CoChat

Exploiting controlled transesterification as a “top down” approach to tailor poly( ε -caprolactone)-poly(lactic acid) copolymer structures with bis-Zn catalysts

Open access

The DOI matches its Crossref record; 50 of the 50 references it cites were found in a registry or an index; 1 of the 17 sources its claims cite were checked for support.

Abstract

Mediated by a bis-Zn catalyst, poly(lactic acid)- block -poly( ε -caprolactone) diblock copolymers can be modified via controlled transesterification, leading to diverse copolymer structures.

Overview

CoChat Summary

TL;DR

Controlled Zn-mediated transesterification, triggered by adding ε-caprolactone to living PCL-*block*-PLA chains, can be used as a “top down” post-polymerisation method to tune PCL-PLA copolymer randomness versus blockiness. Increasing the ε-CL stoichiometry and decreasing the diblock precursor length increase randomness, while low ε-CL loading or δ-valerolactone tips the balance toward transesterification.

Key findings

  • Adding 10, 20, 40, and 80 eq. of ε-CL to PCL₂₀₀-*block*-PLA₂₀₀* increased the randomness value R from 0.02 in the control to 0.08, 0.18, 0.26, and 0.30, respectively; average sequence lengths fell from l_LA/l_CL = 100/101 in the control to 33/21, 13/10, 8/7, and 7/6 (Table 1).
  • Block length also controlled the extent of transesterification: with 20 eq. ε-CL, PCL₁₀₀-*block*-PLA₁₀₀ gave R = 0.42 and l_LA/l_CL = 5/5, PCL₂₀₀-*block*-PLA₂₀₀ gave R = 0.18 and l_LA/l_CL = 13/10, and PCL₄₀₀-*block*-PLA₄₀₀ gave R = 0.07 and l_LA/l_CL = 33/27.
  • Transesterification disrupted both PCL and PLA blocks: PLA₂₀* + 20 eq. ε-CL gave l_LA = 1, l_CL = 2, R = 1.33; PCL₁₀-*block*-PLA₂₀ + 10 eq. ε-CL gave l_LA = l_CL = 2, R = 1.05. In the latter, ε-CL in CCC sequences fell to 37% from a theoretical 90% (91% observed), and LA in LLL sequences fell to 52% from a theoretical 95% (96% observed); if ε-CL were inserted only into the PLA block, the minimum CCC percentage would be 45%.
  • Post-polymerisation modification of an isolated PCL₂₀₀-*block*-PLA₂₀₀ with 40 eq. ε-CL gave l_LA = 15, l_CL = 13, R = 0.15, versus l_LA = 8, l_CL = 7, R = 0.26 for the comparable one-pot sample 3; no CLC or LCL triads were observed, indicating lower transesterification for the isolated precursor.

Methods

  • PCL-*block*-PLA copolymers were prepared by ring-opening polymerisation using LZn₂Et/BnOH, with sequential addition of ε-CL then LA; extended diblocks targeted PCLₙ-*block*-PLAₙ (n = 100, 200, 400) under optimised conditions (ε-CL loading 22% w/w in toluene, 70 °C). ε-CL conversion was ≥95% in <5 min, and rac-LA conversion was ≥80% in <1 h.
  • Transesterification was induced by adding ε-CL or δ-VL to living or isolated copolymer chains; products were analysed by ¹H NMR, quantitative ¹³C NMR, SEC, DOSY, and DSC, with l_LA, l_CL, R, and triad distributions calculated from NMR.
  • Reverse Monte Carlo simulations were used to model oligomeric copolymer structures for samples 8 and 9, using 5 × 10⁴ iterations; lowest scores were 14 for sample 8 and 11 for sample 9, compared with a random-sequence score of 28.

Limitations

  • The paper does not include a dedicated limitations section. The text notes that ¹H and ¹³C NMR spectra give information averaged over the entire system, so transesterification may occur only in a fraction of the copolymers while others remain unaffected.
  • The post-polymerisation modification route deviated from the one-pot route, which the authors suggest may arise from inefficiencies in forming the activated copolymer, i.e. not all copolymer chains are activated by LZn₂Et.
  • Simulations were performed on oligomeric model systems to facilitate structural analysis, rather than on the full range of copolymer samples.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1039/d4py00169a

