The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Facile synthesis of MOF-177 by a sonochemical method using 1-methyl-2-pyrrolidinone as a solvent
Abstract
High quality MOF-177 crystals in the size range of 5-20 microm were successfully synthesized via a sonochemical route in a substantially reduced synthesis time (40 min) in the presence of low-cost NMP (1-methyl-2-pyrrolidone) as a solvent. Microwave heating in NMP also produced MOF-177 under similar conditions (35 min, 5-50 microm) but exhibited inferior crystallinity. In comparison, a conventional solvothermal route in DEF (diethylformamide) took 48 h to produce MOF-177 crystals 0.5-1.5 mm in size. The BET surface areas of the MOF-177 samples decreased in the order of sonochemical (4898 m(2) g(-1)) > conventional (4833 m(2) g(-1)) > microwave route (4197 m(2) g(-1)). In line with this trend, MOF-177 prepared via the sonochemical route resulted in the highest CO(2) adsorption capacity, 1315 mg g(-1) at 30 bar and 298 K. The product yield of MOF-177 synthesized via the sonochemical route was 95.6%, and was significantly higher than the product yields of other methods.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Reticular synthesis and the design of new materials
Yaghi, O. M., O'Keeffe, M., Ockwig, N. W., Chae, H. K., Eddaoudi, M., & Kim, J. (2003) · Nature · doi:10.1038/nature01650 · Cited by 9,101
Self-citationSuslick, K. S. (1990) · Science · doi:10.1126/science.247.4949.1439 · Cited by 2,897
Millward, A. R., & Yaghi, O. M. (2005) · Journal of the American Chemical Society · doi:10.1021/ja0570032 · Cited by 2,876
A route to high surface area, porosity and inclusion of large molecules in crystals
Materials Design and Discovery Group, Chae, H. K., Siberio-Pérez, D. Y., Kim, J., Go, Y., Eddaoudi, M., Matzger, A. J., O'Keeffe, M., & Yaghi, O. M. (2004) · Nature · doi:10.1038/nature02311 · Cited by 2,816
Self-citationSonochemical synthesis of amorphous iron
Suslick, K. S., Choe, S.-B., Cichowlas, A. A., & Grinstaff, M. W. (1991) · Nature · doi:10.1038/353414a0 · Cited by 1,255
Hwang, Y. K., Hong, D., Chang, J., Jhung, S. H., Seo, Y., Kim, J., Vimont, A., Daturi, M., Serre, C., & Férey, G. (2008) · Angewandte Chemie International Edition · doi:10.1002/anie.200705998 · Cited by 1,243
Self-citationSuslick, K. S., Hammerton, D. A., & Cline, R. E. (1986) · Journal of the American Chemical Society · doi:10.1021/ja00278a055 · Cited by 1,243
Using sonochemistry for the fabrication of nanomaterials
Gedanken, A. (2004) · Ultrasonics Sonochemistry · doi:10.1016/j.ultsonch.2004.01.037 · Cited by 1,220
High Uptakes of CO2 and CH4 in Mesoporous Metal—Organic Frameworks MIL-100 and MIL-101
Llewellyn, P. L., Bourrelly, S., Serre, C., Vimont, A., Daturi, M., Hamon, L., De Weireld, G., Chang, J.-S., Hong, D.-Y., Kyu Hwang, Y., et al. (2008) · Langmuir · doi:10.1021/la800227x · Cited by 1,156
Schlichte, K., Kratzke, T., & Kaskel, S. (2004) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2003.12.027 · Cited by 1,112
Room temperature synthesis of metal-organic frameworks: MOF-5, MOF-74, MOF-177, MOF-199, and IRMOF-0
Tranchemontagne, D. J., Hunt, J. R., & Yaghi, O. M. (2008) · Tetrahedron · doi:10.1016/j.tet.2008.06.036 · Cited by 1,091
Metallo-organic molecular sieve for gas separation and purification
Min Wang, Q., Shen, D., Bülow, M., Ling Lau, M., Deng, S., Fitch, F. R., Lemcoff, N. O., & Semanscin, J. (2002) · Microporous and Mesoporous Materials · doi:10.1016/s1387-1811(02)00405-5 · Cited by 771
Alaerts, L., Séguin, E., Poelman, H., Thibault‐Starzyk, F., Jacobs, P. A., & De Vos, D. E. (2006) · Chemistry – A European Journal · doi:10.1002/chem.200600220 · Cited by 694
