The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
A New Model for Determining Weight Coefficients of Criteria in MCDM Models: Full Consistency Method (FUCOM)
Open accessAbstract
In this paper, a new multi-criteria problem solving method—the Full Consistency Method (FUCOM)—is proposed. The model implies the definition of two groups of constraints that need to satisfy the optimal values of weight coefficients. The first group of constraints is the condition that the relations of the weight coefficients of criteria should be equal to the comparative priorities of the criteria. The second group of constraints is defined on the basis of the conditions of mathematical transitivity. After defining the constraints and solving the model, in addition to optimal weight values, a deviation from full consistency (DFC) is obtained. The degree of DFC is the deviation value of the obtained weight coefficients from the estimated comparative priorities of the criteria. In addition, DFC is also the reliability confirmation of the obtained weights of criteria. In order to illustrate the proposed model and evaluate its performance, FUCOM was tested on several numerical examples from the literature. The model validation was performed by comparing it with the other subjective models (the Best Worst Method (BWM) and Analytic Hierarchy Process (AHP)), based on the pairwise comparisons of the criteria and the validation of the results by using DFC. The results show that FUCOM provides better results than the BWM and AHP methods, when the relation between consistency and the required number of the comparisons of the criteria are taken into consideration. The main advantages of FUCOM in relation to the existing multi-criteria decision-making (MCDM) methods are as follows: (1) a significantly smaller number of pairwise comparisons (only n − 1), (2) a consistent pairwise comparison of criteria, and (3) the calculation of the reliable values of criteria weight coefficients, which contribute to rational judgment.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Models, Methods, Concepts & Applications of the Analytic Hierarchy Process
Saaty, T. L., & Vargas, L. G. (2012) · International Series in Operations Research & Management Science · doi:10.1007/978-1-4614-3597-6 · Cited by 2,210
Cited by
Weighting methods for multi-criteria decision making technique
Odu, G. O. (2019) · Journal of Applied Sciences and Environmental Management · doi:10.4314/jasem.v23i8.7 · Cited by 536
Ufa State Petroleum Technological University, U., & Mukhametzyanov, I. (2021) · Decision Making: Applications in Management and Engineering · doi:10.31181/dmame210402076i · Cited by 343
“These are such methods as the direct ranking method (DR) (Goodwin & Wright, 1998; Roberts & Goodwin, 2002; Von Winterfeldt & Edwards, 1986), the point allocation (PA) method (Doyle et al., 1997; Roberts & Goodwin, 2002), the ranking method (Ahn & Park, 2008; Barron, 1992, 1996; Roberts & Goodwin, 2002; Solymosi & Domb…”
MethodA new intelligent multilayer framework for insider threat detection
Al-Mhiqani, M. N., Ahmad, R., Abidin, Z. Z., Abdulkareem, K. H., Mohammed, M. A., Gupta, D., & Shankar, K. (2022) · Computers and Electrical Engineering · doi:10.1016/j.compeleceng.2021.107597 · Cited by 87
A Fermatean fuzzy MCDM method for selection and ranking Problems: Case studies
Aydoğan, H., & Ozkir, V. (2024) · Expert Systems with Applications · doi:10.1016/j.eswa.2023.121628 · Cited by 59
Metadata
- Authors
- Pamučar, D., Stević, Ž., & Sremac, S.
- Venue
- Symmetry
- Publisher
- MDPI AG
- Published
- 2018-09-10
- Volume
- 10
- Issue
- 9
- Pages
- 393
- ISSN
- 2073-8994 (ISSN-L)
- OpenAlex
- W2891154333
- Cited by
- 857
- References
- 1
- FWCI
- 40.38
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A New Model for Determining Weight Coefficients of Criteria in MCDM Models: Full Consistency Method (FUCOM). https://app.cochat.ai/papers/10.3390/sym10090393
- The paper
- Pamučar, D., Stević, Ž., & Sremac, S. (2018). A New Model for Determining Weight Coefficients of Criteria in MCDM Models: Full Consistency Method (FUCOM). Symmetry. https://doi.org/10.3390/sym10090393
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.