The DOI matches its Crossref record.
Biochar as a Fuel: 1. Properties and Grindability of Biochars Produced from the Pyrolysis of Mallee Wood under Slow-Heating Conditions
Abstract
Biomass as a fuel suffers from its bulky, fibrous, high moisture content and low-energy-density nature, leading to key issues including high transport cost and poor biomass grindability. This study investigates the possibility to pretreat biomass to produce biochar as a solid biofuel to address these issues. Biochars were produced from the pyrolysis of centimeter-sized particles of Western Australia (WA) mallee wood in a fixed-bed reactor at 300 to 500 °C and a heating rate of 10 °C/min. The data show that, at pyrolysis temperatures ≥320 °C, biochar as a fuel has similar fuel H/C and O/C ratios compared to Collie coal that is the only coal being mined in WA. Converting biomass to biochar leads to a substantial increase in fuel mass energy density from ∼10 GJ/ton of green biomass to ∼28 GJ/ton of biochars prepared from pyrolysis at 320 °C, in comparison to 26 GJ/ton for Collie coal. However, there is little improvement in fuel volumetric energy density, which is around 7−9 GJ/m 3 in comparison to 17 GJ/m 3 of Collie coal. Biochars are still bulky and grinding is required for volumetric energy densification. Biochar grindability experiments show that the fuel grindability increases drastically even at pyrolysis temperature as low as 300 °C. Further increase in pyrolysis temperature to 500 °C leads to only a small increase in biochar grindability. Under the grinding conditions, a significant size reduction (34−66% cumulative volumetric size below 75 μm) for biochars can be achieved after 4 minutes grinding (in comparison to only 19% for biomass after 15 minutes grinding), leading to a significant increase in volumetric energy density (e.g., from ∼8 to 19 GJ/m 3 for biochar prepared from pyrolysis at 400 °C). Whereas grinding raw biomass typically results in large and fibrous particles, grinding biochars produces short and round particles. The results in this article indicate that biochar has desired fuel properties and potentially a good solution to address the key issues including high transport cost and poor grindability associated with the direct use of biomass as a fuel.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Weber, K., & Quicker, P. (2018) · Fuel · doi:10.1016/j.fuel.2017.12.054 · Cited by 1,522
Review of the stability of biochar in soils: predictability of O:C molar ratios
Spokas, K. A. (2010) · Carbon Management · doi:10.4155/cmt.10.32 · Cited by 1,160
Joseph, S., Cowie, A. L., Van Zwieten, L., Bolan, N., Budai, A., Buss, W., Cayuela, M. L., Graber, E. R., Ippolito, J. A., Kuzyakov, Y., et al. (2021) · GCB Bioenergy · doi:10.1111/gcbb.12885 · Cited by 1,090
Biochar: A synthesis of its agronomic impact beyond carbon sequestration
Spokas, K. A., Cantrell, K. B., Novak, J. M., Archer, D. W., Ippolito, J. A., Collins, H. P., Boateng, A. A., Lima, I. M., Lamb, M. C., McAloon, A. J., et al. (2012) · Journal of Environmental Quality · doi:10.2134/jeq2011.0069 · Cited by 1,014
Kim, K. H., Kim, J.-Y., Cho, T.-S., & Choi, J. W. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.04.094 · Cited by 696
Past, present, and future of biochar
Chen, W., Meng, J., Han, X., Lan, Y., & Zhang, W. (2019) · Biochar · doi:10.1007/s42773-019-00008-3 · Cited by 552
Characteristics and applications of biochar for environmental remediation: a review
Xie, T., Reddy, K. R., Wang, C., Yargicoglu, E., & Spokas, K. (2015) · Critical Reviews in Environmental Science and Technology · doi:10.1080/10643389.2014.924180 · Cited by 527
