CoChat

Crystallization Kinetics and Morphology of Biodegradable Double Crystalline PLLA- b -PCL Diblock Copolymers

Castillo, Reina Verónica, Müller, Alejandro J., Raquez, Jean-Marie, Dubois, Philippe · 2010 · Macromolecules

The DOI matches its Crossref record; 84 of the 84 references it cites were found in a registry or an index; 8 of the 100 sources its claims cite were checked for support.

Abstract

The crystallization kinetics and morphology of biodegradable and double crystalline poly( l -lactide)- b -poly(ε-caprolactone) diblock copolymers (PLLA- b -PCL) was studied in a wide composition range by differential scanning calorimetry (DSC) and polarized light optical microscopy (PLOM). The two blocks were found to be partially miscible according to the variations of their thermal transitions with composition. PLOM results showed that PLLA crystallizes in a wide composition range with a spherulitic superstructural morphology. Only when the PLLA content is as low as 10 wt % are axialites formed. These results were in good agreement with the overall crystallization kinetics obtained by DSC isothermal experiments and analyzed by the Avrami equation. Both overall crystallization rates and spherulitic growth rates of the PLLA block decrease with PCL content because PCL acts as a diluent for the PLLA block in view of their miscibility. Reorganization processes revealed as double melting peaks for the PLLA block (not observed for the PLLA homopolymer) were observed during heating scans performed after isothermal crystallization. The reorganization ability of the PLLA block was found to increase with PCL content, a fact that quantified the perturbation caused by molten PCL block chains during the isothermal crystallization of the PLLA block. The PCL block crystallizes within previously formed PLLA spherulites or axialites. Despite the partial miscibility, unexpected and novel frac…

Overview

CoChat Summary

TL;DR

This paper maps the crystallization kinetics and morphology of biodegradable double-crystalline PLLA-*b*-PCL diblock copolymers across a wide composition range using DSC and PLOM. It reports partial miscibility, PCL diluent effects on PLLA crystallization, fractionated crystallization of PCL, and the first documented homogeneous nucleation of a crystallizable component in a miscible or weakly segregated diblock copolymer.

Key findings

  • PLLA and PCL blocks are partially miscible; PCL acts as a diluent, depressing PLLA *T*<sub>c</sub> and *T*<sub>m</sub> and slowing PLLA crystallization. PLLA forms spherulites for most compositions, with Avrami indexes near 2.5–3.0 for PLLA contents >32 wt %; only L10C90<sub>24</sub> gives *n* close to 2 and axialites by PLOM.
  • PCL crystallizes within previously formed PLLA spherulites or axialites. Fractionated crystallization occurs for PCL contents between 40 and 19 wt %; for L81C19<sub>21</sub>, PCL crystallizes near −45 °C after cooling to −60 °C, shows homogeneous nucleation, and has an Avrami index close to 1. For PCL contents lower than 7 wt %, PCL chains did not crystallize.
  • Heating after isothermal crystallization gives double melting peaks for the PLLA block in all copolymers except homo-PLLA; reorganization increases with PCL content up to 68 wt %, except for L10C90<sub>24</sub>. At 80 °C/min, reorganization is not completely suppressed for some high-PCL compositions.
  • Self-nucleation of PLLA increases PLLA crystallinity and nucleates PCL: Δ*T* ≈ 12 °C for L60C40<sub>21</sub> and Δ*T* ≈ 3 °C for L10C90<sub>24</sub>. PCL overall crystallization rate strongly decreases with increasing PLLA content.

