Investigation of the Microstructure and Rheology of Iridium Oxide Catalyst Inks for Low-Temperature Polymer Electrolyte Membrane Water Electrolyzers
Open accessThe DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Abstract
We present an investigation of the structure and rheological behavior of catalyst inks for low-temperature polymer electrolyte membrane water electrolyzers. The ink consists of iridium oxide (IrO 2 ) catalyst particles and a Nafion ionomer dispersed in a mixture of 1-propanol and water. The effects of ionomer concentration and catalyst concentration on the microstructure of the catalyst ink were studied. Studies on dilute inks (0.1 wt % IrO 2 ) using zeta potential and dynamic light scattering measurements indicated a strong adsorption of the ionomer onto the catalyst particles which resulted in an increase in the ζ-potential and the z -average diameter. Steady-shear and dynamic-oscillatory-shear rheological measurements of concentrated IrO 2 dispersions (35 wt % IrO 2 ) indicated that the particles are strongly agglomerated in the absence of the ionomer. The addition of even a small amount of the ionomer (2.4 wt % with respect to total solids) caused the rheology to transition from shear thinning to Newtonian because of the reduction in agglomerated structure due to stabilization of the aggregates by the ionomer, consistent with the behavior of dilute inks. At intermediate ionomer loadings, between 2.4 and 9 wt %, the viscosity increased with increasing ionomer wt %, though remained Newtonian, predominantly due to the increasing ionomer volume fraction in the ink. For ionomer loadings greater than 9 wt %, the particles were found to be flocculated, likely induced by a dispersed ionomer. The flocculated inks exhibited strong shear-thinning and gel-like behaviors in steady-shear and oscillatory-shear rheology. The onset of flocculation was found to be sensitive to the catalyst concentration, where below 35 wt % of IrO 2, flocculation was not observed. The rheological observations were further verified by ultra-small-angle X-ray scattering.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fuel Cell Catalyst Layers: A Polymer Science Perspective
Holdcroft, S. (2014) · Chemistry of Materials · doi:10.1021/cm401445h · Cited by 481
Wang, M., Park, J. H., Kabir, S., Neyerlin, K. C., Kariuki, N. N., Lv, H., Stamenkovic, V. R., Myers, D. J., Ulsh, M., & Mauger, S. A. (2019) · ACS Applied Energy Materials · doi:10.1021/acsaem.9b01037 · Cited by 192
Self-citationRheological Investigation on the Microstructure of Fuel Cell Catalyst Inks
Khandavalli, S., Park, J. H., Kariuki, N. N., Myers, D. J., Stickel, J. J., Hurst, K., Neyerlin, K. C., Ulsh, M., & Mauger, S. A. (2018) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.8b15039 · Cited by 153
Self-citationShukla, S., Bhattacharjee, S., Weber, A. Z., & Secanell, M. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.0961706jes · Cited by 137
Inherent Acidity of Perfluorosulfonic Acid Ionomer Dispersions and Implications for Ink Aggregation
Berlinger, S. A., McCloskey, B. D., & Weber, A. Z. (2018) · The Journal of Physical Chemistry B · doi:10.1021/acs.jpcb.8b06493 · Cited by 122
Understanding inks for porous-electrode formation
Hatzell, K. B., Dixit, M. B., Berlinger, S. A., & Weber, A. Z. (2017) · J. Mater. Chem. A · doi:10.1039/c7ta07255d · Cited by 97
Dispersion of Rod-like Particles of Nafion in Salt-Free Water/1-Propanol and Water/Ethanol Solutions
Yamaguchi, M., Matsunaga, T., Amemiya, K., Ohira, A., Hasegawa, N., Shinohara, K., Ando, M., & Yoshida, T. (2014) · The Journal of Physical Chemistry B · doi:10.1021/jp506814m · Cited by 81
Gravure coating for roll-to-roll manufacturing of proton-exchange-membrane fuel cell catalyst layers
Mauger, S. A., Neyerlin, K. C., Yang-Neyerlin, A. C., More, K. L., & Ulsh, M. (2018) · Journal of The Electrochemical Society · doi:10.1149/2.0091813jes · Cited by 81
Self-citation
Cited by
The Controllable Design of Catalyst Inks to Enhance PEMFC Performance: A Review
Guo, Y., Pan, F., Chen, W., Ding, Z., Yang, D., Li, B., Ming, P., & Zhang, C. (2021) · Electrochemical Energy Reviews · doi:10.1007/s41918-020-00083-2 · Cited by 175
Roll-to-roll production of catalyst coated membranes for low-temperature electrolyzers
Park, J., Kang, Z., Bender, G., Ulsh, M., & Mauger, S. A. (2020) · Journal of Power Sources · doi:10.1016/j.jpowsour.2020.228819 · Cited by 115
Self-citationDu, S., Li, W., Wu, H., Abel Chuang, P.-Y., Pan, M., & Sui, P.-C. (2020) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2020.07.241 · Cited by 88
Guo, Y., Yang, D., Li, B., Yang, D., Ming, P., & Zhang, C. (2021) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.1c07070 · Cited by 65
Metadata
- Authors
- Khandavalli, S., Park, J. H., Kariuki, N. N., Zaccarine, S. F., Pylypenko, S., Myers, D. J., Ulsh, M., & Mauger, S. A.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2019-11-07
- Volume
- 11
- Issue
- 48
- Pages
- 45068-45079
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2985290359
- Cited by
- 74
- References
- 8
- FWCI
- 1.32
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Investigation of the Microstructure and Rheology of Iridium Oxide Catalyst Inks for Low-Temperature Polymer Electrolyte Membrane Water Electrolyzers. https://app.cochat.ai/papers/10.1021/acsami.9b14415
- The paper
- Khandavalli, S., Park, J. H., Kariuki, N. N., Zaccarine, S. F., Pylypenko, S., Myers, D. J., Ulsh, M., & Mauger, S. A. (2019). Investigation of the Microstructure and Rheology of Iridium Oxide Catalyst Inks for Low-Temperature Polymer Electrolyte Membrane Water Electrolyzers. ACS Applied Materials & Interfaces. https://doi.org/10.1021/acsami.9b14415
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.