Furukawa, H., Miller, M. A., & Yaghi, O. M. (2007) · Journal of Materials Chemistry · doi:10.1039/b703608f · Cited by 607
Sonochemical synthesis of MOF-5
Son, W.-J., Kim, J., Kim, J., & Ahn, W.-S. (2008) · Chemical Communications · doi:10.1039/b814740j · Cited by 558
Self-citationPatterned Growth of Metal-Organic Framework Coatings by Electrochemical Synthesis
Ameloot, R., Stappers, L., Fransaer, J., Alaerts, L., Sels, B. F., & De Vos, D. E. (2009) · Chemistry of Materials · doi:10.1021/cm900069f · Cited by 525
A Porous Coordination Copolymer with over 5000 m2/g BET Surface Area
Koh, K., Wong-Foy, A. G., & Matzger, A. J. (2009) · Journal of the American Chemical Society · doi:10.1021/ja809985t · Cited by 487
Li, Z.-Q., Qiu, L.-G., Xu, T., Wu, Y., Wang, W., Wu, Z.-Y., & Jiang, X. (2009) · Materials Letters · doi:10.1016/j.matlet.2008.09.010 · Cited by 448
Seo, Y.-K., Hundal, G., Jang, I. T., Hwang, Y. K., Jun, C.-H., & Chang, J.-S. (2009) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2008.10.035 · Cited by 373
Metal–organic framework MOF-5 prepared by microwave heating: Factors to be considered
Choi, J.-S., Son, W.-J., Kim, J., & Ahn, W.-S. (2008) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2008.04.033 · Cited by 362
Self-citationYoo, Y., Lai, Z., & Jeong, H.-K. (2009) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2009.03.036 · Cited by 332
Chowdhury, P., Bikkina, C., Meister, D., Dreisbach, F., & Gumma, S. (2008) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2008.07.029 · Cited by 269
Postsynthetic Covalent Modification of Metal–Organic Framework (MOF) Materials
Song, Y., & Cronin, L. (2008) · Angewandte Chemie International Edition · doi:10.1002/anie.200801631 · Cited by 178
Sonochemical and Microwave-Assisted Preparations of PbTe and PbSe. A Comparative Study
Kerner, R., Palchik, O., & Gedanken, A. (2001) · Chemistry of Materials · doi:10.1021/cm001411h · Cited by 136
Comparison of Cu-BTC and zeolite 13X for adsorbent based CO2 separation
Liang, Z., Marshall, M., & Chaffee, A. L. (2009) · Energy Procedia · doi:10.1016/j.egypro.2009.01.166 · Cited by 75
Tetrahedral frameworks TX2 with T–X–T angle=180°
O’Keeffe, M. (2006) · Materials Research Bulletin · doi:10.1016/j.materresbull.2005.12.013 · Cited by 21
Cited by
Carbon Dioxide Capture in Metal–Organic Frameworks
Sumida, K., Rogow, D. L., Mason, J. A., McDonald, T. M., Bloch, E. D., Herm, Z. R., Bae, T.-H., & Long, J. R. (2012) · Chemical Reviews · doi:10.1021/cr2003272 · Cited by 6,408
Cook, T. R., Zheng, Y.-R., & Stang, P. J. (2013) · Chemical Reviews · doi:10.1021/cr3002824 · Cited by 2,950
Metal‐Organic Frameworks: A Rapidly Growing Class of Versatile Nanoporous Materials
Meek, S. T., Greathouse, J. A., & Allendorf, M. D. (2011) · Advanced Materials · doi:10.1002/adma.201002854 · Cited by 1,407
Adsorptive removal of hazardous materials using metal-organic frameworks (MOFs): A review
Khan, N. A., Hasan, Z., & Jhung, S. H. (2013) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2012.11.011 · Cited by 1,398
Multifunctional metal–organic frameworks: from academia to industrial applications
Silva, P., Vilela, S. M. F., Tomé, J. P. C., & Almeida Paz, F. A. (2015) · Chemical Society Reviews · doi:10.1039/c5cs00307e · Cited by 1,003
Metadata
- Authors
- Jung, D.-W., Yang, D.-A., Kim, J., Kim, J., & Ahn, W.-S.
- Venue
- Dalton Transactions
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2010
- Volume
- 39
- Issue
- 11
- Pages
- 2883
- ISSN
- 1477-9226 (ISSN-L)
- 1477-9234
- OpenAlex
- W2170515159
- Cited by
- 264
- References
- 26
- FWCI
- 6.41
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.