Operation of Three-Stage Process of Lithium Recovery from Geothermal Brine: Simulation
Open accessThe DOI matches its Crossref record; 64 of the 66 references it cites were found in a registry or an index.
Abstract
Lithium-rich geothermal waters are considered as an alternative source, and further concentration of lithium is required for its effective recovery. In this work, we have simulated a three-stage lithium recovery process including the brine softening by precipitation Ca2+/Mg2+ cations with sodium carbonate (calculated in PHREEQC), followed by an integrated system consisting of membrane distillation unit (water evaporation), crystallizer (NaCl precipitation), and membrane extraction (Li+ recovery), which was simulated in Simulink/MATLAB. It was shown that the deterioration of membrane performance in time due to scaling/fouling plays a critical role in the performance of the system resulting in the dramatic increase of the replaced membrane modules by a factor of 5. Low cost membranes are required. The process simulation based on the experimental and literature data on the high salinity solutions with the membrane distillation revealed that the specific productivity can be achieved in the range of 9.9–880 g (Li+) per square meter of membranes in the module used before its replacement. The increase of energy efficiency is needed. The mass-flow-rate of saline solution circulated to the crystallizer was set at its almost minimum value as 6.5 kg/min to enable its successful operation at the given parameters of the membrane distillation unit. In other words, the operation of the integrated system having 140 kg of saline solution in the loop and a membrane module of 2.5 m2 for concentration of lithium presence from 0.11 up to 2.3 g/kg would be associated with the circulation of about of 259 tons of saline solution per month between the distillation unit (60 °C) and the crystallizer (15 °C) to yield of up to 1.4 kg of lithium ions. The comprehensive summary and discussion are presented in the conclusions section.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Figures


![Figure 3 Representation of the membrane module in Simulink: m is the amount of water evaporated in MD module per minute [kg/min], J(Tf) is the polynomial equation that defines the flux of distilled water as a function of the feed Table 2 [kg/m2·h]; Tf is the feed temperature [°C]; S is the active surface area of one membrane module [m2], K is the number of membrane modules, Z(t) is the nonlinear function describing the deterioration of membrane performance due to scaling/fouling over time.](https://figures.cochat.ai/paper-figures/364dfa35f37f48798cd28121812b9106/operation-of-three-stage-process-of-lithium-recovery-from-geothermal-brine-figure-3.jpg)





Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The cited source says what the claim attributes to it.
In the citing paper
“They emphasized the need for low-cost membranes to alleviate the financial burden associated with frequent replacements.”
From Pathways to Greener Primary Lithium Extraction for a Really Sustainable Energy Transition: Environmental Challenges and Pioneering Innovations (2024) · cites this paper as [176]
The cited source says what the claim attributes to it.
In the citing paper
“Kalmykov et al. [176] identified membrane fouling and dirt accumulation as significant factors reducing system efficiency during lithium extraction from geothermal brines.”
From Pathways to Greener Primary Lithium Extraction for a Really Sustainable Energy Transition: Environmental Challenges and Pioneering Innovations (2024) · cites this paper as [176]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Plummer, L. N., & Busenberg, E. (1982) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(82)90056-4 · Cited by 1,886
Recovery and recycling of lithium: a review
Swain, B. (2017) · Separation and Purification Technology · doi:10.1016/j.seppur.2016.08.031 · Cited by 1,713
Membranes and theoretical modeling of membrane distillation: A review
Khayet, M. (2011) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2010.09.005 · Cited by 1,247 · cited 1×
“In this thermally-driven process, the membrane acts as a non-selective barrier that provides high fluxes of water vapors through the pores of the membrane and high selectivity since the saline water as the non-wetting liquid for hydrophobic membrane remains in the feed compartment [37,38].”
BackgroundTarascon, J.-M. (2010) · Nature Chemistry · doi:10.1038/nchem.680 · Cited by 1,157
Global lithium resources: relative importance of pegmatite, brine and other deposits
Kesler, S. E., Gruber, P. W., Medina, P. A., Keoleian, G. A., Everson, M. P., & Wallington, T. J. (2012) · Ore Geology Reviews · doi:10.1016/j.oregeorev.2012.05.006 · Cited by 1,140 · cited 1×
“The recovery of lithium from a different kind of natural brines such as geothermal brine is complicated by high water salinity 200–500 g/L and the presence of hardness ions, especially magnesium ions [13,14].”
BackgroundMembrane distillation: Recent developments and perspectives
Drioli, E., Ali, A., & Macedonio, F. (2015) · Desalination · doi:10.1016/j.desal.2014.10.028 · Cited by 1,107 · cited 1×
“The membrane distillation (MD) can be considered one of the effective approaches for the concentration of different kinds of brines with moderate or high salinity [36].”