Ghodake, G. S., Shinde, S. K., Kadam, A. A., Saratale, R. G., Saratale, G. D., Kumar, M., Palem, R. R., AL-Shwaiman, H. A., Elgorban, A. M., Syed, A., et al. (2021) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2021.126645 · Cited by 414
Engineered biochar – A sustainable solution for the removal of antibiotics from water
Krasucka, P., Pan, B., Sik Ok, Y., Mohan, D., Sarkar, B., & Oleszczuk, P. (2021) · Chemical Engineering Journal · doi:10.1016/j.cej.2020.126926 · Cited by 401
Wannapeera, J., Fungtammasan, B., & Worasuwannarak, N. (2011) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2011.04.010 · Cited by 348
Advances and future directions of biochar characterization methods and applications
Igalavithana, A. D., Mandal, S., Niazi, N. K., Vithanage, M., Parikh, S. J., Mukome, F. N. D., Rizwan, M., Oleszczuk, P., Al-Wabel, M., Bolan, N., et al. (2017) · Critical Reviews in Environmental Science and Technology · doi:10.1080/10643389.2017.1421844 · Cited by 321
Malico, I., Nepomuceno Pereira, R., Gonçalves, A. C., & Sousa, A. M. O. (2019) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2019.06.022 · Cited by 253
Reusing biochar as a filler or cement replacement material in cementitious composites: A review
Danish, A., Ali Mosaberpanah, M., Usama Salim, M., Ahmad, N., Ahmad, F., & Ahmad, A. (2021) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2021.124295 · Cited by 167
Microscopy observations of habitable space in biochar for colonization by fungal hyphae from soil
Jaafar, N. M., Clode, P. L., & Abbott, L. K. (2014) · Journal of Integrative Agriculture · doi:10.1016/s2095-3119(13)60703-0 · Cited by 157
A Review of Non-Soil Biochar Applications
Bartoli, M., Giorcelli, M., Jagdale, P., Rovere, M., & Tagliaferro, A. (2020) · Materials · doi:10.3390/ma13020261 · Cited by 156
Banana pseudo-stem biochar derived from slow and fast pyrolysis process
Abdullah, N., Mohd Taib, R., Mohamad Aziz, N. S., Omar, M. R., & Md Disa, N. (2023) · Heliyon · doi:10.1016/j.heliyon.2023.e12940 · Cited by 124
Review of the Effects of Biochar Amendment on Soil Properties and Carbon Sequestration
Xie, T., Sadasivam, B. Y., Reddy, K. R., Wang, C., & Spokas, K. (2016) · Journal of Hazardous, Toxic, and Radioactive Waste · doi:10.1061/(asce)hz.2153-5515.0000293 · Cited by 112
Heidari, A., Khaki, E., Younesi, H., & Lu, H. R. (2019) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2019.118394 · Cited by 108
Nutrient release from switchgrass-derived biochar pellets embedded with fertilizers
Kim, P., Hensley, D., & Labbé, N. (2014) · Geoderma · doi:10.1016/j.geoderma.2014.05.017 · Cited by 107
Lu, H. R., & El Hanandeh, A. (2019) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2018.12.025 · Cited by 68
Maaoui, A., Ben Hassen Trabelsi, A., Ben Abdallah, A., Chagtmi, R., Lopez, G., Cortazar, M., & Olazar, M. (2023) · Journal of the Energy Institute · doi:10.1016/j.joei.2023.101242 · Cited by 69
Abdelhafez, A. A., Abbas, M. H. H., & Li, J. (2017) · Engineering Applications of Biochar · doi:10.5772/intechopen.68803 · Cited by 37
Biomass char as a fuel for internal combustion engines
Ellem, G. K., & Mulligan, C. J. (2012) · Asia-Pacific Journal of Chemical Engineering · doi:10.1002/apj.636 · Cited by 10
Metadata
- Authors
- Abdullah, H., & Wu, H.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2009-08-20
- Volume
- 23
- Issue
- 8
- Pages
- 4174-4181
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2016957187
- Cited by
- 321
- References
- 0
- FWCI
- 8.35
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.