Technology of closed-drift thrusters
The DOI matches its Crossref record.
Abstract
Introduction A CLOSED-drift thruster is defined herein as a thruster in which ions are electrostatically accelerated in essentially the thrust direction, with the accelerating electric field established by an electron current interacting with a transverse magnetic field. One component of the electron motion is counter to the ion flow. Another component is normal to that direction. The current associated with this normal component is called the Hall current. In a closed-drift accelerator there is a complete, or closed, path for the Hall current. In addition, for the ions to be accelerated in essentially a single thrust direction, the ion cyclotron radius must be much larger than the total acceleration length. Closed-drift thrusters usually employ axially symmetric electrodes and pole pieces, with the magnetic field in the radial direction and the electric field in the axial direction. The Hall current flows in a circular closed path in such a configuration. A few closed-drift thrusters without axial symmetry have also been investigated. The closed-drift thruster is particularly well suited for operation in the 1000-2000 s range of specific impulse (approximately 10,000-20,000 m/s exhaust velocity). It is difficult to operate above about 1000 s with an electrothermal thruster due to excessive excitation and ionization losses. On the other hand, the space-charge-flow limitations of gridded electrostatic thrusters will not permit practical ion current densities below about 2000 s. Within the 1000-2000 s range, the electron backflow required to establish ion acceleration can, for the most part, be used to generate ions. The generation of ions constitutes the major closed-drift thruster loss in this range of specific impulse, and this loss can be under 100 eV per beam ion. The power processing requirements are also moderate. In a properly designed closed-drift thruster only one power circuit is required for steady-state operation, with the voltage of this circuit typically in the 50-500 V range.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Plasma oscillations in Hall thrusters
Choueiri, E. Y. (2001) · Physics of Plasmas · doi:10.1063/1.1354644 · Cited by 537
Low frequency oscillations in a stationary plasma thruster
Boeuf, J. P., & Garrigues, L. (1998) · Journal of Applied Physics · doi:10.1063/1.368529 · Cited by 477
Wall material effects in stationary plasma thrusters. I. Parametric studies of an SPT-100
Gascon, N., Dudeck, M., & Barral, S. (2003) · Physics of Plasmas · doi:10.1063/1.1611880 · Cited by 242
Performance evaluation of an iodine-vapor Hall thruster
Szabo, J., Pote, B., Paintal, S., Robin, M., Hillier, A., Branam, R. D., & Huffmann, R. E. (2012) · Journal of Propulsion and Power · doi:10.2514/1.b34291 · Cited by 121
Self-similarity in Hall plasma discharges: Applications to particle models
Taccogna, F., Longo, S., Capitelli, M., & Schneider, R. (2005) · Physics of Plasmas · doi:10.1063/1.1877517 · Cited by 74
Metadata
- Authors
- Kaufman, H. R.
- Venue
- AIAA Journal
- Published
- 1985-01
- Volume
- 23
- Issue
- 1
- Pages
- 78-87
- ISSN
- 0001-1452 (ISSN-L)
- 1533-385X
- OpenAlex
- W2001900982
- Cited by
- 117
- References
- 0
- FWCI
- 0.00
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.