The DOI matches its Crossref record; 60 of the 61 references it cites were found in a registry or an index.
Thermal conductance of metal–diamond interfaces at high pressure
Open accessAbstract
The thermal conductance of interfaces between metals and diamond, which has a comparatively high Debye temperature, is often greater than can be accounted for by two-phonon processes. The high pressures achievable in a diamond anvil cell (DAC) can significantly extend the metal phonon density of states to higher frequencies, and can also suppress extrinsic effects by greatly stiffening interface bonding. Here we report time-domain thermoreflectance measurements of metal–diamond interface thermal conductance up to 50 GPa in the DAC for Pb, Au0.95Pd0.05, Pt and Al films deposited on type 1A natural [100] and type 2A synthetic [110] diamond anvils. In all cases, the thermal conductances increase weakly or saturate to similar values at high pressure. Our results suggest that anharmonic conductance at metal–diamond interfaces is controlled by partial transmission processes, where a diamond phonon that inelastically scatters at the interface absorbs or emits a metal phonon. The thermal conductance of interfaces between metal and diamond at high pressure is often greater than can be accounted for by two-phonon processes. Here, the authors present a new experimental system, suggesting that the ‘extra’ thermal conductance seen is controlled by Raman-like three-phonon processes.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The cited source says what the claim attributes to it.
In the citing paper
“The heat capacity of new materials 38, 39 and thermal conductance of various solid/solid interfaces 40-47 have also been frequently measured using TDTR.”
From Tutorial: Time-domain thermoreflectance (TDTR) for thermal property characterization of bulk and thin film materials (2018) · cites this paper as [43]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Calibration of the ruby pressure gauge to 800 kbar under quasi‐hydrostatic conditions
Mao, H., Xu, J., & Bell, P. M. (1986) · Journal of Geophysical Research Atmospheres · doi:10.1029/jb091ib05p04673 · Cited by 4,476
Swartz, E. T., & Pohl, R. O. (1989) · Reviews of Modern Physics · doi:10.1103/revmodphys.61.605 · Cited by 2,992
Cahill, D. G., Ford, W. K., Goodson, K. E., Mahan, G. D., Majumdar, A., Maris, H. J., Merlin, R., & Phillpot, S. R. (2003) · Journal of Applied Physics · doi:10.1063/1.1524305 · Cited by 2,825
Self-citationWong, H. ‐. P., Raoux, S., Kim, S., Liang, J., Reifenberg, J. P., Rajendran, B., Asheghi, M., & Goodson, K. E. (2010) · Proceedings of the IEEE · doi:10.1109/jproc.2010.2070050 · Cited by 1,824
Nanoscale thermal transport. II. 2003–2012
Cahill, D. G., Braun, P. V., Chen, G., Clarke, D. R., Fan, S., Goodson, K. E., Keblinski, P., King, W. P., Mahan, G. D., Majumdar, A., et al. (2014) · Applied Physics Reviews · doi:10.1063/1.4832615 · Cited by 1,763
Self-citationReview of the vapour pressures of ice and supercooled water for atmospheric applications
Murphy, D. M., & Koop, T. (2005) · Quarterly Journal of the Royal Meteorological Society · doi:10.1256/qj.04.94 · Cited by 1,595
Analysis of heat flow in layered structures for time-domain thermoreflectance
Cahill, D. G. (2004) · Review of Scientific Instruments · doi:10.1063/1.1819431 · Cited by 1,543
Self-citationCarbon nanotube reinforced metal matrix composites - a review
Bakshi, S. R., Debrupa Lahiri, A., & Agarwal, A. K. (2010) · International Materials Reviews · doi:10.1179/095066009x12572530170543 · Cited by 1,447
Heat Assisted Magnetic Recording
KRYDER, M. H., Gage, E. C., McDaniel, T. W., Challener, W. A., Rottmayer, R. E., Ju, G., Hsia, Y.-T., & Erden, M. F. (2008) · Proceedings of the IEEE · doi:10.1109/jproc.2008.2004315 · Cited by 1,087
Effects of chemical bonding on heat transport across interfaces
Losego, M. D., Grady, M. E., Sottos, N. R., Cahill, D. G., & Braun, P. V. (2012) · Nature Materials · doi:10.1038/nmat3303 · Cited by 701
Self-citation
Flagged first, then by citations
1 of the 61 references couldn’t be matched to a known paper.
Cited by
Sorted by citations
Interfacial thermal resistance: Past, present, and future
Chen, J., Xu, X., Zhou, J., & Li, B. (2022) · Reviews of Modern Physics · doi:10.1103/revmodphys.94.025002 · Cited by 759
Experimental observation of high thermal conductivity in boron arsenide
Kang, J. S., Li, M., Wu, H. Y., Nguyen, H., & Hu, Y. (2018) · Science · doi:10.1126/science.aat5522 · Cited by 662
Jiang, P., Qian, X., & Yang, R. (2018) · Journal of Applied Physics · doi:10.1063/1.5046944 · Cited by 424
Present and future thermal interface materials for electronic devices
Razeeb, K. M., Dalton, E., Cross, G. L. W., & Robinson, A. J. (2017) · International Materials Reviews · doi:10.1080/09506608.2017.1296605 · Cited by 425
Giri, A., & Hopkins, P. E. (2019) · Advanced Functional Materials · doi:10.1002/adfm.201903857 · Cited by 384
Metadata
- Authors
- Hohensee, G. T., Wilson, R. B., & Cahill, D. G.
- Affiliations
- University of Illinois Urbana-Champaign (US)
- Corresponding author
- Hohensee, Gregory T.
- Venue
- Nature Communications
- Published
- 2015-03-06
- Volume
- 6
- Issue
- 1
- Pages
- 6578-6578
- ISSN
- 2041-1723 (ISSN-L)
- OpenAlex
- W2171459929
- Cited by
- 197
- References
- 61
- Citations by year
- 2026: 16 · 2025: 19 · 2024: 20 · 2023: 18 · 2022: 24 · 2021: 18 · 2020: 14 · 2019: 16 · 2018: 19 · 2017: 15 · 2016: 16 · 2015: 1
- FWCI
- 6.90
- Type
- journal article
- Language
- en
- Open access
- gold
- doi.org
- Licence
- Locations
- Nature Communications (publishedVersion)
- PubMed (publishedVersion)
- OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) (submittedVersion)
- RePEc: Research Papers in Economics (submittedVersion)
- Funders
- U.S. Department of Energy (DENA0002006)
- University of Illinois at Urbana-Champaign
- Division of Materials Research
- Topics
- Physical Sciences › Materials Science › Materials Chemistry › Thermal properties of materials
- Physical Sciences › Materials Science › Materials Chemistry › Diamond and Carbon-based Materials Research
- Physical Sciences › Earth and Planetary Sciences › Geophysics › High-pressure geophysics and materials
- Keywords
- metal-diamond interface, thermal conductance, high pressure, diamond anvil cell, time-domain thermoreflectance, three-phonon processes, phonon scattering, lead, gold-palladium alloy, platinum, aluminum
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
