Study of plate deformation and stress in subduction processes using two-dimensional numerical models
Open accessThe DOI matches its Crossref record; 47 of the 47 references it cites were found in a registry or an index.
Abstract
Two‐dimensional finite element modeling is used to model subduction of an oceanic lithospheric plate beneath continental lithosphere. The subduction process is initiated along a preexisting inclined fault and continues until reaching 400 km of total convergence. The lithosphere is assumed to be underlain by an in viscid asthenosphere. Different rheological laws have been considered for the lithosphere, including elasticity and elastoplasticity. The modeling shows that both the stress system in the plates and the surface topography are strongly dependent on two main parameters: the density contrast between lithosphere and asthenosphere (Δρ = ρ L ‐ ρ A ) and the coefficient of friction along the subduction plane. Varying these two parameters allows explanation of the main characteristics of real subduction zones and results in two major regimes manifested by extension or compression in the arc‐back arc system. Extension and back arc rifting corresponds to a positive density contrast and a low coefficient of friction, while negative Δρ values and/or high friction leads to a compressional regime. The coexistence of trench arc compression and back arc tension is only possible for a coefficient of friction lower than 0.1. The results of the numerical experiments agree with those of experimental modeling conducted under similar physical assumptions.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Thermo-mechanical numerical models of convergent margin systems show that stable, one-sided subduction requires a discrete low-strength zone existing between two strong plates (Hassani et al., 1997;Sobolev and Babeyko, 2005;Tagawa et al., 2007), quantitatively defined as an effective coefficient of friction at the plate interface of < 0.1.”
From Secular change and the onset of plate tectonics on Earth (2020) · cites this paper as Hassani et al., 1997
Citations
Cites
Zienkiewicz, O. C. (1989) · Cited by 14,802
Byerlee, J. (1978) · pure and applied geophysics · doi:10.1007/bf00876528 · Cited by 4,029
Geodynamics applications of continuum physics to geological problems
Turcotte, D. L., & Schubert, G. (1982) · Andalas University Repository (Andalas University) · Cited by 1,921
Experimental Rock Deformation — The Brittle Field
(2005) · Springer eBooks · doi:10.1007/b137431 · Cited by 1,660
Geodynamics: Applications of Continuum Physics to Geological Problems
England, P. (1983) · Eos, Transactions American Geophysical Union · doi:10.1029/eo064i011p00106-01 · Cited by 1,605
Back‐arc opening and the mode of subduction
Uyeda, S., & Kanamori, H. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib03p01049 · Cited by 1,286
Computational Methods for Transient Analysis
Belytschko, T., Hughes, T. J. R., & Burgers, P. (1985) · Journal of Applied Mechanics · doi:10.1115/1.3169187 · Cited by 1,181
Origin and development of marginal basins in the western Pacific
Karig, D. E. (1971) · Journal of Geophysical Research · doi:10.1029/jb076i011p02542 · Cited by 1,035
Mechanics of fold‐and‐thrust belts and accretionary wedges: Cohesive Coulomb Theory
Dahlen, F. A., Suppe, J., & Davis, D. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib12p10087 · Cited by 770
Doglioni, C. (1991) · Terra Nova · doi:10.1111/j.1365-3121.1991.tb00172.x · Cited by 697
Research works printed but not linked: 2
- Jean M., 1988, Implementation of unilateral contact and dry friction in computer codes dealing with large deformation problems, J. Mec. Theor. Appl., 7, 145
- Underwood P., 1983, Computational Methods for Transient Analysis, 245
Cited by
Lithosphere tearing at STEP faults: response to edges of subduction zones
Govers, R., & Wortel, M. J. R. (2005) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2005.03.022 · Cited by 654
“Perpendicular asthenospheric Maxwell BCs have a characteristic decay time that is much larger than the Maxwell time of the asthenosphere; effectively, lateral asthenosphere BCs simulate the compressible asthenosphere beyond the model domain in this case (cf. [ 62 ]).”
BackgroundMOUNTAIN BUILDING, EROSION, AND THE SEISMIC CYCLE IN THE NEPAL HIMALAYA
Avouac, J.-P. (2003) · Advances in Geophysics · doi:10.1016/s0065-2687(03)46001-9 · Cited by 426
“D finite element code (Hassani et al., 1997) initially designed to account for the mechanical layering of the crust.”
BackgroundMethodInfluentialOncken, O., Hindle, D., Kley, J., Elger, K., Victor, P., & Schemmann, K. (2006) · Frontiers in Earth Sciences · doi:10.1007/978-3-540-48684-8_1 · Cited by 349
“…variations in slab pull force, slab anchoring, mantle viscosity, mantle flow patterns, slab length (distance to a slab window that enables the flow of mantle from below to above the subducting plate, as required by rollback), and the strength of the plate interface (see also Hassani et al., 1997).”
BackgroundModeling mountain building and the seismic cycle in the Himalaya of Nepal
Cattin, R., & Avouac, J. P. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900032 · Cited by 363
Secular change and the onset of plate tectonics on Earth
Palin, R. M., Santosh, M., Cao, W., Li, S.-S., Hernández-Uribe, D., & Parsons, A. (2020) · Earth-Science Reviews · doi:10.1016/j.earscirev.2020.103172 · Cited by 355
“If subduction could initiate on the early Earth, either locally or globally, what petrophysical and/or geodynamic conditions are required for it to be sustainable? Thermo-mechanical numerical models of convergent margin systems show that stable, one-sided subduction requires a discrete low-strength zone existing betwe…”
Background
Metadata
- Authors
- Hassani, R., Jongmans, D., & Chéry, J.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1997-08-10
- Volume
- 102
- Issue
- B8
- Pages
- 17951-17965
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2058318380
- Cited by
- 196
- References
- 47
- Citations by year
- 2026: 3 · 2025: 3 · 2024: 7 · 2023: 6 · 2022: 11 · 2021: 7 · 2020: 11 · 2019: 3 · 2018: 7 · 2017: 6 · 2016: 11 · 2015: 6 · 2014: 12 · 2013: 5 · 2012: 11
- FWCI
- 3.28
- Type
- journal article
- Language
- en
- Open access
- bronze
- doi.org
- Locations
- Journal of Geophysical Research Atmospheres (publishedVersion)
- Topics
- Physical Sciences › Earth and Planetary Sciences › Geophysics › earthquake and tectonic studies
- Physical Sciences › Earth and Planetary Sciences › Geology › Geological and Geophysical Studies
- Physical Sciences › Earth and Planetary Sciences › Geophysics › Geological and Geophysical Studies Worldwide
- Keywords
- subduction, plate deformation, lithospheric stress, back-arc extension, subduction initiation, surface topography
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.