The DOI matches its Crossref record; 11 of the 11 references it cites were found in a registry or an index.
Effect of Dispersion Solvent in Catalyst Ink on Proton Exchange Membrane Fuel Cell Performance
Open accessAbstract
The effects of dispersion solvents in catalyst ink on performance of the membrane electrode assembly (MEA) for proton exchange membrane fuel cell are studied. Dispersion solvents under examination are water, ethylene glycol, glycerin, propylene glycols, and methanol. These solvents cover a wide range property of dielectric constant, boiling points, and viscosity. We examine the rheology behaviors of catalyst ink prepared with these solvents. Both anode and cathode of the MEA are made by using doctor-blade method to spread catalyst ink onto the gas diffusion layers. The single cell with prepared MEA is measured by linear scanning voltammetry to evaluate the discharge characteristics, by cyclic voltammetry to evaluate catalyst utilization, and electrochemical impedance spectroscopy to evaluate internal resistance. A semi-empirical equation is use to analyze the voltage losses due to activation over-potential and internal resistance. We find that ethylene glycol was the best dispersion agent among organic solvents tested. The power density of the single cell is able to reach the maximum power density of 1,428 mA (mg Pt)-1 at hot-pressed temperature of 135 °C, and 1200psi for 90 seconds.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“If adding a small amount of ionomer in the catalyst ink, i.e., a low I/C ratio, the ionomer molecules adsorb on the catalyst agglomerates, enhancing the columbic repulsion force and steric hindrance of inter-agglomerates [42,53,74], inhibiting aggregation, to some extent similar to a stabilizing agent, decreasing the agglomerate size, and thus improving the colloidal stability [53,54].”
From Effect of Catalyst Ink and Formation Process on the Multiscale Structure of Catalyst Layers in PEM Fuel Cells (2022) · cites this paper as [42]
In the citing paper
“Fast evaporation could also lead to surface cracking in the dried CLs [42].”
From Effect of Catalyst Ink and Formation Process on the Multiscale Structure of Catalyst Layers in PEM Fuel Cells (2022) · cites this paper as [42]
In the citing paper
“The solvent viscosity has an effect on the ink viscosity and stability, coating process, and drying process [42,126].”
From Effect of Catalyst Ink and Formation Process on the Multiscale Structure of Catalyst Layers in PEM Fuel Cells (2022) · cites this paper as [42]
In the citing paper
“The ink containing a viscous solvent is commonly more stable than that containing a thin solvent due to the decreased Brownian motion of agglomerates and thus decreasing their collision chance [42].”
From Effect of Catalyst Ink and Formation Process on the Multiscale Structure of Catalyst Layers in PEM Fuel Cells (2022) · cites this paper as [42]
In the citing paper
“(i) Extremely quick evaporation of the solvent: Too fast solvent vaporization rate, e.g., the solvent with low boiling point, easily causes much difference in the drying speed between the surface and interior, resulting in the increased drying stress and then cracking in the dried CL [42,66].”
From Effect of Catalyst Ink and Formation Process on the Multiscale Structure of Catalyst Layers in PEM Fuel Cells (2022) · cites this paper as [42]
Citations
Cites
Perry, J. H. (1950) · Journal of Chemical Education · doi:10.1021/ed027p533.1 · Cited by 3,807
Review and analysis of PEM fuel cell design and manufacturing
Mehta, V., & Cooper, J. S. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00542-6 · Cited by 1,685
Litster, S., & McLean, G. (2004) · Journal of Power Sources · doi:10.1016/j.jpowsour.2003.12.055 · Cited by 1,275
Thin-film catalyst layers for polymer electrolyte fuel cell electrodes
Wilson, M. S., & Gottesfeld, S. (1992) · Journal of Applied Electrochemistry · doi:10.1007/bf01093004 · Cited by 871
Methods to Advance Technology of Proton Exchange Membrane Fuel Cells
Ticianelli, E. A., Derouin, C. R., Redondo, A., & Srinivasan, S. (1988) · Journal of The Electrochemical Society · doi:10.1149/1.2096240 · Cited by 561
