The DOI matches its Crossref record; 38 of the 38 references it cites were found in a registry or an index.
Arsenate Adsorption on an Fe−Ce Bimetal Oxide Adsorbent: Role of Surface Properties
Abstract
An Fe-Ce bimetal adsorbent was investigated with X-ray powder diffraction (XRD), transmission electron micrograph (TEM), Fourier transform infrared spectra (FTIR), and X-ray photoelectron spectroscopy (XPS) methods for a better understanding of the effect of surface properties on arsenate (As(V)) adsorption. In the adsorption test, the bimetal oxide adsorbent showed a significantly higher As(V) adsorption capacity than the referenced Ce and Fe oxides (CeO2 and Fe3O4) prepared by the same procedure and some other arsenate adsorbents reported recently. XRD measurement of the adsorbent demonstrated that the phase of magnetite (Fe3O4) disappears gradually with the increasing dosage of Ce4+ ions until reaching a molar ratio of Ce4+ to Fe3+ and Fe2+ of 0.08:0.2:0.1 (Fe-CeO8 refers to the adsorbent prepared at this ratio), and the phase of CeO2 begins to appear following a further increase of the Ce dose. Combined with the results of TEM observation, it was assumed that a solid solution of Fe-Ce is formed following the disappearance of the magnetite phase. Occurrence of a characteristic surface hydroxyl group (MOH, metal surface hydroxyl, 1126 cm(-1)), which showed the highest band intensity in the solid solution state, was confirmed on the bimetal oxide adsorbent by FTIR. Quantificational calculation from the XPS narrow scan results of O(1s) spectra also indicated that the formation of the bimetal Fe-CeO8 was composed of more hydroxyl (30.8%) than was the formation of CeO2 and Fe3O4 (12.6% and 19.6%). The results of adsorption tests on Fe-CeO8 at differentAs(V) concentrations indicated that both the integral area of the As-O band at 836 cm(-1) and the As(V) adsorption capacity increased almost linearly with the decrease of the integral area of M-OH bands at 1126 cm(-1), proving that the adsorption of As(V) by Fe-CeO8 is mainly realized through the mechanism of quantitative ligand exchange. The atomic ratio of Fe on Fe-CeOB decreased from 20.1% to 7.7% with the increase of the As atom ratio from 0 to 16% after As(V) adsorption, suggesting that As(V) adsorption might be realized through the replacement of the M-OH group of Fe (Fe-OH) with arsenate. The well splitting of three v3 bands at As-O band (836 cm(-1)) of FTIR and the hydroxyl ratio (1.7) of Fe-CeO8 calculated from the XPS results suggested that the diprotonated monodentate complex (SOAsO(OH)2) is possibly dominant on the surface of Fe-CeO8.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Infrared and Raman Spectra of Inorganic and Coordination Compounds
Nakamoto, K. (2001) · Handbook of Vibrational Spectroscopy · doi:10.1002/0470027320.s4104 · Cited by 15,406
Nakamoto, K. (2008) · Wiley eBooks · doi:10.1002/9780470405888 · Cited by 8,429
Chemistry of the solid-water interface
Stumm, W. (1992) · Cited by 1,644
Chemistry of the solid-water interface
Sposito, G. (1993) · Marine Chemistry · doi:10.1016/0304-4203(93)90021-f · Cited by 1,453
Goldberg, S., & Johnston, C. T. (2001) · Journal of Colloid and Interface Science · doi:10.1006/jcis.2000.7295 · Cited by 1,264
Waychunas, G. A., Rea, B. A., Fuller, C. C., & Davis, J. A. (1993) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(93)90567-g · Cited by 1,149
Arsenate and Chromate Retention Mechanisms on Goethite. 1. Surface Structure
Fendorf, S., Eick, M. J., Grossl, P., & Sparks, D. L. (1997) · Environmental Science & Technology · doi:10.1021/es950653t · Cited by 1,017
Mineral-Water Interface Geochemistry
(1990) · De Gruyter eBooks · doi:10.1515/9781501509131 · Cited by 865
(1970) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(70)90052-9 · Cited by 813
Arai, Y., & Sparks, D. L. (2001) · Journal of Colloid and Interface Science · doi:10.1006/jcis.2001.7773 · Cited by 757
Cited by
Arsenic removal from water/wastewater using adsorbents—A critical review
Mohan, D., & Pittman, C. U. (2007) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2007.01.006 · Cited by 3,536
Removal Mechanism of As(III) by a Novel Fe−Mn Binary Oxide Adsorbent: Oxidation and Sorption
Zhang, G.-S., Qu, J.-H., Liu, H.-J., Liu, R.-P., & Li, G.-T. (2007) · Environmental Science & Technology · doi:10.1021/es063010u · Cited by 488
Wan, Z., & Wang, J. (2017) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2016.11.039 · Cited by 428
López-Luna, J., Ramírez-Montes, L. E., Martinez-Vargas, S., Martínez, A. I., Mijangos-Ricardez, O. F., González-Chávez, M. D. C. A., Carrillo-González, R., Solís-Domínguez, F. A., Cuevas-Díaz, M. D. C., & Vázquez-Hipólito, V. (2019) · SN Applied Sciences · doi:10.1007/s42452-019-0977-3 · Cited by 371
Santos, S., Ungureanu, G., Boaventura, R., & Botelho, C. (2015) · Science of The Total Environment · doi:10.1016/j.scitotenv.2015.03.107 · Cited by 337
Formation of Binary and Ternary Colloids and Dissolved Complexes of Organic Matter, Fe and As
Sharma, P., Ofner, J., & Kappler, A. (2010) · Environmental Science & Technology · doi:10.1021/es100066s · Cited by 281
The mechanism of antimony(III) removal and its reactions on the surfaces of Fe–Mn Binary Oxide
Xu, W., Wang, H., Liu, R., Zhao, X., & Qu, J. (2011) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2011.07.026 · Cited by 274
Efficient removal of arsenic using plastic waste char: Prevailing mechanism and sorption performance
Singh, E., Kumar, A., Khapre, A., Saikia, P., Shukla, S. K., & Kumar, S. (2020) · Journal of Water Process Engineering · doi:10.1016/j.jwpe.2019.101095 · Cited by 76
Liu, X., Gao, M., Qiu, W., Khan, Z. H., Liu, N., Lin, L., & Song, Z. (2019) · Environmental Science and Pollution Research · doi:10.1007/s11356-019-04914-8 · Cited by 69
Younis, A., Chu, D., & Li, S. (2015) · Scientific Reports · doi:10.1038/srep13599 · Cited by 50
Metadata
- Authors
- Zhang, Y., Yang, M., Dou, X.-M., He, H., & Wang, D.-S.
- Venue
- Environmental Science & Technology
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-08-09
- Volume
- 39
- Issue
- 18
- Pages
- 7246-7253
- ISSN
- 0013-936X (ISSN-L)
- 1520-5851
- OpenAlex
- W2018805665
- Cited by
- 548
- References
- 38
- FWCI
- 2.71
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.
