The DOI matches its Crossref record.
Development of engineered cementitious composites with limestone powder and blast furnace slag
Open accessAbstract
Nowadays limestone powder and blast furnace slag (BFS) are widely used in concrete as blended materials in cement. The replacement of Portland cement by limestone powder and BFS can lower the cost and enhance the greenness of concrete, since the production of these two materials needs less energy and causes less CO 2 emission than Portland cement. Moreover, the use of limestone powder and BFS improves the properties of fresh and hardened concrete, such as workability and durability. Engineered cementitious composites (ECC) is a class of ultra ductile fiber reinforced cementitious composites, characterized by high ductility, tight crack width control and relatively low fiber content. The limestone powder and BFS are used to produce ECC in this research. The mix proportion is designed experimentally by adjusting the amount of limestone powder and BFS, accompanied by four-point bending test and uniaxial tensile test. This study results in an ECC mix proportion with the Portland cement content as low as 15% of powder by weight. This mixture, at 28 days, exhibits a high tensile strain capacity of 3.3%, a tight crack width of 57 μm and a moderate compressive strength of 38 MPa. In order to promote a wide use of ECC, it was tried to simplify the mixing of ECC with only two matrix materials, i.e. BFS cement and limestone powder, instead of three matrix materials. By replacing Portland cement and BFS in the aforementioned ECC mixture with BFS cement, the ECC with BFS cement and limestone powder exhibits a tensile strain capacity of 3.1%, a crack width of 76 μm and a compressive strength of 40 MPa after 28 days of curing.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Wu, M., Johannesson, B., & Geiker, M. (2012) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2011.08.086 · Cited by 757
Yu, J., Yao, J., Lin, X., Li, H., Lam, J. Y. K., Leung, C. K. Y., Sham, I. M. L., & Shih, K. (2018) · Cement and Concrete Research · doi:10.1016/j.cemconres.2018.02.013 · Cited by 324
Zhang, Z., Yang, F., Liu, J.-C., & Wang, S. (2020) · Cement and Concrete Research · doi:10.1016/j.cemconres.2020.106200 · Cited by 305
Guo, P., Meng, W., Xu, M., Li, V. C., & Bao, Y. (2021) · Materials · doi:10.3390/ma14123143 · Cited by 114
Self-citation
Metadata
- Authors
- Zhou, J., Qian, S., Sierra Beltran, M. G., Ye, G., van Breugel, K., & Li, V. C.
- Venue
- Materials and Structures
- Published
- 2009-09-17
- Volume
- 43
- Issue
- 6
- Pages
- 803-814
- ISSN
- 0025-5432 (ISSN-L)
- 1359-5997
- 1871-6873
- OpenAlex
- W2160023807
- Cited by
- 249
- References
- 0
- FWCI
- 13.28
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Development of engineered cementitious composites with limestone powder and blast furnace slag. https://app.cochat.ai/papers/10.1617/s11527-009-9549-0
- The paper
- Zhou, J., Qian, S., Sierra Beltran, M. G., Ye, G., van Breugel, K., & Li, V. C. (2010). Development of engineered cementitious composites with limestone powder and blast furnace slag. Materials and Structures. https://doi.org/10.1617/s11527-009-9549-0
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.