Evaluation of ASTER GDEM2, SRTMv3.0, ALOS AW3D30 and TanDEM-X DEMs for the Peruvian Andes against highly accurate GNSS ground control points and geomorphological-hydrological metrics
Open accessThe DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
Abstract
We present an analysis for Peru of the vertical accuracy and derived geomorphological parameters of three, freely available Digital Elevation Models (DEMs) with 30-m grid sizes and one commercially available 12-m DEM: ASTER GDEM2, SRTMv3.0 (hereafter called SRTM3), ALOS World 3D (AW3D30) and 12-m TanDEM-X. Their elevation values were compared against values measured with a dual-frequency Trimble 5800 Global Navigation Satellite Systems (GNSS) receiver with two antennas in static relative positioning. A total of 139 ground control points (GCPs) with elevations of up to 4334 m above sea level (asl). were obtained from four topographically contrasting regions along the flat, arid coast, the semi-dry Andes and the Amazon rainforest. The combined results of the four areas showed that the residuals of ASTER GDEM2 had a root mean square error (RMSE) of 6.907 m, SRTM3 5.113 m and AW3D30 6.246 m. For the two areas where TanDEM-X was investigated, a RMSE of 1.666 m was obtained. When considering each area individually, of the three 30-m DEMs, SRTM3 performed best in all areas, while ASTER GDEM2 was always performing worst. The standard deviation (SD) of the residuals of ASTER GDEM2 and AW3D30 varied much more between the four study areas than the SD of SRTM3 and TanDEM-X. It was possible to establish linear correlations with R2 > 0.95 between the GNSS-measured and DEM-derived elevation values for all areas and all DEMs, which can be used to correct ASTER GDEM2 and AW3D30 for Peru. No relationship was found between absolute elevation and residuals. Slope angle of >15°, however, correlated to much higher residuals for SRTM3 and AW3D30, whereas a constant increase in residual correlated to a constant increase in slope angle for TanDEM-X. In general, the highest residuals corresponded to the highest slope classes. A comparison of absolute elevation values and slope angles of selected areas between ASTER GDEM2 and SRTM3, as well as between AW3D30 and SRTM3, showed in all cases more deviation from true values in areas with steeper slopes. This effect seems independent of vegetation. The presence of buildings however, severely affected performance of ASTER GDEM2. For some areas, AW3D30 suffered from mismatch between adjacent scenes and horizontal and oblique stripping. An analysis of drainage networks showed that all three 30-m DEMs were capable of producing a similar number of Strahler orders, total number of channels, minimum and maximum channel length and accumulative channel length. All DEMs produced accurate networks in the upper reaches of the catchments, but suffered in flat areas such as wide fluvial valleys and sink-filled areas. ASTER GDEM2 in particular produced parallel river channels and unnatural short cuts. Our results agreed well with those of other studies elsewhere around the world and showed that i) the vertical error is much less than those officially reported for all DEMs; ii) slope is the most determinant factor in DEM accuracy. We conclude that SRTM3 delivers the most stable performance in almost all tests and is therefore the DEM of choice for landscape analysis in Peru. TanDEM-X 12 m performed very well in our elevation accuracy test and could become a worthy successor to SRTM3.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
An analysis of variance test for normality (complete samples)
SHAPIRO, S. S., & WILK, M. B. (1965) · Biometrika · doi:10.1093/biomet/52.3-4.591 · Cited by 23,480
Evaluation of vertical accuracy of open source Digital Elevation Model (DEM)
Mukherjee, S., Joshi, P. K., Mukherjee, S., Ghosh, A., Garg, R. D., & Mukhopadhyay, A. (2013) · International Journal of Applied Earth Observation and Geoinformation · doi:10.1016/j.jag.2012.09.004 · Cited by 394
Orographic barriers, high-resolution TRMM rainfall, and relief variations along the eastern Andes
Bookhagen, B., & Strecker, M. R. (2008) · Geophysical Research Letters · doi:10.1029/2007gl032011 · Cited by 355
Rexer, M., & Hirt, C. (2014) · Australian Journal of Earth Sciences · doi:10.1080/08120099.2014.884983 · Cited by 193
Validation of SRTM Elevations Over Vegetated and Non-vegetated Terrain Using Medium Footprint Lidar
Hofton, M., Dubayah, R., Blair, J. B., & Rabine, D. (2006) · Photogrammetric Engineering & Remote Sensing · doi:10.14358/pers.72.3.279 · Cited by 142
Accuracy validation and comparison of global digital elevation models over Croatia
Varga, M., & Bašić, T. (2015) · International Journal of Remote Sensing · doi:10.1080/01431161.2014.994720 · Cited by 78
Yap, L., Kandé, L. H., Nouayou, R., Kamguia, J., Ngouh, N. A., & Makuate, M. B. (2019) · International Journal of Digital Earth · doi:10.1080/17538947.2018.1458163 · Cited by 70
Cited by
Uuemaa, E., Ahi, S., Montibeller, B., Muru, M., & Kmoch, A. (2020) · Remote Sensing · doi:10.3390/rs12213482 · Cited by 289
Li, H., Zhao, J., Yan, B., Yue, L., & Wang, L. (2022) · International Journal of Digital Earth · doi:10.1080/17538947.2022.2094002 · Cited by 126
Novel Approach for Ranking DEMs: Copernicus DEM Improves One Arc Second Open Global Topography
Bielski, C., López-Vázquez, C., Grohmann, C. H., Guth, P. L., Hawker, L., Gesch, D., Trevisani, S., Herrera-Cruz, V., Riazanoff, S., Corseaux, A., et al. (2024) · IEEE Transactions on Geoscience and Remote Sensing · doi:10.1109/tgrs.2024.3368015 · Cited by 85
Accuracy Assessment of the Global TanDEM-X Digital Elevation Model in a Mountain Environment
Gdulová, K., Marešová, J., & Moudrý, V. (2020) · Remote Sensing of Environment · doi:10.1016/j.rse.2020.111724 · Cited by 64
Li, J., Zhao, Y., Bates, P., Neal, J., Tooth, S., Hawker, L., & Maffei, C. (2020) · Journal of Hydrology · doi:10.1016/j.jhydrol.2020.125617 · Cited by 29
Metadata
- Authors
- González-Moradas, M. D. R., & Viveen, W.
- Venue
- Remote Sensing of Environment
- Publisher
- Elsevier BV
- Published
- 2020-02
- Volume
- 237
- Pages
- 111509
- ISSN
- 0034-4257 (ISSN-L)
- OpenAlex
- W2990251052
- Cited by
- 118
- References
- 7
- FWCI
- 9.78
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Evaluation of ASTER GDEM2, SRTMv3.0, ALOS AW3D30 and TanDEM-X DEMs for the Peruvian Andes against highly accurate GNSS ground control points and geomorphological-hydrological metrics. https://app.cochat.ai/papers/10.1016/j.rse.2019.111509
- The paper
- González-Moradas, M. D. R., & Viveen, W. (2020). Evaluation of ASTER GDEM2, SRTMv3.0, ALOS AW3D30 and TanDEM-X DEMs for the Peruvian Andes against highly accurate GNSS ground control points and geomorphological-hydrological metrics. Remote Sensing of Environment. https://doi.org/10.1016/j.rse.2019.111509
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.