BackgroundMembrane distillation at the water-energy nexus: limits, opportunities, and challenges
Deshmukh, A., Boo, C., Karanikola, V., Lin, S., Straub, A. P., Tong, T., Warsinger, D. M., & Elimelech, M. (2018) · Energy & Environmental Science · doi:10.1039/c8ee00291f · Cited by 1,090
Meshram, P., Pandey, B. D., & Mankhand, T. R. (2014) · Hydrometallurgy · doi:10.1016/j.hydromet.2014.10.012 · Cited by 982
Lithium availability and future production outlooks
Vikström, H., Davidsson, S., & Höök, M. (2013) · Applied Energy · doi:10.1016/j.apenergy.2013.04.005 · Cited by 926
Flexer, V., Baspineiro, C. F., & Galli, C. I. (2018) · Science of the Total Environment · doi:10.1016/j.scitotenv.2018.05.223 · Cited by 768 · cited 1×
“Due to its chemical activity, lithium can be found in nature only in the form of salts presented in more than 150 different minerals, solid ores (spodumene, petalite, and lepidolite), and salt brines (salt lakes and geothermal brines) [10].”
Background
Research works printed but not linked: 2
- Martinet, 2004, Nouvelles voies dans les accumulateurs lithium et les électrolytes de batteries, Clefs CEA, 50–51, 130
- Ryabtsev, 2004, Hydromineral raw materials—An inexhaustible source of lithium in the XXI century, Bull. Tomsk Polytech. Univ. Geo Assets Eng., 307, 64
Cited by
Recent advances in lithium extraction from salt lake brine using coupled and tandem technologies
Zhang, J., Cheng, Z., Qin, X., Gao, X., Wang, M., & Xiang, X. (2023) · Desalination · doi:10.1016/j.desal.2022.116225 · Cited by 195
Nikkhah, H., Ipekçi, D., Xiang, W., Stoll, Z., Xu, P., Li, B., McCutcheon, J. R., & Beykal, B. (2024) · Chemical Engineering Journal · doi:10.1016/j.cej.2024.155349 · Cited by 154
Review of recent advances in lithium extraction from subsurface brines
Disu, B., Rafati, R., Haddad, A. S., Mendoza‐Roca, J. A., Iborra–Clar, M. I., & Bakhtiari, S. S. E. (2024) · Geoenergy Science and Engineering · doi:10.1016/j.geoen.2024.213189 · Cited by 94
Fouling and Membrane Degradation in Electromembrane and Baromembrane Processes
Apel, P. Y., Велизаров, С., Волков, А. В., Елисеева, Т. В., Nikonenko, V., Паршина, А. В., Pismenskaya, N. D., Popov, K., & Yaroslavtsev, A. B. (2022) · Membranes and Membrane Technologies · doi:10.1134/s2517751622020032 · Cited by 84
Zhao, X., Gong, Y., Gao, K., Wang, Y., & Yang, H. Y. (2023) · Chemical Engineering Journal · doi:10.1016/j.cej.2023.145975 · Cited by 78
Metadata
- Authors
- Kalmykov, D., Makaev, S., Golubev, G., Eremeev, I., Vasilevsky, V., Song, J., He, T., & Volkov, A.
- Affiliations
- A.V. Topchiev Institute of Petrochemical Synthesis (RU)
- Chinese Academy of Sciences (CN)
- A.V.Topchiev Institute of Petrochemical Synthesis RAS, 29 Leninsky prospekt, 119991 Moscow, Russia
- ORCID
- Venue
- Membranes
- Publisher
- MDPI AG
- Published
- 2021-02-28
- Volume
- 11
- Issue
- 3
- Pages
- 175
- ISSN
- 2077-0375 (ISSN-L)
- PMC
- PMC8001782
- OpenAlex
- W3135380462
- Cited by
- 37
- References
- 66
- Citations by year
- 2026: 8 · 2025: 5 · 2024: 8 · 2023: 8 · 2022: 6 · 2021: 2
- FWCI
- 1.78
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- Locations
- Membranes (publishedVersion, cc-by)
- PubMed Central (publishedVersion, cc-by)
- PubMed (publishedVersion)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
- Funders
- Russian Foundation for Basic Research (20-58-53038)
- National Natural Science Foundation of China (52011530031)
- CAS International Collaboration (GJHZ2080)
- Topics
- Physical Sciences › Environmental Science › Water Science and Technology › Membrane Separation Technologies
- Physical Sciences › Materials Science › Metals and Alloys › Extraction and Separation Processes
- Physical Sciences › Chemical Engineering › Filtration and Separation › Membrane-based Ion Separation Techniques
- Keywords
- lithium recovery, geothermal brine, membrane distillation, membrane fouling, membrane scaling, sodium carbonate precipitation, crystallizer, NaCl precipitation, membrane extraction, lithium content, energy efficiency
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Operation of Three-Stage Process of Lithium Recovery from Geothermal Brine: Simulation. https://app.cochat.ai/papers/10.3390/membranes11030175
- The paper
- Kalmykov, D., Makaev, S., Golubev, G., Eremeev, I., Vasilevsky, V., Song, J., He, T., & Volkov, A. (2021). Operation of Three-Stage Process of Lithium Recovery from Geothermal Brine: Simulation. Membranes. https://doi.org/10.3390/membranes11030175
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.