The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.
Effect of Alloy Composition and Exposure Conditions on the Selective Oxidation Behavior of Ferritic Fe–Cr and Fe–Cr–X Alloys
Open accessOverview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“Reaction in dry [7] and wet CO 2 gases resulted in both oxidation and carburization for the undoped Fe-20Cr-20Ni alloy, as shown in Fig. 12 for the wet case.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“The addition of a small amount of Si to Fe-20Cr-20Ni greatly reduced oxygen uptake in both dry [7] and wet (Fig. 7) CO 2 gases.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“Addition of Si to Fe-20Cr and Fe-20Cr-20Ni resulted in the formation of an additional silicon oxide layer beneath the chromia layer during reaction in dry [7] and wet CO 2 (Figs. 5, 11).”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe source backs part of the claim, not all of it — or backs it for a different population, condition or comparison.
In the citing paper
“The chromia scale formed in the early stages was therefore replaced by a uniform iron oxide scale when reactions proceeded to longer times in both dry [7] and wet [10] gases.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“However, weight uptakes of the Si-containing alloys in dry CO 2 [7] and wet CO 2 gas (Fig. 1) were markedly smaller than those of the undoped Fe-20Cr alloy.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measured
The check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“The undoped Fe-20Cr-20Ni alloy underwent breakaway oxidation in dry [7] and wet CO 2 (Fig. 8), but the additions of Si to this alloy markedly reduced the oxygen uptake in both dry CO 2 [7] and wet CO 2 (Fig. 7).”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“Blade-shaped whiskers were observed on chromia scales in the wet CO 2 reaction (Fig. 2b), but not in dry CO 2 [7].”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“In contrast, metallographic examination confirmed that no carbides were formed in any Si-containing Fe-20Cr-20Ni alloy in either dry [7] or wet CO 2 gases.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“The thin scale regions on Fe-20Cr-20Ni-(0.1, 0.2, 0.5)Si alloys after reactions in dry [7] and wet CO 2 (Figs. 5, 11) reactions contained the same corrosion products of chromia and silicon oxide.”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measuredThe check wasn’t confident either way, so it gives no verdict — never disputed.
In the citing paper
“Solid chromia scales on these Si-bearing austenitic alloys were thin and almost the same thickness in dry (about 0.8~1.5 µm thick after 240 h) [7] and wet CO 2 (about 1.6 µm thick after 240 h).”
From Effects of Silicon on High Temperature Corrosion of Fe–Cr and Fe–Cr–Ni Alloys in Carbon Dioxide (2014) · cites this paper as [7]
Experimental — accuracy not yet measured
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Theoretical Analysis of the Diffusion Processes Determining the Oxidation Rate of Alloys
Wagner, C. G. (1952) · Journal of The Electrochemical Society · doi:10.1149/1.2779605 · Cited by 1,121
Gase und Kohlenstoff in Metallen
(1976) · Reine und angewandte Metallkunde in Einzeldarstellungen · doi:10.1007/978-3-642-80943-9 · Cited by 656
A review of the oxidation behaviour of structural alloys in steam
Wright, I. G., & Dooley, R. B. (2010) · International Materials Reviews · doi:10.1179/095066010x12646898728165 · Cited by 365
Rapp, R. A. (1961) · Acta Metallurgica · doi:10.1016/0001-6160(61)90103-1 · Cited by 344
Rahmel, A., & Tobolski, J. (1965) · Corrosion Science · doi:10.1016/s0010-938x(65)90500-7 · Cited by 248
Corrosion of metals and alloys in mixed gas environments at elevated temperatures
Giggins, C. S., & Pettit, F. S. (1980) · Oxidation of Metals · doi:10.1007/bf00603609 · Cited by 223
Self-citationThe Mechanism of the High-Temperature Oxidation of Iron-Chromium Alloys in Water Vapor
Fujii, C. T., & Meussner, R. A. (1964) · Journal of The Electrochemical Society · doi:10.1149/1.2425963 · Cited by 223
Essuman, E., Meier, G. H., Zurek, J., Hänsel, M., Singheiser, L., & Quadakkers, W. J. (2007) · Scripta Materialia · doi:10.1016/j.scriptamat.2007.06.058 · Cited by 175
Self-citationComposition and growth mechanisms of alumina scales on FeCrAl-based alloys determined by SNMS
Quadakkers, W. J., Elschner, A., Speier, W., & Nickel, H. (1991) · Applied Surface Science · doi:10.1016/0169-4332(91)90069-v · Cited by 171
Self-citationBasu, S. N., & Yurek, G. J. (1991) · Oxidation of Metals · doi:10.1007/bf00662967 · Cited by 163
Research works printed but not linked: 3
- C. Wagner, Zeitschrift für Elektrochemie 63, 772 (1959).
