Numerical Analysis on the Power Consumption of the PSA Process for Recovering CO2 from Flue Gas
The DOI matches its Crossref record.
Abstract
To recover 99% CO 2 from flue gas containing 10−15% CO 2, a two-stage pressure swing adsorption (PSA) process is usually employed. At the first stage of the two-stage PSA, CO 2 is concentrated to 40−60% and then concentrated to 99% at the second stage. Because two stages are coupled with each other, the overall optimization of the two-stage PSA process is quite a complicated task. In this paper, we only considered the first stage of the two-stage PSA process to simplify the analysis. Effects of the process configuration and operating variables such as the P / F ratio and desorption pressure on the specific power consumption were investigated. The specific power consumption at the blower was reduced with the increase of the P / F ratio. On the contrary, that at the vacuum pump was increased with the increase of the P / F ratio. Because of these two effects, there was an optimum P / F ratio, which minimized the specific power consumption. While the compression ratio is reduced with the increase of the desorption pressure, the CO 2 purity is decreased and the amount of the power used to compress nitrogen is increased. As a result, the specific power consumption was insensitive to the desorption pressure within the range studied here. Employing the pressure equalization step, the CO 2 purity could be increased without much increase of the specific power consumption. With the rinse step, which is often used to increase the purity of the strongly adsorbed component, the CO 2 purity could be increased. However, because more gases should be pumped to produce a given amount of CO 2,, the specific power consumption was significantly increased at a given recovery.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
White, C. M., Strazisar, B. R., Granite, E. J., Hoffman, J. S., & Pennline, H. W. (2003) · Journal of the Air & Waste Management Association · doi:10.1080/10473289.2003.10466206 · Cited by 751
Isoreticular chemistry within metal–organic frameworks for gas storage and separation
Fan, W., Zhang, X., Kang, Z., Liu, X., & Sun, D. (2021) · Coordination Chemistry Reviews · doi:10.1016/j.ccr.2021.213968 · Cited by 584
Abanades, J. C., Arias, B., Lyngfelt, A., Mattisson, T., Wiley, D. E., Li, H., Ho, M. T., Mangano, E., & Brandani, S. (2015) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2015.04.018 · Cited by 441
Hedin, N., Andersson, L., Bergström, L., & Yan, J. (2013) · Applied Energy · doi:10.1016/j.apenergy.2012.11.034 · Cited by 424
Plaza, M. G., García, S., Rubiera, F., Pis, J. J., & Pevida, C. (2010) · Chemical Engineering Journal · doi:10.1016/j.cej.2010.07.030 · Cited by 365
Ebner, A. D., & Ritter, J. A. (2009) · Separation Science and Technology · doi:10.1080/01496390902733314 · Cited by 301
Zhang, J., Webley, P. A., & Xiao, P. (2008) · Energy Conversion and Management · doi:10.1016/j.enconman.2007.06.007 · Cited by 298
A review of mathematical modeling of fixed-bed columns for carbon dioxide adsorption
Shafeeyan, M. S., Wan Daud, W. M. A., & Shamiri, A. (2014) · Chemical Engineering Research and Design · doi:10.1016/j.cherd.2013.08.018 · Cited by 293
“The most important sources of CO2 emissions are power plants that generate electricity from fossil fuels (coal, oil, and natural gas) (Dantas et al., 2011a; Grande et al., 2008; Grande and Rodrigues, 2008; Kikkinides et al., 1993; Mulgundmath et al., 2012; Park et al., 2002; Shafeeyan et al., 2012).”
BackgroundMerel, J., Clausse, M., & Meunier, F. (2008) · Industrial & Engineering Chemistry Research · doi:10.1021/ie071012x · Cited by 286
Advances in Pressure Swing Adsorption for Gas Separation
Grande, C. A. (2012) · ISRN Chemical Engineering · doi:10.5402/2012/982934 · Cited by 285
“[83] J.”
BackgroundTwo-Stage VPSA Process for CO2 Capture from Flue Gas Using Activated Carbon Beads
Shen, C., Liu, Z., Li, P., & Yu, J. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie202097y · Cited by 138
Cycle Development and Design for CO 2 Capture from Flue Gas by Vacuum Swing Adsorption
Zhang, J., & Webley, P. A. (2008) · Environmental Science & Technology · doi:10.1021/es0706854 · Cited by 132
Plaza, M. G., García, S., Rubiera, F., Pis, J. J., & Pevida, C. (2011) · Separation and Purification Technology · doi:10.1016/j.seppur.2011.04.015 · Cited by 100
Luberti, M., Oreggioni, G. D., & Ahn, H. (2017) · Journal of Environmental Chemical Engineering · doi:10.1016/j.jece.2017.07.029 · Cited by 52
“…7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 3 Park et al. (2002) studied a two-stage PSA process to recover 90% of the CO2 contained in the flue gas containing 10-15% CO2.”
MethodResultGreen coffee based CO2 adsorbent with high performance in postcombustion conditions
Plaza, M. G., González, A. S., Pevida, C., & Rubiera, F. (2015) · Fuel · doi:10.1016/j.fuel.2014.10.014 · Cited by 47
Vacuum swing CO2 adsorption cycles in Waste-to-Energy plants
Durán, I., Rubiera, F., & Pevida, C. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2019.122841 · Cited by 29
Performance-Based Screening of Porous Materials for Carbon Capture
Farmahini, A. H., Krishnamurthy, S., Friedrich, D., Brandani, S., & Sarkisov, L. (2021) · Chemical Reviews · doi:10.1021/acs.chemrev.0c01266 · Cited by 7
Metadata
- Authors
- Park, J.-H., Beum, H.-T., Kim, J.-N., & Cho, S.-H.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2002-07-10
- Volume
- 41
- Issue
- 16
- Pages
- 4122-4131
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2095440008
- Cited by
- 113
- References
- 0
- FWCI
- 3.05
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.