Wilson, M. S., Valerio, J. A., & Gottesfeld, S. (1995) · Electrochimica Acta · doi:10.1016/0013-4686(94)00272-3 · Cited by 476
Shin, S.-J., Lee, J.-K., Ha, H.-Y., Hong, S.-A., Chun, H.-S., & Oh, I.-H. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(01)01045-x · Cited by 205
Uchida, M., Fukuoka, Y., Sugawara, Y., Ohara, H., & Ohta, A. (1998) · Journal of The Electrochemical Society · doi:10.1149/1.1838863 · Cited by 191
Fernández, R., Ferreira-Aparicio, P., & Daza, L. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2005.02.048 · Cited by 120
Performance of a polymer electrolyte membrane fuel cell with thin film catalyst electrodes
Chun, Y.-G., Kim, C.-S., Peck, D., & Shin, D.-R. (1998) · Journal of Power Sources · doi:10.1016/s0378-7753(97)02792-4 · Cited by 120
Cited by
Ngo, T. T., Yu, T. L., & Lin, H.-L. (2013) · Journal of Power Sources · doi:10.1016/j.jpowsour.2012.10.055 · Cited by 231
The Controllable Design of Catalyst Inks to Enhance PEMFC Performance: A Review
Guo, Y., Pan, F., Chen, W., Ding, Z., Yang, D., Li, B., Ming, P., & Zhang, C. (2021) · Electrochemical Energy Reviews · doi:10.1007/s41918-020-00083-2 · Cited by 175
Ink solvent dependence of the ionomer distribution in the catalyst layer of a PEMFC
Orfanidi, A., Rheinländer, P. J., Schulte, N., & Gasteiger, H. A. (2018) · Journal of The Electrochemical Society · doi:10.1149/2.1251814jes · Cited by 169
Rheological Investigation on the Microstructure of Fuel Cell Catalyst Inks
Khandavalli, S., Park, J. H., Kariuki, N. N., Myers, D. J., Stickel, J. J., Hurst, K., Neyerlin, K. C., Ulsh, M., & Mauger, S. A. (2018) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.8b15039 · Cited by 153
Takahashi, S., Mashio, T., Horibe, N., Akizuki, K., & Ohma, A. (2015) · ChemElectroChem · doi:10.1002/celc.201500131 · Cited by 143
Metadata
- Authors
- Huang, D.-C., Yu, P.-J., Liu, F.-J., Huang, S.-L., Hsueh, K.-L., Chen, Y.-C., Wu, C.-H., Chang, W.-C., & Tsau, F.-H.
- Affiliations
- National United University (TW)
- Industrial Technology Research Institute (TW)
- Corresponding author
- Hsueh, Kan-Lin
- Venue
- International Journal of Electrochemical Science
- Publisher
- Elsevier BV
- Published
- 2011-07
- Volume
- 6
- Issue
- 7
- Pages
- 2551-2565
- ISSN
- 1452-3981 (ISSN-L)
- OpenAlex
- W4382398352
- Cited by
- 93
- References
- 11
- Citations by year
- 2026: 3 · 2025: 11 · 2024: 11 · 2023: 7 · 2022: 7 · 2021: 18 · 2020: 5 · 2019: 8 · 2018: 8 · 2017: 1 · 2016: 2 · 2015: 2 · 2013: 2 · 2012: 6
- FWCI
- 2.24
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- cc-by-nc-nd
- www.elsevier.com/tdm/userlicense/1.0/ (tdm)
- www.elsevier.com/legal/tdmrep-license (tdm)
- creativecommons.org/licenses/by-nc-nd/4.0/ (vor, 4379 d)
- Locations
- International Journal of Electrochemical Science (publishedVersion, cc-by-nc-nd)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion)
- Funders
- Ministry of Economic Affairs
- Bureau of Energy, Ministry of Economic Affairs, Republic of Taiwan
- Industrial Technology Research Institute
- United Nations University
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Fuel Cells and Related Materials
- Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
- Physical Sciences › Materials Science › Materials Chemistry › Advancements in Solid Oxide Fuel Cells
- Keywords
- proton exchange membrane fuel cells, catalyst ink, membrane electrode assembly, ethylene glycol, glycerol, propylene glycol, methanol, rheology, catalyst utilization, internal resistance, activation overpotential, power density, platinum catalysts
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of Dispersion Solvent in Catalyst Ink on Proton Exchange Membrane Fuel Cell Performance. https://app.cochat.ai/papers/10.1016/s1452-3981(23)18202-2
- The paper
- Huang, D.-C., Yu, P.-J., Liu, F.-J., Huang, S.-L., Hsueh, K.-L., Chen, Y.-C., Wu, C.-H., Chang, W.-C., & Tsau, F.-H. (2011). Effect of Dispersion Solvent in Catalyst Ink on Proton Exchange Membrane Fuel Cell Performance. International Journal of Electrochemical Science. https://doi.org/10.1016/s1452-3981(23)18202-2
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.