The DOI matches its Crossref record; 55 of the 56 references it cites were found in a registry or an index.
Synthesis and Electrochemical Properties of Two-Dimensional RGO/Ti3C2Tx Nanocomposites
Open accessAbstract
MXene is a new type of two-dimensional layered material. Herein, a GO/Ti3C2Tx nanocomposite was prepared by a simple liquid phase method, and the obtained GO/Ti3C2Tx was transformed into RGO/Ti3C2Tx under high temperature with Ar/H2. The prepared samples were characterized using X-ray diffraction (XRD), Raman measurement, scanning electron microscopy (SEM), energy disperse spectroscopy (EDS), and X-ray photoelectron spectroscopy (XPS). As an electrode material in lithium-ion batteries, the RGO/Ti3C2Tx nanocomposite exhibited an excellent electrochemical performance and an excellent rate performance. Compared to pure Ti3C2Tx, the nanocomposite had a better reversible capacity at different current densities and had no attenuation after 200 cycles, which is one time higher than pure Ti3C2Tx. The improvement in the specific capacity was due to the excellent electrical conductivity and the unique structure of RGO, in which a charge transfer bridge was built among the Ti3C2Tx flakes. Such a bridge shortened the transmission distance of the electrons and ions and effectively controlled the restacking of the laminated materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Figures
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“the MXene utilized in this study can be oxidized at temperature higher than 600 °C [20, 32–34]”
From Hybrid MXene/reduced graphene oxide aerogel microspheres for hydrogen evolution reaction (2021) · cites this paper as [34]
Experimental — accuracy not yet measured
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Two‐Dimensional Nanocrystals Produced by Exfoliation of Ti 3 AlC 2
Naguib, M., Kurtoglu, M., Presser, V., Lu, J., Niu, J., Heon, M., Hultman, L., Gogotsi, Y. G., & Barsoum, M. W. (2011) · Advanced Materials · doi:10.1002/adma.201102306 · Cited by 12,026 · cited 2×
“The A element is selectively etched from the MAX phase using hydrofluoric acid (HF) [9,13] or a mixture of fluoride salt and hydrochloric acid (HCl) [14] to produce MXene, which are known to possess graphene-like 2D structures.”
BackgroundMethodThe chemistry of graphene oxide
Dreyer, D. R., Park, S., Bielawski, C. W., & Ruoff, R. S. (2010) · Chem. Soc. Rev. · doi:10.1039/b917103g · Cited by 11,653 · cited 1×
“GO was synthesized with expanded graphite by a modified Hummers method [42].”
Method25th Anniversary Article: MXenes: A New Family of Two‐Dimensional Materials
Naguib, M., Mochalin, V. N., Barsoum, M. W., & Gogotsi, Y. G. (2013) · Advanced Materials · doi:10.1002/adma.201304138 · Cited by 6,453 · cited 2×
“5)3C2, Ti3CN, Ta4C3, Nb2C, V2C, and Nb4C3 [13,16].”
MethodTwo-Dimensional Transition Metal Carbides
Naguib, M., Mashtalir, O., Carle, J., Presser, V., Lu, J., Hultman, L., Gogotsi, Y. G., & Barsoum, M. W. (2012) · ACS Nano · doi:10.1021/nn204153h · Cited by 4,818 · cited 1×
“For example, MXene contains Ti3C2Tx and Ti2CTx [8,9].”
