Review on Reactor Configurations for Adsorption-Based CO 2 Capture
Open accessThe DOI matches its Crossref record; 112 of the 115 references it cites were found in a registry or an index.
Abstract
Adsorption-based CO2 capture has enjoyed considerable research attention in recent years. Most of the research efforts focused on sorbent development to reduce the energy penalty. However, the use of suitable gas–solid contacting systems is key for extracting the full potential from the sorbent to minimize operating and capital costs and accelerate the commercial deployment of the technology. This paper reviews several reactor configurations that were proposed for adsorption-based CO2 capture. The fundamental behavior of adsorption in different gas–solid contactors (fixed, fluidized, moving, or rotating beds) and regeneration under different modes (pressure, temperature, or combined swings) is discussed, highlighting the strengths and limitations of different combinations of gas–solid contactor and regeneration mode. In addition, the estimated energy duties in published studies and current technology readiness level of the different reactor configurations are reported. Other aspects, such as the reactor footprint, the operation strategy, suitability to retrofits, and the ability to operate under flexible loads are also discussed. In terms of future work, the key research need is a standardized techno-economic benchmarking study to calculate CO2 avoidance costs for different adsorption technologies under standardized assumptions. Qualitatively, each technology presents several strengths and weaknesses that make it impossible to identify a clear optimal solution. Such a standardized quantitative comparison is therefore needed to focus on future technology development efforts.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“It has been shown, in fact, that alternative microstructures can offer much lower pressure drops [49].”
From Topology optimisation of adsorption beds for cost-effective direct air capture (2026) · cites this paper as [49]
Citations
Cites
Carbon capture and storage (CCS): the way forward
Bui, M., Adjiman, C. S., Bardow, A., Anthony, E. J., Boston, A., Brown, S., Fennell, P. S., Fuss, S., Galindo, A., Hackett, L. A., et al. (2018) · Energy & Environmental Science · doi:10.1039/c7ee02342a · Cited by 4,374
Principles of adsorption and adsorption processes
Kast, W. (1985) · Chemical Engineering and Processing: Process Intensification · doi:10.1016/0255-2701(85)80013-1 · Cited by 2,430
Post-Combustion CO 2 Capture Using Solid Sorbents: A Review
Samanta, A., Zhao, A., Shimizu, G. K. H., Sarkar, P., & Gupta, R. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie200686q · Cited by 1,889
CO2 capture by solid adsorbents and their applications: current status and new trends
Wang, Q., Luo, J., Zhong, Z., & Borgna, A. (2011) · Energy Environ. Sci. · doi:10.1039/c0ee00064g · Cited by 1,611
Abanades, J. C., Arias, B., Lyngfelt, A., Mattisson, T., Wiley, D. E., Li, H., Ho, M. T., Mangano, E., & Brandani, S. (2015) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2015.04.018 · Cited by 441
Alkali and alkaline-earth cation exchanged chabazite zeolites for adsorption based CO2 capture
Zhang, J., Singh, R., & Webley, P. A. (2008) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2007.08.022 · Cited by 313
Structured adsorbents in gas separation processes
Rezaei, F., & Webley, P. (2010) · Separation and Purification Technology · doi:10.1016/j.seppur.2009.10.004 · Cited by 294
CO2 capture from dry flue gas by vacuum swing adsorption: A pilot plant study
Krishnamurthy, S., Rao, V. R., Guntuka, S., Sharratt, P., Haghpanah, R., Rajendran, A., Amanullah, M., Karimi, I. A., & Farooq, S. (2014) · AIChE Journal · doi:10.1002/aic.14435 · Cited by 282
Wurzbacher, J. A., Gebald, C., & Steinfeld, A. (2011) · Energy & Environmental Science · doi:10.1039/c1ee01681d · Cited by 252
Post combustion CO2 capture by carbon fibre monolithic adsorbents
Thiruvenkatachari, R., Su, S., An, H., & Yu, X. X. (2009) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2009.05.003 · Cited by 251
Research works printed but not linked: 6
- 2014, Climate change mitigation: Summary for Policymakers
- 10.1016/j.ijggc.2015.04.018 · DOI · Paper page
- Treybal, R. E. Mass-transfer operations . 3rd ed. McGraw-Hill Book Company, 1980; p 800.
- Berg C., 1946, Trans. AIChE, 665
- 10.1007/s10450-014-9603-2 · DOI · Paper page
- 10.1016/j.cej.2018.10.082 · DOI
Cited by
Dziejarski, B., Krzyżyńska, R., & Andersson, K. (2023) · Fuel · doi:10.1016/j.fuel.2023.127776 · Cited by 628
Adsorption of Carbon Dioxide for post-combustion capture: a review
Raganati, F., Miccio, F., & Ammendola, P. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.1c01618 · Cited by 661
Recent advances in direct air capture by adsorption
Zhu, X., Xie, W., Wu, J., Miao, Y., Xiang, C., Chen, C., Ge, B., Gan, Z., Yang, F., Zhang, M., et al. (2022) · Chemical Society Reviews · doi:10.1039/d1cs00970b · Cited by 456
CO2 Post-combustion Capture: A Critical Review of Current Technologies and Future Directions
Raganati, F., & Ammendola, P. (2024) · Energy & Fuels · doi:10.1021/acs.energyfuels.4c02513 · Cited by 296
Gunawardene, O. H. P., Gunathilake, C. A., Vikrant, K., & Amaraweera, S. M. (2022) · Atmosphere · doi:10.3390/atmos13030397 · Cited by 249
Metadata
- Authors
- Dhoke, C., Zaabout, A., Cloete, S., & Amini, S.
- Affiliations
- Norwegian University of Science and Technology (NO)
- SINTEF Industry (NO)
- University of Alabama (US)
- Corresponding author
- Zaabout, Abdelghafour
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2021-03-05
- Volume
- 60
- Issue
- 10
- Pages
- 3779-3798
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W3133859536
- Cited by
- 240
- References
- 115
- Citations by year
- 2026: 53 · 2025: 51 · 2024: 50 · 2023: 46 · 2022: 30 · 2021: 10
- FWCI
- 14.53
- Type
- journal article
- Language
- en
- Open access
- hybrid
- doi.org
- Locations
- Industrial & Engineering Chemistry Research (publishedVersion, cc-by)
- NORA - Norwegian Open Research Archives (submittedVersion, cc-by)
- Funders
- Norges Forskningsr?d (268507/E20)
- Topics
- Physical Sciences › Chemical Engineering › Filtration and Separation › Carbon Dioxide Capture Technologies
- Physical Sciences › Engineering › Computational Mechanics › Granular flow and fluidized beds
- Physical Sciences › Environmental Science › Environmental Engineering › Industrial Gas Emission Control
- Keywords
- CO2 capture, reactor configuration, fixed bed, fluidized bed, movable bed, adsorbent regeneration, pressure swing adsorption, temperature swing adsorption, technology readiness level, retrofitting, CO2 avoidance cost
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Review on Reactor Configurations for Adsorption-Based CO 2 Capture. https://app.cochat.ai/papers/10.1021/acs.iecr.0c04547
- The paper
- Dhoke, C., Zaabout, A., Cloete, S., & Amini, S. (2021). Review on Reactor Configurations for Adsorption-Based CO 2 Capture. Industrial & Engineering Chemistry Research. https://doi.org/10.1021/acs.iecr.0c04547
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.