The DOI matches its Crossref record.
Conformal Coating on Ultrahigh-Aspect-Ratio Nanopores of Anodic Alumina by Atomic Layer Deposition
Abstract
Anodic alumina (AA) membranes are composed of highly uniform, nanometer-scale pores arranged in a hexagonal close-packed array. Depositing conformal films inside the nanopores is extremely difficult because the nanopores have an ultrahigh aspect ratio of L / d ≈ 10 3 . Atomic layer deposition (ALD) is a thin film growth technique that can deposit highly uniform films on high-aspect-ratio substrates with monolayer thickness control. In this study, AA membranes were coated with Al 2 O 3 and ZnO ALD films and subsequently analyzed using cross-sectional scanning electron microscopy (SEM) and electron probe microanalysis (EPMA). SEM analysis of individual nanopores revealed that the AA membranes with nanopore diameters of d = 65 nm and lengths of L = 50 μm could be coated conformally by Al 2 O 3 ALD using sufficient reactant exposure times. Zn concentration profiles measured by EPMA following ZnO ALD showed the progressive infiltration of the ZnO ALD into the nanopores with increasing exposure times for aspect ratios as high as L / d ∼5000. Monte Carlo simulation of the experimental results assuming Knudsen diffusion accurately reproduced the experimental Zn concentration profiles and predicted the minimum ALD reactant exposures necessary to achieve conformal films. The Monte Carlo simulation also predicted that the diffusion-limited deposition will become reaction-limited given a sufficiently low ALD reaction probability. To test this idea, Fourier transform infrared absorption measurements were performed during the coating of the AA membranes by Al 2 O 3 and SiO 2 ALD. The surface reactions during Al 2 O 3 ALD have a relatively high reaction probability of ∼10 - 3 . In contrast, the surface reactions during SiO 2 ALD have a very low reaction probability of ∼10 - 8 . In agreement with the predictions, diffusion-limited behavior with a t 1/2 time dependence was observed during Al 2 O 3 ALD. Reaction-limited behavior with a t 1 time dependence was observed during SiO 2 ALD.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Atomic layer deposition of a MoS2film
Tan, L. K., Liu, B., Teng, J. H., Guo, S., Low, H. Y., & Loh, K. P. (2014) · Nanoscale · doi:10.1039/c4nr02451f · Cited by 409
Tailoring nanoporous materials by atomic layer deposition
Detavernier, C., Dendooven, J., Pulinthanathu Sree, S., Ludwig, K. F., & Martens, J. A. (2011) · Chemical Society Reviews · doi:10.1039/c1cs15091j · Cited by 386
X-ray ptychographic computed tomography at 16 nm isotropic 3D resolution
Holler, M., Diaz, A., Guizar-Sicairos, M., Karvinen, P., Färm, E., Härkönen, E., Ritala, M., Menzel, A., Raabe, J., & Bunk, O. (2014) · Scientific Reports · doi:10.1038/srep03857 · Cited by 357
Goldstein, D. N., McCormick, J. A., & George, S. M. (2008) · The Journal of Physical Chemistry C · doi:10.1021/jp804296a · Cited by 330
Self-citationOnn, T., Küngas, R., Fornasiero, P., Huang, K., & Gorte, R. (2018) · Inorganics · doi:10.3390/inorganics6010034 · Cited by 111
Metadata
- Authors
- Elam, J. W., Routkevitch, D., Mardilovich, P. P., & George, S. M.
- Venue
- Chemistry of Materials
- Publisher
- American Chemical Society (ACS)
- Published
- 2003-08-14
- Volume
- 15
- Issue
- 18
- Pages
- 3507-3517
- ISSN
- 0897-4756 (ISSN-L)
- 1520-5002
- OpenAlex
- W1984962131
- Cited by
- 623
- References
- 0
- FWCI
- 6.36
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Conformal Coating on Ultrahigh-Aspect-Ratio Nanopores of Anodic Alumina by Atomic Layer Deposition. https://app.cochat.ai/papers/10.1021/cm0303080
- The paper
- Elam, J. W., Routkevitch, D., Mardilovich, P. P., & George, S. M. (2003). Conformal Coating on Ultrahigh-Aspect-Ratio Nanopores of Anodic Alumina by Atomic Layer Deposition. Chemistry of Materials. https://doi.org/10.1021/cm0303080
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.