BackgroundCation Intercalation and High Volumetric Capacitance of Two-Dimensional Titanium Carbide
Lukatskaya, M. R., Mashtalir, O., Ren, C. E., Dall’Agnese, Y., Rozier, P., Taberna, P., Naguib, M., Simon, P., Barsoum, M. W., & Gogotsi, Y. G. (2013) · Science · doi:10.1126/science.1241488 · Cited by 4,365
The MN+1AXN phases: A new class of solids
Barsoum, M. W. (2000) · Progress in Solid State Chemistry · doi:10.1016/s0079-6786(00)00006-6 · Cited by 3,685
Science and technology roadmap for graphene, related two-dimensional crystals, and hybrid systems
Ferrari, A. C., Bonaccorso, F., Fal’ko, V. I., Novoselov, K. S., Roche, S., Bøggild, P., Borini, S., Koppens, F. H. L., Palermo, V., Pugno, N. M., et al. (2014) · Nanoscale · doi:10.1039/c4nr01600a · Cited by 3,065
Intercalation and delamination of layered carbides and carbonitrides
Mashtalir, O., Naguib, M., Mochalin, V. N., Dall’Agnese, Y., Heon, M., Barsoum, M. W., & Gogotsi, Y. G. (2013) · Nature Communications · doi:10.1038/ncomms2664 · Cited by 2,874
Flexible and conductive MXene films and nanocomposites with high capacitance
Ling, Z., Ren, C. E., Zhao, M., Yang, J. H., Giammarco, J. M., Qiu, J., Barsoum, M. W., & Gogotsi, Y. G. (2014) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.1414215111 · Cited by 2,284
Tang, Q. H., Zhou, Z. P., & Shen, P. (2012) · Journal of the American Chemical Society · doi:10.1021/ja308463r · Cited by 2,254
Cited by
Sorted by citations
Advances in the Synthesis of 2D MXenes
Yi, W., Zhang, P., Soomro, R. A., Zhu, Q., & Xu, B. (2021) · Advanced Materials · doi:10.1002/adma.202103148 · Cited by 1,241
Surface Termination Dependent Work Function and Electronic Properties of Ti3C2Tx MXene
Schultz, T., Frey, N. C., Hantanasirisakul, K., Park, S., May, S. J., Shenoy, V. B., Gogotsi, Y. G., & Koch, N. (2019) · Chemistry of Materials · doi:10.1021/acs.chemmater.9b00414 · Cited by 738
Flexible 3D Porous MXene Foam for High‐Performance Lithium‐Ion Batteries
Zhao, Q. C., Zhu, Q., Miao, J., Zhang, P., Wan, P., He, L., & Xu, B. (2019) · Small · doi:10.1002/smll.201904293 · Cited by 391
MXene as emerging material for photocatalytic degradation of environmental pollutants
Solangi, N. H., Karri, R. R., Mazari, S. A., Mubarak, N. M., Jatoi, A. S., Malafaia, G., & Азад, А. К. (2022) · Coordination Chemistry Reviews · doi:10.1016/j.ccr.2022.214965 · Cited by 284
Yuan, S., Lai, Q., Duan, X., & Wang, Q. (2023) · Journal of Energy Storage · doi:10.1016/j.est.2023.106716 · Cited by 265
Metadata
- Authors
- Shen, C., Wang, L., Zhou, A., Wang, B., Wang, X., Lian, W., Hu, Q., Qin, G., & Liu, X.
- Affiliations
- Henan Polytechnic University (CN)
- Chinese Academy of Sciences (CN)
- University of Manchester (GB)
- Corresponding author
- Wang, Libo
- Venue
- Nanomaterials
- Publisher
- MDPI AG
- Published
- 2018-01-31
- Volume
- 8
- Issue
- 2
- Pages
- 80
- ISSN
- 2079-4991 (ISSN-L)
- PMC
- PMC5853712
- OpenAlex
- W2785719750
- Cited by
- 152
- References
- 56
- Citations by year
- 2026: 15 · 2025: 9 · 2024: 19 · 2023: 35 · 2022: 25 · 2021: 12 · 2020: 21 · 2019: 15 · 2018: 1
- FWCI
- 4.57
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- Locations
- Nanomaterials (publishedVersion, cc-by)
- Europe PMC (PubMed Central) (publishedVersion, cc-by)
- PubMed Central (publishedVersion, cc-by)
- PubMed (publishedVersion)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
- Research Explorer (The University of Manchester) (submittedVersion, cc-by)
- Funders
- National Natural Science Foundation of China (51403056, 51472075, 134100510008, 51772077, T2013-4)
- Henan Polytechnic University (T2013‐4)
- Henan Province Science and Technology Innovation Talent Program
- Topics
- Physical Sciences › Materials Science › Materials Chemistry › MXene and MAX Phase Materials
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advancements in Battery Materials
- Physical Sciences › Materials Science › Electronic, Optical and Magnetic Materials › Supercapacitor Materials and Fabrication
- Keywords
- MXene, Ti3C2Tx, reduced graphene oxide, lithium-ion battery anodes, electrochemical performance, rate capability, reversible capacity, two-dimensional layered materials
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