- J. H. Swisher and E. T. Turkdogan, Transactions of the Metallurgical Society AIME 239, 426 (1967).
- M. H. B. Ani, T. Kodama, M. Ueda, K. Kawamura, and T. Maruyama, Materials Transactions 50, 256 (2009).
Cited by
Sorted by citations
Review of progress in calculation and simulation of high-temperature oxidation
Gao, D., Shen, Z., Chen, K., Zhou, X., Hong, L., Wang, J., Li, Y., Liu, Z., Deng, H., Wang, W. Y., et al. (2024) · Progress in Materials Science · doi:10.1016/j.pmatsci.2024.101348 · Cited by 187
Carburisation of ferritic Fe–Cr alloys by low carbon activity gases
Gheno, T., Monceau, D., Zhang, J., & Young, D. J. (2011) · Corrosion Science · doi:10.1016/j.corsci.2011.05.013 · Cited by 169
Col, A., Parry, V., & Pascal, C. (2017) · Corrosion Science · doi:10.1016/j.corsci.2016.10.029 · Cited by 144
Guzonas, D. A., & Cook, W. G. (2012) · Corrosion Science · doi:10.1016/j.corsci.2012.08.006 · Cited by 132
Corrosion of 9-12Cr ferritic–martensitic steels in high-temperature CO2
Rouillard, F., & Furukawa, T. (2016) · Corrosion Science · doi:10.1016/j.corsci.2016.01.009 · Cited by 132
Metadata
- Authors
- Meier, G. H., Jung, K., Mu, N., Yanar, N. M., Pettit, F. S., Pirón Abellán, J., Olszewski, T., Nieto Hierro, L., Quadakkers, W. J., & Holcomb, G. R.
- Affiliations
- University of Pittsburgh (US)
- Forschungszentrum Jülich (DE)
- National Energy Technology Laboratory (US)
- Corresponding author
- Jung, Keeyoung
- Venue
- Oxidation of Metals
- Published
- 2010-09-05
- Volume
- 74
- Issue
- 5-6
- Pages
- 319-340
- ISSN
- 0030-770X (ISSN-L)
- 1573-4889
- OpenAlex
- W2082495205
- Cited by
- 204
- References
- 29
- Citations by year
- 2026: 6 · 2025: 16 · 2024: 15 · 2023: 17 · 2022: 18 · 2021: 14 · 2020: 16 · 2019: 14 · 2018: 11 · 2017: 13 · 2016: 12 · 2015: 13 · 2014: 15 · 2013: 13 · 2012: 8
- FWCI
- 15.08
- Type
- journal article
- Language
- en
- Open access
- green
- www.osti.gov
- Licence
- www.springer.com/tdm (tdm)
- Locations
- Oxidation of Metals (publishedVersion)
- OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) (submittedVersion)
- Funders
- National Energy Technology Laboratory
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
- Physical Sciences › Materials Science › Materials Chemistry › Nuclear Materials and Properties
- Physical Sciences › Materials Science › Materials Chemistry › Advancements in Solid Oxide Fuel Cells
- Keywords
- selective oxidation, ferritic-martensitic steel, Fe-Cr alloys, oxy-fuel combustion, chromia scale, Wagner model, chromium content, alloying elements, silicon, oxide scale formation, high-temperature oxidation
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