Methods

  • Diblock copolymers were synthesized by controlled/“living” sequential block copolymerization initiated by aluminum trialkoxides in toluene and characterized by SEC and <sup>1</sup>H NMR; Table 1 lists compositions and molecular weights.
  • DSC used a Perkin-Elmer DSC-7 with ~5 mg samples, 10 °C/min cooling/heating, isothermal PLLA crystallization after melting at 190 °C for 3 min and cooling at 60 °C/min, and PCL isothermal crystallization after PLLA saturation and heating to 110 °C. High-speed DSC at 80 °C/min used 0.63 mg samples; self-nucleation and isothermal step crystallization were also performed, and Avrami analysis was applied.
  • PLOM used thin films melted at 190 °C for 3 min, quenched to isothermal crystallization temperatures in a Linkam TP-91 hot stage, and observed under crossed polarizers with a Zeiss MC-80 microscope and λ plate; spherulitic growth rates were calculated from radius versus time.

Limitations

  • The paper states that the reason for the small exothermic signals before PLLA melting and their composition dependence is unknown and beyond the article’s scope; the exact origin of the double exotherm in Figure 6c is also stated as unknown and beyond scope.
  • The paper states that it deals only with PLLA crystallization kinetics at temperatures >120 °C, and that the complex behavior at temperatures <120 °C requires further investigation.
  • Evident from the text: no mechanical, degradation, or biomedical performance data are reported despite the motivation; one PCL L81C19<sub>21</sub> crystallization result after cooling to −60 °C is noted as “not shown.”

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1021/ma100201g

Cites

84 of 84 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Verification

Claims the paper makes

8 Valid · 0 Not valid · 29 Not checked · 145 Own results and interpretations

110 more claims

Create a free account to see all 182 claims and every source verdict.

See all claims — free account
  • Probably not a substantial claim. 21
  • It may state two separate claims as one. 50
  • The quote only partly states this claim. 1

Create a free account to see these claims.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

2 of 2

Citations

Cites

Show all 84 references

Research works printed but not linked: 3

  1. Nandan B., 2007, Polymer Rev., 46, 143
  2. Laredo E., 2007, Eur. Phys. J., 23, 295
  3. Gedde U. W., 1995, Polymer Physics

Cited by

See all 175

Metadata

Authors
Castillo, R. V., Müller, A. J., Raquez, J.-M., & Dubois, P.
Affiliations
  • Instituto Venezolano de Investigaciones Científicas (VE)
  • Universidad Simón Bolívar (VE)
  • University of Mons (BE)
  • Center of Innovation and Research in Materials & Polymers CIRMAP, Service des Matériaux Polymères et Composites SMPC, Université de Mons-UMONS, Place du Parc 20, B-7000 Mons, Belgium
Corresponding author
Müller, Alejandro J.
Venue
Macromolecules
Published
2010-04-09
Volume
43
Issue
9
Pages
4149-4160
ISSN
  • 0024-9297 (ISSN-L)
  • 1520-5835
OpenAlex
W1995399247
Cited by
175
References
81
Citations by year
2026: 5 · 2025: 4 · 2024: 6 · 2023: 8 · 2022: 9 · 2021: 8 · 2020: 7 · 2019: 11 · 2018: 12 · 2017: 21 · 2016: 13 · 2015: 19 · 2014: 18 · 2013: 9 · 2012: 14
FWCI
8.74
Type
journal article
Language
en
Open access
closed
Locations
  • Macromolecules (publishedVersion)
  • ORBi UMONS (submittedVersion)
  • PolyPublie (École Polytechnique de Montréal) (submittedVersion)
Funders
Fonds De La Recherche Scientifique - FNRS
Topics
  • Physical Sciences › Materials Science › Polymers and Plastics › Polymer crystallization and properties
  • Physical Sciences › Materials Science › Biomaterials › biodegradable polymer synthesis and properties
  • Physical Sciences › Materials Science › Materials Chemistry › Block Copolymer Self-Assembly
Keywords
poly(L-lactic acid), polycaprolactone, diblock copolymers, crystallization kinetics, spherulitic morphology, homogeneous nucleation, Avrami analysis, glass transition temperature, fractional crystallization, biodegradable polymers, isothermal crystallization

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-11, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-11 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.