The DOI matches its Crossref record; 11 of the 11 references it cites were found in a registry or an index.
Adhesion and Strength of Viscoelastic Solids. Is There a Relationship between Adhesion and Bulk Properties?
Abstract
Strength of adhesion depends upon the rheology of an adhesive as well as upon its interaction with a substrate. This is shown by studies using model joints prepared with different amounts of interlinking between two rubber sheets. The fracture energy G per unit of interfacial area appears to be a product of two terms: G = G o [1 + f ( R, T )], where G o is the intrinsic (chemical) strength of the interface and f ( R, T ), usually much larger than unity, reflects energy dissipated viscoelastically within the adherends at a crack speed R and temperature T . Values of G o range from virtually zero for nonbonded sheets up to the threshold tear strength of rubber, 50−80 J/m 2, in proportion to the density of interfacial bonds. Values of G are as much as 1000× greater at high speeds and low temperatures. Like adhesion, the tear strength of a soft rubbery solid is also increased by internal energy losses and shows the same marked dependence upon rate of tearing. By comparing the rate R at which tear strength increases by a certain factor with the angular frequency ω at which the elastic modulus μ increases by the same factor the length δ of the dissipative zone at the crack tip can be estimated: δ = R /ω. But values obtained in this way are only about 1 Å, too small to represent an actual dissipation zone in rubber. It seems likely instead that fracture takes place intermittently, the crack growing at high speed and then stopping. A possible mechanism of crack stopping is by splitting at the crack tip. Indeed, tip blunting can be inferred by comparing tear strength with resistance to cutting, when blunting is suppressed. Cutting resistance increases much more slowly with increasing rate and decreasing temperature. Thus, much of the observed tear strength of soft adhesives and soft solids is attributed to crack-tip blunting. Further research is needed to establish the exact nature of the blunting process and how it is related (as it clearly is) to viscoelastic and dissipative properties. Attention is drawn to other unresolved issues in adhesion science.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Williams, M. L., Landel, R. F., & Ferry, J. D. (1955) · Journal of the American Chemical Society · doi:10.1021/ja01619a008 · Cited by 8,083
Effect of Wetting Liquids on the Strength of Adhesion of Viscoelastic Material
Gent, A. N., & Schultz, J. (1972) · The Journal of Adhesion · doi:10.1080/00218467208072199 · Cited by 589
Self-citationDeformation and Fracture of High Polymers
Kausch, H. H., Hassell, J. A., & Jaffee, R. I. (1973) · Science · doi:10.1126/science.181.4103.961 · Cited by 272
Rupture of rubber. III. Determination of tear properties
Greensmith, H. W., & Thomas, A. G. (1955) · Journal of Polymer Science · doi:10.1002/pol.1955.120188803 · Cited by 266
Rupture of rubber. II. The strain concentration at an incision
Thomas, A. G. (1955) · Journal of Polymer Science · doi:10.1002/pol.1955.120188802 · Cited by 252
Effect of interfacial bonding on the strength of adhesion
Ahagon, A., & Gent, A. N. (1975) · Journal of Polymer Science: Polymer Physics Edition · doi:10.1002/pol.1975.180130703 · Cited by 188
Self-citationThreshold fracture energies for elastomers
Ahagon, A., & Gent, A. N. (1975) · Journal of Polymer Science: Polymer Physics Edition · doi:10.1002/pol.1975.180131005 · Cited by 167
Self-citationInterfacial bonding, energy dissipation, and adhesion
Gent, A. N., & Lai, S. (1994) · Journal of Polymer Science Part B Polymer Physics · doi:10.1002/polb.1994.090320826 · Cited by 142
