Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 291

The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.

Potassium hydroxide activation of activated carbon: a commentary

Open access
Hui, Tang Shu, Zaini, Muhammad Abbas Ahmad·2015·Carbon letters

Abstract

Copyright © Korean Carbon Society http://carbonlett.org Over the years, the furnace has been used as a common heating method to manufacture activated carbon. In a furnace, heat is transferred through conduction and convection. The outer surface of the sample is in contact with the generated heat, which slowly diffuses inwards as a result of the thermal gradient between the surface and the core of the material’s particles. Another method of heating employs microwave irradiation. Even though it is less energyand time-consuming, the microwave method has several critical issues with respect to temperature control and thermal runaway, especially in the scaling-up of the microwave heating process [1]. Generally, the activation of a carbonaceous precursor can be performed through physical (steam, air or CO2) or chemical activation (activators such as ZnCl2, KOH, etc.) or a combination of both. The chemical activation is normally preferable over physical activation since it is a faster process with a lower activation temperature. Moreover, the activated carbon produced via chemical activation usually possesses high specific surface area (as determined by the Brunauer-Emmett-Teller, BET method), good pore development and high carbon yield [2,3]. In recent years, potassium salts such as KOH and K2CO3 have been widely used in the manufacture of low cost activated carbon. It has been found that activated carbon prepared by KOH activation is highly microporous when compared to that produced through ZnCl2 or H3PO4 activation [4-6]. Besides, KOH also enhances the specific surface area and the formation of—OH functional groups on the carbon surface [7]. Over the past 5 years, many advantages of KOH activation have been revealed in the literature [8]. However, the adverse drawbacks of employing KOH have been overlooked in many of the published studies. In this paper, the preparation of activated carbon by KOH activation using conventional heating is reviewed and discussed. The limitations and implications of using KOH in the activation process are highlighted. The selection of appropriate potassium salts for activated carbon preparation is also recommended. The physical preparation of activated carbon is comprised of two major processes, namely, carbonization and activation of the carbonized sample [4]. Chemical activation is a single step process, as both carbonization and activation occur simultaneously at temperatures ranging between 400oC and 700oC, which is lower than that of physical activation [9]. However, in some cases, additional carbonization or a pre-carbonization step is performed to produce char prior to chemical impregnation and activation [5,4,10-13]. Thus, potassium hydroxide activation can be achieved through either direct chemical activation or char-impregnated chemical activation. In direct chemical activation, a selected carbonaceous precursor is first dried overnight to remove moisture and then chemically treated at a desired impregnation ratio (weight of KOH over weight of precursor). The impregnated solid is then heated in a furnace at a specified temperature and time. Carbonization of the precursor is often omitted when the impregnated solid is already suitable for activation. Table 1 exhibits recently developed activated carbon preparation methods using various precursors and KOH activation with conventional heating. From Table 1, it can be seen that DOI: http://dx.doi.org/ DOI:10.5714/CL.2015.16.4.275

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.5714/cl.2015.16.4.275

Cites

1 of 1 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 1 references

Cited by

See all 291

Metadata

Authors
Hui, T. S., & Zaini, M. A. A.
Venue
Carbon letters
Published
2015-10-31
Volume
16
Issue
4
Pages
275-280
ISSN
1976-4251 (ISSN-L)
OpenAlex
W2341750026
Cited by
291
References
1
FWCI
7.44
Type
journal article
Language
en
Open access
bronze

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Potassium hydroxide activation of activated carbon: a commentary. https://app.cochat.ai/papers/10.5714/cl.2015.16.4.275
The paper
Hui, T. S., & Zaini, M. A. A. (2015). Potassium hydroxide activation of activated carbon: a commentary. Carbon letters. https://doi.org/10.5714/cl.2015.16.4.275

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.