High-Temperature Corrosion Mechanisms for Selected Iron and Nickel-Based Alloys Exposed to Sulfur and Chlorine-Containing Environments
The DOI matches its Crossref record; 15 of the 17 references it cites were found in a registry or an index.
Abstract
A comprehensive research project consisting of pilot-scale combustion testing and long-term laboratory corrosion study has been performed. A pilot-scale combustion facility was modified to enable burning of pulverized coals under the conditions typical for coal-fired utility boilers. Eight United States (U.S.) coals were selected for this investigation, with the test conditions for all coals set to have the same heat input to the combustor. In addition, the air/fuel ratio was controlled so that approximately 3% excess oxygen was attained in the combustion gas at the furnace outlet, a location equivalent to the furnace exit of commercial boilers. During each pilot-scale combustion test, extensive online measurements of the flue gas compositions were performed. In addition, deposit samples were collected at the same location for chemical analyses. This information characterized well the combustion environments adjacent to the superheaters and reheaters of utility boilers burning different U.S. coals. The gas and deposit compositions were then simulated in a series of 1,000-h laboratory corrosion tests in which the corrosion performances of different alloys were evaluated at 704°C (1,300°F). Results of this laboratory study led to better understanding of the corrosion mechanisms operating on superheaters and reheaters in coal-fired boilers due to the coexistence of sulfur and chlorine in coal. A new corrosion mechanism, i.e., “active sulfide-to-oxide corrosion mechanism,” accounts for the rapid corrosion attack on low-alloy ferritic steels and lower-grade stainless steels resulting from the formation of iron chloride (FeCl2) vapor and associated cycling reactions. For higher alloys containing sufficient chromium, the attack is dominated by “hot corrosion” in the presence of a fused salt. In addition, two stages of the hot corrosion mechanism have been elucidated here in detail. The initiation of hot corrosion attack induced by molten sulfate may involve Stage 1 “acidic” fluxing and re-precipitation of the protective scale formed initially on the deposit-covered alloy surfaces, followed by Stage 2 Hot Corrosion dominated by “basic” fluxing and re-precipitation after the scale is locally penetrated by the fused salt.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Materials for ultra-supercritical coal-fired power plant boilers
Viswanathan, R., Coleman, K., & Rao, U. (2006) · International Journal of Pressure Vessels and Piping · doi:10.1016/j.ijpvp.2006.08.006 · Cited by 342
Na2SO4-induced accelerated oxidation (hot corrosion) of nickel
Goebel, J. A., & Pettit, F. S. (1970) · Metallurgical Transactions · doi:10.1007/bf02642794 · Cited by 284
Emissions of Sulfur Trioxide from Coal-Fired Power Plants
Srivastava, R. K., Miller, C. A., Erickson, C., & Jambhekar, R. (2004) · Journal of the Air & Waste Management Association · doi:10.1080/10473289.2004.10470943 · Cited by 278
Hot Corrosion of Metals and Alloys
Pettit, F. (2011) · Oxidation of Metals · doi:10.1007/s11085-011-9254-6 · Cited by 241
Mechanism of Na2 SO 4 Induced Corrosion at 600°–900°C
Luthra, K. L., & Shores, D. A. (1980) · Journal of The Electrochemical Society · doi:10.1149/1.2129375 · Cited by 170
Investigation on Coal Pyrolysis in CO2Atmosphere
Duan, L., Zhao, C., Zhou, W., Qu, C., & Chen, X. (2009) · Energy & Fuels · doi:10.1021/ef9002473 · Cited by 153
The Hot Corrosion of Metals by Molten Salts
Rapp, R. A. (1981) · ECS Proceedings Volumes · doi:10.1149/198110.0159pv · Cited by 136
Advanced Heat Resistant Steels for Power Generation
Viswanathan, R., & Nutting, J. (1999) · OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) · Cited by 106
Hot Corrosion of Preoxidized Ni by a Thin Fused Na2 SO 4 Film at 900°C
Otsuka, N., & Rapp, R. A. (1990) · Journal of The Electrochemical Society · doi:10.1149/1.2086436 · Cited by 60
Some generalities in the analyses of equilibria in lonic solutions
Rapp, R. A., Mehl, R. F., & Medalist, A. (2000) · Metallurgical and Materials Transactions A · doi:10.1007/s11661-000-0128-9 · Cited by 25
Research works printed but not linked: 5
- Rapp, 1994, J. Met, 46, 47
- Daniel, 1991, “The Effect of Coal Chlorides on Furnace Wall Corrosion,”, Coal Science and Technology 17 Chlorine in Coal, 207
- Kaminskii, 1996, Therm. Eng, 43, 505
- Grabke, 1998, Molten Salt Forum, 5–6, 405
- Rapp, 2009, Electrochem. Trans, 16, 271
Cited by
deBarbadillo, J. J. (2016) · Elsevier eBooks · doi:10.1016/b978-0-08-100552-1.00014-2 · Cited by 38
Wang, J., Zhou, H., Zhang, C.-Z., Liu, W.-N., & Zhao, B.-Y. (2017) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2017.11.014 · Cited by 31
Reaction Mechanism for Sulfur Species during Pulverized Coal Combustion
Ma, H., Zhou, L., Ma, S., Wang, Z., Cui, Z., Zhang, W., & Li, J. (2018) · Energy & Fuels · doi:10.1021/acs.energyfuels.7b03868 · Cited by 27
High Temperature Corrosion Resistant and Anti-slagging Coatings for Boilers: A Review
Khantisopon, K., Singh, S., Jitputti, J., Berndt, C. C., & Ang, A. S. M. (2024) · High Temperature Corrosion of Materials · doi:10.1007/s11085-024-10251-0 · Cited by 30
Okoro, S. C., Kiamehr, S., Montgomery, M., Frandsen, F., & Pantleon, K. (2016) · Materials and Corrosion · doi:10.1002/maco.201609174 · Cited by 17
Metadata
- Authors
- Kung, S. C.
- Corresponding author
- Kung, Steven C.
- Venue
- Corrosion
- Published
- 2014-11-07
- Volume
- 71
- Issue
- 4
- Pages
- 483-501
- ISSN
- 0010-9312 (ISSN-L)
- 1938-159X
- DOI
- 10.5006/1409
- OpenAlex
- W1985426096
- Cited by
- 13
- References
- 17
- Citations by year
- 2026: 1 · 2025: 1 · 2024: 1 · 2022: 1 · 2021: 3 · 2018: 2 · 2017: 1 · 2016: 3
- FWCI
- 1.97
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- CORROSION (publishedVersion)
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
- Physical Sciences › Engineering › Mechanical Engineering › High Temperature Alloys and Creep
- Physical Sciences › Materials Science › Materials Chemistry › Corrosion Behavior and Inhibition
- Keywords
- high-temperature corrosion, iron alloys, nickel-based alloys, coal-fired boilers, superheater, reheater, hot corrosion, molten sulfates, molten salts, low alloy ferritic steel, stainless steel, coal deposits, flue gas composition, corrosion mechanism
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: High-Temperature Corrosion Mechanisms for Selected Iron and Nickel-Based Alloys Exposed to Sulfur and Chlorine-Containing Environments. https://app.cochat.ai/papers/10.5006/1409
- The paper
- Kung, S. C. (2015). High-Temperature Corrosion Mechanisms for Selected Iron and Nickel-Based Alloys Exposed to Sulfur and Chlorine-Containing Environments. Corrosion. https://doi.org/10.5006/1409
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.