Self-citationMeasurement of rubber cutting resistance in the absence of friction
Lake, G. J., & Yeoh, O. H. (1978) · International Journal of Fracture · doi:10.1007/bf01390472 · Cited by 115
The Fracture Energy and Some Mechanical Properties of a Polyurethane Elastomer
Mueller, H. K., & Knauss, W. G. (1971) · Transactions of the Society of Rheology · doi:10.1122/1.549209 · Cited by 109
Cited by
Tough adhesives for diverse wet surfaces
Li, J., Celiz, A. D., Yang, J., Yang, Q., Wamala, I., Whyte, W., Seo, B. R., Vasilyev, N. V., Vlassak, J. J., Suo, Z., et al. (2017) · Science · doi:10.1126/science.aah6362 · Cited by 1,598
Toughening Elastomers with Sacrificial Bonds and Watching Them Break
Ducrot, E., Chen, Y., Bulters, M., Sijbesma, R. P., & Creton, C. (2014) · Science · doi:10.1126/science.1248494 · Cited by 1,203
Tough bonding of hydrogels to diverse non-porous surfaces
Yuk, H., Zhang, T., Lin, S., Parada, G. A., & Zhao, X. (2016) · Nature Materials · doi:10.1038/nmat4463 · Cited by 1,184
Zhang, W., Wang, R., Sun, Z., Zhu, X., Zhao, Q., Zhang, T., Cholewinski, A., Yang, F. (., Zhao, B., Pinnaratip, R., et al. (2020) · Chemical Society Reviews · doi:10.1039/c9cs00285e · Cited by 970
Fracture and adhesion of soft materials: a review
Creton, C., & Ciccotti, M. (2016) · Reports on Progress in Physics · doi:10.1088/0034-4885/79/4/046601 · Cited by 915
Transfer Printing Techniques for Materials Assembly and Micro/Nanodevice Fabrication
Carlson, A., Bowen, A. M., Huang, Y., Nuzzo, R. G., & Rogers, J. A. (2012) · Advanced Materials · doi:10.1002/adma.201201386 · Cited by 917
Mechanochemical tools for polymer materials
Chen, Y., Mellot, G., van Luijk, D., Creton, C., & Sijbesma, R. P. (2021) · Chemical Society Reviews · doi:10.1039/d0cs00940g · Cited by 475
50th Anniversary Perspective: Networks and Gels: Soft but Dynamic and Tough
Creton, C. (2017) · Macromolecules · doi:10.1021/acs.macromol.7b01698 · Cited by 463
Kim, S., Wu, J., Carlson, A., Jin, S. H., Kovalsky, A., Glass, P., Liu, Z., Ahmed, N., Elgan, S. L., Chen, W., et al. (2010) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.1005828107 · Cited by 442
Bai, R., Yang, J., & Suo, Z. (2019) · European Journal of Mechanics - A/Solids · doi:10.1016/j.euromechsol.2018.12.001 · Cited by 346
Crack propagation in viscoelastic solids
Persson, B. N. J., & Brener, E. A. (2005) · Physical Review E · doi:10.1103/physreve.71.036123 · Cited by 317
Fatigue fracture of tough hydrogels
Bai, R., Yang, Q., Tang, J., Morelle, X. P., Vlassak, J., & Suo, Z. (2017) · Extreme Mechanics Letters · doi:10.1016/j.eml.2017.07.002 · Cited by 312
Fracture toughness of hydrogels: measurement and interpretation
Long, R., & Hui, C.-Y. (2016) · Soft Matter · doi:10.1039/c6sm01694d · Cited by 303
Crack propagation in rubber-like materials
Persson, B. N. J., Albohr, O., Heinrich, G., & Ueba, H. (2005) · Journal of Physics: Condensed Matter · doi:10.1088/0953-8984/17/44/r01 · Cited by 281
Crack blunting and the strength of soft elastic solids
Hui, C.-Y., A., J., Bennison, S. J., & Londono, J. D. (2003) · Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences · doi:10.1098/rspa.2002.1057 · Cited by 257
Design principles for creating synthetic underwater adhesives
Narayanan, A., Dhinojwala, A., & Joy, A. (2021) · Chemical Society Reviews · doi:10.1039/d1cs00316j · Cited by 193
Metadata
- Authors
- Gent, A. N.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 1996-01-01
- Volume
- 12
- Issue
- 19
- Pages
- 4492-4496
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2088405940
- Cited by
- 362
- References
- 11
- FWCI
- 3.57
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.