CoChat

Influence of power supply in the feasibility of Phaeodactylum tricornutum cultures

Brindley Alías, C., García‐Malea López, M.C., Acién Fernández, F.G., Ferníndez Sevilla, J.M., García Sánchez, J.L., Molina Grima, E. · 2004 · Biotechnology and Bioengineering
Cited by 95

The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.

Abstract

The influence of fluid‐dynamic conditions on the yield of Phaeodactylum tricornutum microalgal cultures was analyzed in two stages: first, the influence of air flow rate; second, the influence of using fluid‐moving pumps for recirculating the culture. With respect to the air flow rate, the yield of the cultures increased with the aeration rate up to values of 2.0 v/v/min, then stress was observed and the yield of the cultures decreased. With respect to the influence of mechanical power supply for liquid impulsion, three different types of pumps—centrifugal, pulse, and peristaltic—were essayed at different power supplies. The cultures were stressed for the three types of pumps essayed. For each pump, the higher the power supply the lower was the Fv/Fm value and the higher was the stress at which cells were exposed. The highest measured stress was when the culture was moved with the centrifugal pump. Despite measured stress, for all the experiments stable steady states were reached, thus indicating that cells reduced their yield but did not die, as was verified by cell viability measurements. It was observed that the increase of the power supply improved the frequency of light exposition thus enhancing the yield of the cultures. However, the higher the power supply, the lower the microeddy length scale; therefore, stress could appear. Data demonstrated that the microeddy length scale was always much higher than cell size and therefore the turbulence was not responsible for stress. Also, the mass transfer was discarded as responsible for yield reduction. It was concluded that the shear rate was the factor determining the existence of stress phenomena. The evaluation of these shear rates demonstrated that values above 30–80 s−1 damaged the cells strongly. These data were verified in an outdoor pilot‐scale tubular photobioreactor that was implemented with the same type of pumps, thus demonstrating the necessity to take into account this factor in the design and scale‐up of microalgal photobioreactors. © 2004 Wiley Periodicals, Inc.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1002/bit.20179

Cites

3 of 3 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 3 references

Cited by

Metadata

Authors
Brindley Alías, C., García‐Malea López, M. C., Acién Fernández, F. G., Ferníndez Sevilla, J. M., García Sánchez, J. L., & Molina Grima, E.
Venue
Biotechnology and Bioengineering
Publisher
Wiley
Published
2004-08-19
Volume
87
Issue
6
Pages
723-733
ISSN
  • 0006-3592 (ISSN-L)
  • 1097-0290
OpenAlex
W2148598593
Cited by
95
References
3
FWCI
1.30
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.