The DOI matches its Crossref record.
Development of Regenerable MgO-Based Sorbent Promoted with K2CO3 for CO2 Capture at Low Temperatures
Abstract
To improve their CO2 absorption capacity, alkali-based sorbents prepared by impregnation and wet mixing method of potassium carbonate on supports such as activated carbon and MgO (KACI30, KACP30, KMgI30, and KMgP30), were investigated in a fixed bed reactor (C02 absorption at 50-100 degrees C and regeneration at 150-400 degrees C). Total CO2 capture capacities of KMgI30-500 and KMgP30-500 were 178.6 and 197.6 mg CO2/g sorbent, respectively, in the presence of 11 vol % H2O even at 50 degrees C. The large amount of CO2 capture capacity of KMgP30-500 and KMgI30-500 could be explained by the fact that MgO itself, as well as K2CO3, could absorb CO2 in the presence of water vapor even at low temperatures. In particular, water vapor plays an important role in the CO2 absorption of MgO and KMgI30-500 even at low temperatures below 60 degrees C, in marked contrast to MgO and CaO which can absorb CO2 at high temperatures. The CO2 capture capacity of the KMgI30-300 sorbent, however, was less than that of KMgI30-500 due to the formation of Mg(OH)2 which did not absorb CO2. MgO based-sorbents promoted with K2CO3 after CO2 absorption formed new structures such as K2Mg(CO3)2 and K2Mg(CO3)2 x 4(H2O), unlike KACI30 which showed only the KHCO3 crystal structure. The new Mg-based sorbents promoted with K2CO3 showed excellent characteristics in that it could satisfy a large amount of CO2 absorption at low temperatures, a high CO2 absorption rate, and fast and complete regeneration.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Adsorbent Materials for Carbon Dioxide Capture from Large Anthropogenic Point Sources
Choi, S., Drese, J. H., & Jones, C. W. (2009) · ChemSusChem · doi:10.1002/cssc.200900036 · Cited by 2,596
A review on solid adsorbents for carbon dioxide capture
Lee, S.-Y., & Park, S.-J. (2015) · Journal of Industrial and Engineering Chemistry · doi:10.1016/j.jiec.2014.09.001 · Cited by 707
Self-citationCarbon capture and storage using alkaline industrial wastes
Bobicki, E. R., Liu, Q., Xu, Z., & Zeng, H. (2012) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.11.002 · Cited by 666
Understanding the Effect of Water on CO2 Adsorption
Kolle, J. M., Fayaz, M., & Sayari, A. (2021) · Chemical Reviews · doi:10.1021/acs.chemrev.0c00762 · Cited by 523
Dunstan, M. T., Donat, F., Bork, A. H., Grey, C. P., & Müller, C. R. (2021) · Chemical Reviews · doi:10.1021/acs.chemrev.1c00100 · Cited by 481
Li, L., Zhao, N., Wei, W., & Sun, Y. (2013) · Fuel · doi:10.1016/j.fuel.2011.08.022 · Cited by 480
Recent advances in capture of carbon dioxide using alkali-metal-based oxides
Wang, S., Yan, S., Ma, X., & Gong, J. (2011) · Energy & Environmental Science · doi:10.1039/c1ee01116b · Cited by 382
Trends in Solid Adsorbent Materials Development for CO 2 Capture
Pardakhti, M., Jafari, T., Tobin, Z., Dutta, B., Moharreri, E., Shemshaki, N. S., Suib, S., & Srivastava, R. (2019) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.9b08487 · Cited by 357
Carbon dioxide adsorption on oxide nanoparticle surfaces
Baltrusaitis, J., Schuttlefield, J., Zeitler, E., & Grassian, V. H. (2011) · Chemical Engineering Journal · doi:10.1016/j.cej.2010.12.041 · Cited by 339
Primary, secondary, and tertiary amines for CO2 capture: Designing for mesoporous CO2 adsorbents
Ko, Y. G., Shin, S. S., & Choi, U. S. (2011) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2011.03.045 · Cited by 277
Duyar, M. S., Wang, S., Arellano-Treviño, M. A., & Farrauto, R. J. (2016) · Journal of CO2 Utilization · doi:10.1016/j.jcou.2016.05.003 · Cited by 277
Liu, W.-J., Jiang, H., Tian, K., Ding, Y.-W., & Yu, H.-Q. (2013) · Environmental Science & Technology · doi:10.1021/es401286p · Cited by 276
A review on carbon dioxide mineral carbonation through pH-swing process
Azdarpour, A., Asadullah, M., Mohammadian, E., Hamidi, H., Junin, R., & Karaei, M. A. (2015) · Chemical Engineering Journal · doi:10.1016/j.cej.2015.05.064 · Cited by 275
Joseph, S., Kammann, C. I., Shepherd, J. G., Conte, P., Schmidt, H.-P., Hagemann, N., Rich, A. M., Marjo, C. E., Allen, J., Munroe, P., et al. (2018) · Science of The Total Environment · doi:10.1016/j.scitotenv.2017.09.200 · Cited by 262
Activated carbons prepared from peanut shell and sunflower seed shell for high CO2 adsorption
Deng, S., Hu, B., Chen, T., Wang, B., Huang, J., Wang, Y., & Yu, G. (2015) · Adsorption · doi:10.1007/s10450-015-9655-y · Cited by 159
Recent developments and consideration issues in solid adsorbents for CO2 capture from flue gas
Nie, L., Mu, Y., Jin, J., Chen, J., & Mi, J. (2018) · Chinese Journal of Chemical Engineering · doi:10.1016/j.cjche.2018.07.012 · Cited by 122
Metadata
- Authors
- Lee, S. C., Chae, H. J., Lee, S. J., Choi, B. Y., Yi, C. K., Lee, J. B., Ryu, C. K., & Kim, J. C.
- Venue
- Environmental Science & Technology
- Publisher
- American Chemical Society (ACS)
- Published
- 2008-04-01
- Volume
- 42
- Issue
- 8
- Pages
- 2736-2741
- ISSN
- 0013-936X (ISSN-L)
- 1520-5851
- OpenAlex
- W1980910150
- Cited by
- 220
- References
- 0
- FWCI
- 27.74
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.