Electrochemical degradation of per- and poly-fluoroalkyl substances using boron-doped diamond electrodes
Open accessThe DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
Abstract
Electrochemical degradation using boron-doped diamond (BDD) electrodes has been proven to be a promising technique for the treatment of water contaminated with per- and poly-fluoroalkyl substances (PFAS). Various studies have demonstrated that the extent of PFAS degradation is influenced by the composition of samples and electrochemical conditions. This study evaluated the significance of several factors, such as the current density, initial concentration of PFAS, concentration of electrolyte, treatment time, and their interactions on the degradation of PFAS. A 24 factorial design was applied to determine the effects of the investigated factors on the degradation of perfluorooctanoic acid (PFOA) and generation of fluoride in spiked water. The best-performing conditions were then applied to the degradation of PFAS in wastewater samples. The results revealed that current density and time were the most important factors for PFOA degradation. In contrast, a high initial concentration of electrolyte had no significant impact on the degradation of PFOA, whereas it decreased the generation of F−. The experimental design model indicated that the treatment of spiked water under a current density higher than 14 mA cm−2 for 3–4 h could degrade PFOA with an efficiency of up to 100% and generate an F− fraction of approximately 40–50%. The observed high PFOA degradation and a low concentration of PFAS degradation products indicated that the mineralization of PFOA was effective. Under the obtained best conditions, the degradation of PFOA in wastewater samples was 44–70%. The degradation efficiency for other PFAS in these samples was 65–80% for perfluorooctane sulfonic acid (PFOS) and 42–52% for 6–2 fluorotelomer sulfonate (6-2 FTSA). The presence of high total organic carbon (TOC) and chloride contents was found to be an important factor affecting the efficiency of PFAS electrochemical degradation in wastewater samples. The current study indicates that the tested method can effectively degrade PFAS in both water and wastewater and suggests that increasing the treatment time is needed to account for the presence of other oxidizable matrices.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A first global production, emission, and environmental inventory for perfluorooctane sulfonate
Paul, A. G., Jones, K. C., & Sweetman, A. J. (2009) · Environmental Science & Technology · doi:10.1021/es802216n · Cited by 1,096
Li, F., Duan, J., Tian, S., Ji, H., Zhu, Y., Wei, Z., & Zhao, D. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2019.122506 · Cited by 707
Oxidative Conversion as a Means of Detecting Precursors to Perfluoroalkyl Acids in Urban Runoff
Houtz, E. F., & Sedlak, D. L. (2012) · Environmental Science & Technology · doi:10.1021/es302274g · Cited by 681
Degradation and Removal Methods for Perfluoroalkyl and Polyfluoroalkyl Substances in Water
Merino, N., Qu, Y., Deeb, R. A., Hawley, E. L., Hoffmann, M. R., & Mahendra, S. (2016) · Environmental Engineering Science · doi:10.1089/ees.2016.0233 · Cited by 349
Per- and polyfluorinated substances (PFASs): Environmental challenges
Krafft, M. P., & Riess, J. G. (2015) · Current Opinion in Colloid & Interface Science · doi:10.1016/j.cocis.2015.07.004 · Cited by 294
Multianalyte profiling of per- and polyfluoroalkyl substances (PFASs) in liquid commercial products
Favreau, P., Poncioni-Rothlisberger, C., Place, B. J., Bouchex-Bellomie, H., Weber, A., Tremp, J., Field, J. A., & Kohler, M. (2017) · Chemosphere · doi:10.1016/j.chemosphere.2016.11.127 · Cited by 116
Yang, X., Huang, J., Zhang, K., Yu, G., Deng, S., & Wang, B. (2014) · Environmental Science and Pollution Research · doi:10.1007/s11356-013-2389-z · Cited by 115
Cited by
Gar Alalm, M., & Boffito, D. C. (2022) · Chemical Engineering Journal · doi:10.1016/j.cej.2022.138352 · Cited by 288
O’Connor, J., Bolan, N. S., Kumar, M., Nitai, A. S., Ahmed, M. B., Bolan, S. S., Vithanage, M., Rinklebe, J., Mukhopadhyay, R., Srivastava, P., et al. (2022) · Process Safety and Environmental Protection · doi:10.1016/j.psep.2022.06.002 · Cited by 183
Veciana, M., Bräunig, J., Farhat, A., Pype, M.-L., Freguia, S., Carvalho, G., Keller, J., & Ledezma, P. (2022) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2022.128886 · Cited by 148
Lu, J., Lu, H., Liang, D., Feng, S., Li, Y., & Li, J. (2023) · Chemosphere · doi:10.1016/j.chemosphere.2023.138824 · Cited by 65
Ahmadi, M., Adeleye, O., Vonalt, G., & Nazemi, M. (2025) · Environmental Science & Technology · doi:10.1021/acs.est.5c04748 · Cited by 41
Metadata
- Authors
- Uwayezu, J. N., Carabante, I., Lejon, T., van Hees, P., Karlsson, P., Hollman, P., & Kumpiene, J.
- Venue
- Journal of Environmental Management
- Publisher
- Elsevier BV
- Published
- 2021-07
- Volume
- 290
- Pages
- 112573
- ISSN
- 0301-4797 (ISSN-L)
- OpenAlex
- W3156401553
- Cited by
- 122
- References
- 7
- FWCI
- 5.08
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Electrochemical degradation of per- and poly-fluoroalkyl substances using boron-doped diamond electrodes. https://app.cochat.ai/papers/10.1016/j.jenvman.2021.112573
- The paper
- Uwayezu, J. N., Carabante, I., Lejon, T., van Hees, P., Karlsson, P., Hollman, P., & Kumpiene, J. (2021). Electrochemical degradation of per- and poly-fluoroalkyl substances using boron-doped diamond electrodes. Journal of Environmental Management. https://doi.org/10.1016/j.jenvman.2021.112573
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.