Failure of trabecular bone with simulated lytic defects can be predicted non‐invasively by structural analysis
The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Abstract
Pathologic fracture is a significant risk for patients afflicted with metastatic or benign skeletal tumors. The quandary for physicians who treat these patients is that after making the diagnosis they must try to predict the load bearing capacity of the involved bone and the fracture risk from images seen in radiological examinations. Since bone fails at a relatively constant strain independent of density we demonstrate that using a mechanics of materials approach that the cross‐sectional structural properties of the bone most affected by the lytic defect governs the load bearing capacity of the entire bone. Homogeneous cylindrical cores of trabecular bone were harvested from the vertebral bodies of whale spines, and prepared with circular or slotted through‐hole defects of varying sizes to simulate lytic skeletal tumors. Each specimen was imaged using quantitative computed tomography (CT), dual energy X‐ray absorptiometry (DXA), and magnetic resonance imaging (MRI) to obtain data for calculating cross‐sectional structural properties: axial, flexural, and torsional rigidity. The specimens were then divided into groups uniformly distributed with respect to defect sizes and shapes, and subjected to uniaxial tension, four‐point bending or torsion until failure. A strong positive relationship was found between measured tensile yield loads, bending, and torsional yield moments vs. axial, flexural and torsional structural rigidities respectively, calculated from QCT, DXA, and MRI data [QCT: tension r2 = 0.951, bending r2 = 0.909, torsion r2 = 0.914 (p < 0.001); DXA: tension r2 = 0.926, bending r2 = 0.841, torsion r2 = 0.916 (p < 0.001), MRI: tension r2 = 0.916; bending r2 = 0.856, torsion r2 = 0.852 (p < 0.001)]. For cylindrical cores of trabecular bone with simulated lytic defects, the load bearing capacity of the entire core was directly proportional to the axial, bending, or torsional rigidity at the weakest cross‐section through the core containing the defect. Therefore structural rigidity analysis of cross‐sectional geometric data measured non‐invasively by QCT, DXA, and MRI of bones containing lytic defects may be used to predict the load bearing capacity of the involved bone and the relative fracture risk in vivo. © 2003 Orthopaedic Research Society. Published by Elsevier Ltd. All rights reserved.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The compressive behavior of bone as a two-phase porous structure
Carter, D., & Hayes, W. (1977) · The Journal of Bone & Joint Surgery · doi:10.2106/00004623-197759070-00021 · Cited by 2,001
Yield Behavior of Bovine Cancellous Bone
Turner, C. H. (1989) · Journal of Biomechanical Engineering · doi:10.1115/1.3168375 · Cited by 127
Uniaxial yield strains for bovine trabecular bone are isotropic and asymmetric
Chang, W. C. W., Christensen, T. M., Pinilla, T. P., & Keaveny, T. M. (1999) · Journal of Orthopaedic Research · doi:10.1002/jor.1100170418 · Cited by 77
Cited by
Bone Mechanical Properties in Healthy and Diseased States
Morgan, E. F., Unnikrisnan, G. U., & Hussein, A. I. (2018) · Annual Review of Biomedical Engineering · doi:10.1146/annurev-bioeng-062117-121139 · Cited by 1,026
“spatial variations in tissue mineral density and then use density–modulus relationships to avoid the assumption of a homogeneous modulus distribution (150).”
Bone mechanical properties and changes with osteoporosis
Osterhoff, G., Morgan, E. F., Shefelbine, S. J., Karim, L., McNamara, L. M., & Augat, P. (2016) · Injury · doi:10.1016/s0020-1383(16)47003-8 · Cited by 557
Nazarian, A., von Stechow, D., Zurakowski, D., Müller, R., & Snyder, B. D. (2008) · Calcified Tissue International · doi:10.1007/s00223-008-9174-x · Cited by 244
“The clinical implications of this work are important for developing noninvasive in vivo fracture risk predictions for bones affected by metastatic cancer, osteoporosis, or both using sequential, transaxial CT [4, 9, 75, 76] or magnetic resonance [77–79] images of the involved bones.”
BackgroundSelf-citationHussein, A. I., Jackman, T. M., Morgan, S. R., Barest, G. D., & Morgan, E. F. (2013) · Osteoporosis International · doi:10.1007/s00198-013-2417-3 · Cited by 39
“The minimum value of EA over all transverse cross sections (EAmin) was identified for each vertebra because the strength of the vertebra has been hypothesized to be correlated with this minimum value [30].”
Background
Metadata
- Authors
- Hong, J., Cabe, G. D., Tedrow, J. R., Hipp, J. A., & Snyder, B. D.
- Venue
- Journal of Orthopaedic Research
- Publisher
- Wiley
- Published
- 2004-05
- Volume
- 22
- Issue
- 3
- Pages
- 479-486
- ISSN
- 0736-0266 (ISSN-L)
- 1554-527X
- OpenAlex
- W2038484874
- Cited by
- 91
- References
- 3
- FWCI
- 3.41
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.