The DOI matches its Crossref record; 44 of the 44 references it cites were found in a registry or an index.
Air and PCM cooling for battery thermal management considering battery cycle life
Open accessAbstract
Abstract Cycle life of lithium-ion batteries (LIBs) is essential for the application of hybrid electric vehicles (HEV) and electric vehicles (EV). Since temperature greatly affects degradation rate and safety of LIBs, battery thermal management system (BTMS) is required. In this paper, the performance of active air cooling and passive phase change material (PCM) cooling for BTMS are assessed in terms of battery thermal states and cycle life. A coupled one-dimensional electrochemical and two-dimensional thermal models are developed to simulate the temperature of a battery module with 16 cylindrical (26650) graphite-LiFePO4 lithium-ion battery cells. The model is validated with the experimental data taken from literature. By applying a realistic current profile of a HEV to the battery model, simulations are performed at various ambient temperatures, inlet velocities of air cooling and PCM phase change temperatures. The battery cycle life and its non-uniformity across the module are estimated with a battery degradation model with inputs of battery temperature results. The study shows that active air cooling has a better cooling effect than PCM cooling, especially at high ambient temperatures. But the active air cooling leads to a large temperature non-uniformity at low inlet air velocities. The cycle life of the battery module under air cooling is longer than that of PCM cooling, although a larger life non-uniformity is observed. Furthermore, two methods are compared by a newly proposed evaluation index called cyclical cost. This index considers both the battery cycle life and the parasitic power consumption of the BTMS. The result demonstrates that air cooling has a lower cyclical cost than PCM cooling. When the inlet velocity of the air cooling system increases, the cyclical cost has a trend of decreasing first and then increasing. This paper provides a guide for the development of BTMS to further prolong the cycle life and reduce total operating cost of LIBs.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Modeling of Galvanostatic Charge and Discharge of the Lithium/Polymer/Insertion Cell
Doyle, M., Fuller, T. F., & Newman, J. (1993) · Journal of The Electrochemical Society · doi:10.1149/1.2221597 · Cited by 4,328 · cited 2×
“In this study, a one-dimensional electrochemical model developed by Doyle and Newman [22,23] is used to predict heat generation of LIBs.”
MethodThe lithium-ion battery: State of the art and future perspectives
Zubi, G., Dufo-López, R., Carvalho, M., & Pasaoglu, G. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2018.03.002 · Cited by 2,563
Thackeray, M. M., Wolverton, C., & Isaacs, E. D. (2012) · Energy & Environmental Science · doi:10.1039/c2ee21892e · Cited by 2,515
Simulation and Optimization of the Dual Lithium Ion Insertion Cell
Fuller, T. F., Doyle, M., & Newman, J. (1994) · Journal of The Electrochemical Society · doi:10.1149/1.2054684 · Cited by 2,057
Cycle-life model for graphite-LiFePO4 cells
Wang, J., Liu, P., Hicks-Garner, J., Sherman, E., Soukiazian, S., Verbrugge, M., Tataria, H., Musser, J., & Finamore, P. (2011) · Journal of Power Sources · doi:10.1016/j.jpowsour.2010.11.134 · Cited by 1,760
Review of solutions to global warming, air pollution, and energy security
Jacobson, M. Z. (2009) · Energy Environ. Sci. · doi:10.1039/b809990c · Cited by 1,760
A review on lithium-ion battery ageing mechanisms and estimations for automotive applications
Barré, A., Deguilhem, B., Grolleau, S., Gérard, M., Suard, F., & Riu, D. (2013) · Journal of Power Sources · doi:10.1016/j.jpowsour.2013.05.040 · Cited by 1,758
A Critical Review and Analysis on the Recycling of Spent Lithium-Ion Batteries
Lv, W., Wang, Z., Cao, H., Sun, Y., Zhang, Y., & Sun, Z. (2018) · ACS Sustainable Chemistry & Engineering · doi:10.1021/acssuschemeng.7b03811 · Cited by 1,163
Sabbah, R., Kizilel, R., Selman, J. R., & Al-Hallaj, S. (2008) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.03.082 · Cited by 680
Liu, W., Li, X., Xiong, D., Hao, Y., Li, J., Kou, H., Yan, B., Li, D., Lu, S., Koo, A., et al. (2017) · Nano Energy · doi:10.1016/j.nanoen.2017.11.010 · Cited by 677
Cited by
A review on recent progress, challenges and perspective of battery thermal management system
Lin, J., Liu, X., Li, S., Zhang, C., & Yang, S. (2021) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2020.120834 · Cited by 588
Zhao, G., Wang, X., Negnevitsky, M., & Li, C. (2023) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2022.119626 · Cited by 395
A review of thermal management for Li-ion batteries: Prospects, challenges, and issues
Shahjalal, M., Shams, T., Islam, M. E., Alam, W., Modak, M., Hossain, S. B., Ramadesigan, V., Ahmed, M. R., Ahmed, H., & Iqbal, A. (2021) · Journal of Energy Storage · doi:10.1016/j.est.2021.102518 · Cited by 303
Weng, J., Huang, Q., Li, X., Zhang, G., Ouyang, D., Chen, M., Yuen, A. C. Y., Li, A., Lee, E. W. M., Yang, W., et al. (2022) · Energy Storage Materials · doi:10.1016/j.ensm.2022.09.007 · Cited by 297
Thakur, A. K., Prabakaran, R., Elkadeem, M. R., Sharshir, S. W., Arıcı, M., Wang, C., Zhao, W., Hwang, J.-Y., & Saidur, R. (2020) · Journal of Energy Storage · doi:10.1016/j.est.2020.101771 · Cited by 287
Self-citation
Metadata
- Authors
- Chen, F., Huang, R., Wang, C., Yu, X., Liu, H., Wu, Q., Qian, K., & Bhagat, R.
- Venue
- Applied Thermal Engineering
- Publisher
- Elsevier BV
- Published
- 2020-06
- Volume
- 173
- Pages
- 115154
- ISSN
- 1359-4311 (ISSN-L)
- OpenAlex
- W3010240455
- Cited by
- 310
- References
- 44
- FWCI
- 14.23
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Air and PCM cooling for battery thermal management considering battery cycle life. https://app.cochat.ai/papers/10.1016/j.applthermaleng.2020.115154
- The paper
- Chen, F., Huang, R., Wang, C., Yu, X., Liu, H., Wu, Q., Qian, K., & Bhagat, R. (2020). Air and PCM cooling for battery thermal management considering battery cycle life. Applied Thermal Engineering. https://doi.org/10.1016/j.applthermaleng.2020.115154
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.