The DOI matches its Crossref record.
Fireside Corrosion of Superheater Materials in Coal/Biomass Co-fired Advanced Power Plants
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
Among Pt-Ir aluminide coatings (Ir = 0, 32, 46, 83, 100 at%) on the nickel-base single crystal superalloy TMS-82+ exposed at 900 °C to Na2SO4 + 10% NaCl salt coatings, the Pt-46Ir coating had the lowest mass gain.
“The lowest mass gain was observed for the Pt-46Ir aluminide coating”
From Corrosion Problems in Incinerators and Biomass-Fuel-Fired Boilers (2014) · cites this paper as [116]
The Pt-46Ir aluminide coating formed a dense and continuous protective Al2O3 scale on the surface.
“which formed the dense and continuous protective Al 2 O 3”
From Corrosion Problems in Incinerators and Biomass-Fuel-Fired Boilers (2014) · cites this paper as [116]
Citations
Cites
Still being checked.
Research works printed but not linked: 17
- A. A. Khan, W. de Jong, P. J. Jansens and H. Spliethoff, Fuel Processing Technology 90, 21 (2009). · DOI
- J. Stringer and I. G. Wright, Oxidation of Metals 44, 265 (1995). · DOI · Paper page
- N. J. Simms, P. J. Kilgallon, and J. E. Oakey, Energy Materials: Material Science and Engineering for Energy System, 2 (2007). · DOI
- S. R. J. Saunders, in Guidelines for Methods of Testing and Research in High Temperature Corrosion, eds. H. J. Grabke and D. B. Meadowcroft (The Institute of Metals, London, 1995), p. 85.
- N. J. Simms and A. T. Fry, in Materials for Advanced Power Engineering, Proceedings, eds. J. Lecomte-Beckers and M. Carton (Forschungszentrum Jülich GmbH, 2010).
- A. U. Syed, N. J. Simms, and J. E. Oakey, “Fireside corrosion of superheaters: effects of air and oxy-firing of coal and biomass”, Fuel (in press).
- E. Raask, Mineral Impurities in Coal Combustion, (Hemisphere Publishing Corporation, Washington DC, 1985).
- K. Natesan, A. Purohit, and D. L. Rink. US Department of Energy Fossil Energy Conference (2003).
- N. J. Simms, in Power Plant Life Management and Performance Improvement, ed. J. E. Oakey (Woodhead Publishing, Cambridge, 2011), p. 145. · DOI · Paper page
- J. R. Nicholls, N. J. Simms, and A. Encinas-Oropesa, Mats at High Temperatures 24, 149 (2007). · DOI
- D. Young, High Temperature Oxidation and Corrosion of Metals, (Elsevier, Amsterdam, 2008).
- N. Birks, G. H. Meier, and F. S. Pettit, High-Temperature Oxidation of Metals, (Cambridge University, Cambridge, 2006). · DOI · Paper page
- A. U. Syed, “Fireside Corrosion Study of Superheater Materials in Advanced Power Plants”, PhD thesis.
- W. T. Reid, External Corrosion and deposits: Boilers and Gas Turbines, (Elsevier, New York, 1971).
- A. Hendry, Corrosion Science 20, 383 (1980). · DOI · Paper page
- C. Cain and W. Nelson, Transactions of the ASME, Journal of Engineering Power 83, 468 (1961). · DOI
- D. Lindberg, R. Backman, and P. Chartrand, Journal of Chemical Thermodynamics 39, 1001 (2007). · DOI
Cited by
Sorted by citations
Corrosion Problems in Incinerators and Biomass-Fuel-Fired Boilers
Mudgal, D., Singh, S., & Prakash, S. (2014) · International Journal of Corrosion · doi:10.1155/2014/505306 · Cited by 56
Impacts of Applied Stresses on High Temperature Corrosion Behavior of HR3C in Molten Salt
Fu, J., Li, N., Zhou, Q., & Guo, P. (2015) · Oxidation of Metals · doi:10.1007/s11085-014-9522-3 · Cited by 31
Fireside corrosion and deposition on heat exchangers in biomass combustion systems
Mori, S., Sanusi, T., Simms, N., & Sumner, J. (2023) · Materials at High Temperatures · doi:10.1080/09603409.2022.2138007 · Cited by 8
“The test lasted for a total of 1000 h, with samples cycled every 100 h, during which deposits were re-applied to the various samples using the ‘deposit recoat’ technique [25,26].”
MethodSelf-citationKong, Y., Ning, H., Huang, Y., Zhou, M., Zeng, G., Cheng, K., Shen, Y., Li, J., & Liu, Z. (2025) · Journal of Materials Research and Technology · doi:10.1016/j.jmrt.2025.10.111 · Cited by 4
Metadata
- Authors
- Hussain, T., Syed, A. U., & Simms, N. J.
- Affiliations
- Cranfield University (GB)
- Corresponding author
- Hussain, Tanvir
- Syed, Adnan U.
- Simms, Nigel J.
- Venue
- Oxidation of Metals
- Published
- 2013-03-15
- Volume
- 80
- Issue
- 5-6
- Pages
- 529-540
- ISSN
- 0030-770X (ISSN-L)
- 1573-4889
- OpenAlex
- W1969378209
- Cited by
- 38
- References
- 0
- Citations by year
- 2026: 3 · 2025: 4 · 2023: 2 · 2022: 5 · 2021: 4 · 2020: 3 · 2019: 3 · 2018: 2 · 2017: 5 · 2015: 2 · 2014: 3 · 2013: 2
- FWCI
- 3.75
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- www.springer.com/tdm (tdm)
- Locations
- Oxidation of Metals (publishedVersion)
- Funders
- Research Councils UK
- Tata Steel
- Engineering and Physical Sciences Research Council
- Economic and Social Research Council
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
- Physical Sciences › Engineering › Mechanical Engineering › High Temperature Alloys and Creep
- Physical Sciences › Materials Science › Materials Chemistry › Material Properties and Failure Mechanisms
- Keywords
- fireside corrosion, coal-biomass co-firing, T92 steel, HR3C steel, metal loss, high-temperature corrosion
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review