5
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.