The DOI matches its Crossref record; 39 of the 39 references it cites were found in a registry or an index.
Thermal Conductivity of Nanocrystalline Silicon: Importance of Grain Size and Frequency-Dependent Mean Free Paths
Abstract
The thermal conductivity reduction due to grain boundary scattering is widely interpreted using a scattering length assumed equal to the grain size and independent of the phonon frequency (gray). To assess these assumptions and decouple the contributions of porosity and grain size, five samples of undoped nanocrystalline silicon have been measured with average grain sizes ranging from 550 to 64 nm and porosities from 17% to less than 1%, at temperatures from 310 to 16 K. The samples were prepared using current activated, pressure assisted densification (CAPAD). At low temperature the thermal conductivities of all samples show a T(2) dependence which cannot be explained by any traditional gray model. The measurements are explained over the entire temperature range by a new frequency-dependent model in which the mean free path for grain boundary scattering is inversely proportional to the phonon frequency, which is shown to be consistent with asymptotic analysis of atomistic simulations from the literature. In all cases the recommended boundary scattering length is smaller than the average grain size. These results should prove useful for the integration of nanocrystalline materials in devices such as advanced thermoelectrics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Introduction to Solid State Physics
Kittel, C., & Fan, H. Y. (1957) · American Journal of Physics · doi:10.1119/1.1934457 · Cited by 22,240
Introduction to Solid State Physics
Kittel, C., & Dexter, D. L. (1953) · American Journal of Physics · doi:10.1119/1.1933590 · Cited by 13,240
Holman, J. P. (1976) · Cited by 9,157
High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys
Poudel, B., Hao, Q., Ma, Y., Lan, Y., Minnich, A., Yu, B., Yan, X., Wang, D., Muto, A., Vashaee, D., et al. (2008) · Science · doi:10.1126/science.1156446 · Cited by 5,606
Ziman, J. M., & Levy, P. W. (1961) · Physics Today · doi:10.1063/1.3057244 · Cited by 3,368
Thermophysical Properties of Matter
Touloukian, Y. S. (1995) · CERN Document Server (European Organization for Nuclear Research) · Cited by 3,282
Swartz, E. T., & Pohl, R. O. (1989) · Reviews of Modern Physics · doi:10.1103/revmodphys.61.605 · Cited by 2,924
Thermal conductivity measurement from 30 to 750 K: the 3ω method
Cahill, D. G. (1990) · Review of Scientific Instruments · doi:10.1063/1.1141498 · Cited by 1,928
Exchange bias in nanostructures
Nogués, J., Sort, J., Langlais, V., Skumryev, V., Suriñach, S., Muñoz, J. S., & Baró, M. D. (2005) · Physics Reports · doi:10.1016/j.physrep.2005.08.004 · Cited by 1,925
Thermal conductivity of individual silicon nanowires
Li, D., Wu, Y., Kim, P., Shi, L., Yang, P., & Majumdar, A. (2003) · Applied Physics Letters · doi:10.1063/1.1616981 · Cited by 1,764
Cited by
Advanced Thermoelectric Design: From Materials and Structures to Devices
Shi, X.-L., Zou, J., & Chen, Z.-G. (2020) · Chemical Reviews · doi:10.1021/acs.chemrev.0c00026 · Cited by 2,524
Mao, J., Liu, Z., Zhou, J., Zhu, H., Zhang, Q., Chen, G., & Ren, Z. (2018) · Advances in Physics · doi:10.1080/00018732.2018.1551715 · Cited by 592
Qiu, L., Zhu, N., Feng, Y., Michaelides, E. E., Żyła, G., Jing, D., Zhang, X., Norris, P. M., Markides, C. N., & Mahian, O. (2020) · Physics Reports · doi:10.1016/j.physrep.2019.12.001 · Cited by 523
Advances in Thermal Conductivity
Toberer, E. S., Baranowski, L. L., & Dames, C. (2012) · Annual Review of Materials Research · doi:10.1146/annurev-matsci-070511-155040 · Cited by 334
Self-citationHanus, R., Agne, M. T., Rettie, A. J. E., Chen, Z., Tan, G., Chung, D. Y., Kanatzidis, M. G., Pei, Y., Voorhees, P. W., & Snyder, G. J. (2019) · Advanced Materials · doi:10.1002/adma.201900108 · Cited by 311
Non-Fourier phonon heat conduction at the microscale and nanoscale
Chen, G. (2021) · Nature Reviews Physics · doi:10.1038/s42254-021-00334-1 · Cited by 305
Mean free path spectra as a tool to understand thermal conductivity in bulk and nanostructures
Yang, F., & Dames, C. (2013) · Physical Review B · doi:10.1103/physrevb.87.035437 · Cited by 283
Self-citationDong, H., Wen, B., & Melnik, R. (2014) · Scientific Reports · doi:10.1038/srep07037 · Cited by 228
Computational Study of In-Plane Phonon Transport in Si Thin Films
Wang, X., & Huang, B. (2014) · Scientific Reports · doi:10.1038/srep06399 · Cited by 101
Ultralow Thermal Conductivity in Polycrystalline CdSe Thin Films With Controlled Grain Size
Feser, J. P., Chan, E. M., Majumdar, A., Segalman, R. A., & Urban, J. J. (2013) · Nano Letters · doi:10.1021/nl400531f · Cited by 83
Cheng, Z., Bougher, T., Bai, T., Wang, S. Y., Li, C., Yates, L., Foley, B. M., Goorsky, M., Cola, B. A., Faili, F., et al. (2018) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.7b16812 · Cited by 76
Smith, D. S., Puech, F., Nait-Ali, B., Alzina, A., & Honda, S. (2018) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2018.01.082 · Cited by 70
Evaluating the effect of grain size distribution on thermal conductivity of thermoelectric materials
Das, P., Bathula, S., & Gollapudi, S. (2020) · Nano Express · doi:10.1088/2632-959x/abb43f · Cited by 26
Mitterhuber, L., Kosednar-Legenstein, B., Vohra, A., Borga, M., Posthuma, N., & Kraker, E. (2024) · Journal of Applied Physics · doi:10.1063/5.0207513 · Cited by 11
Metadata
- Authors
- Wang, Z., Alaniz, J. E., Jang, W., Garay, J. E., & Dames, C.
- Venue
- Nano Letters
- Publisher
- American Chemical Society (ACS)
- Published
- 2011-05-09
- Volume
- 11
- Issue
- 6
- Pages
- 2206-2213
- ISSN
- 1530-6984 (ISSN-L)
- 1530-6992
- OpenAlex
- W2020245831
- Cited by
- 462
- References
- 39
- FWCI
- 12.70
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.