Cites

50 of 50 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Image 1
CC-BY · From the PDF
Fig. 1 Synthesis of PCL-PLA diblock copolymers via ROP using LZn2Et / BnOH, 39 and the strategy investigated herein to modify the copolymer structure using controlled transesteri fi cation.
Fig. 1 Synthesis of PCL-PLA diblock copolymers via ROP using LZn2Et / BnOH, 39 and the strategy investigated herein to modify the copolymer structure using controlled transesteri fi cation.CC-BY · From the PDF
Image 3
CC-BY · From the PDF
Fig. 2 (a) 1 H NMR spectra of PCL200block -PLA200 with various eq. of ε -CL added (indicated on the spectra), where the black arrow indicates PCL protons adjacent to a PLA unit and the pink arrow indicates PLA protons adjacent to a PCL unit. Plots of (b) the randomness value R and (c) the number average sequence length ( l ) calculated using 1 H NMR spectroscopy against the equivalents of ε -CL added.
Fig. 2 (a) 1 H NMR spectra of PCL200block -PLA200 with various eq. of ε -CL added (indicated on the spectra), where the black arrow indicates PCL protons adjacent to a PLA unit and the pink arrow indicates PLA protons adjacent to a PCL unit. Plots of (b) the randomness value R and (c) the number average sequence length ( l ) calculated using 1 H NMR spectroscopy against the equivalents of ε -CL added.CC-BY · From the PDF
Fig. 3 Plots of (a) the number average sequence length ( l ) and (b) the randomness value R calculated using 1 H NMR spectroscopy against the targeted block DP for adding 20 equivalents of ε -CL to PCL100block -PLA100*, PCL200block -PLA200* and PCL400block -PLA400*.
Fig. 3 Plots of (a) the number average sequence length ( l ) and (b) the randomness value R calculated using 1 H NMR spectroscopy against the targeted block DP for adding 20 equivalents of ε -CL to PCL100block -PLA100*, PCL200block -PLA200* and PCL400block -PLA400*.CC-BY · From the PDF
Fig. 4 (a) Expanded 13 C NMR spectra of PCL200block -PLA200 with 10 -80 eq. of ε -CL added and the respective peak assignments indicated on the spectra. (b) Shows the same 13 C NMR spectra with a magni fi ed baseline.
Fig. 4 (a) Expanded 13 C NMR spectra of PCL200block -PLA200 with 10 -80 eq. of ε -CL added and the respective peak assignments indicated on the spectra. (b) Shows the same 13 C NMR spectra with a magni fi ed baseline.CC-BY · From the PDF
Fig. 5 Expanded 13 C NMR spectra of (a) PLA20* with 20 eq. of ε -CL (sample 8 ) and (b) PCL10block -PLA20 with 10 eq. of ε -CL (sample 9 ), showing the respective peak assignments.
Fig. 5 Expanded 13 C NMR spectra of (a) PLA20* with 20 eq. of ε -CL (sample 8 ) and (b) PCL10block -PLA20 with 10 eq. of ε -CL (sample 9 ), showing the respective peak assignments.CC-BY · From the PDF
Fig. 6 2D histograms of sequence number against sequence length, with the 1D histogram above, for PLA20-PCL20 (sample 8 ), where (a) is ε -CL and (b) is L, and for PCL10-PLA20-PCL10 (sample 9 ), where (c) is ε -CL and (d) is L.
Fig. 6 2D histograms of sequence number against sequence length, with the 1D histogram above, for PLA20-PCL20 (sample 8 ), where (a) is ε -CL and (b) is L, and for PCL10-PLA20-PCL10 (sample 9 ), where (c) is ε -CL and (d) is L.CC-BY · From the PDF
Fig. 7 (a) 1 H NMR spectra of PLA20-PVL20 (sample 10 ) where, the black arrow indicates PVL protons adjacent to a PLA unit. (b) Expanded 13 C NMR spectra of PCL20-PVL20 (sample 11 ) with the respective peak assignments indicated on the spectra where V and C represent ringopened δ -VL and ε -CL units, respectively.
Fig. 7 (a) 1 H NMR spectra of PLA20-PVL20 (sample 10 ) where, the black arrow indicates PVL protons adjacent to a PLA unit. (b) Expanded 13 C NMR spectra of PCL20-PVL20 (sample 11 ) with the respective peak assignments indicated on the spectra where V and C represent ringopened δ -VL and ε -CL units, respectively.CC-BY · From the PDF
Image 10
CC-BY · From the PDF

Verification

Claims the paper makes

0 Valid · 2 Not valid · 15 Not checked · 86 Own results and interpretations

52 more claims

Create a free account to see all 103 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 37
  • The quote only partly states this claim. 1
  • Probably not a substantial claim. 9

Create a free account to see these claims.

Citations

Cites

Research works printed but not linked: 8

  1. Kumar, 2014, J. Food Prod. Dev. Packag., 1, 1
  2. Reddy, 2013, Int. J. Emerging Technol. Adv. Eng., 3, 82
  3. Sudesh, 2008, Clean: Soil, Air, Water, 36, 433
  4. King, 2003, Langmuir, 8428
  5. Xiao, 2010, Int. J. Nanomed., 5, 1057
  6. S.Petrovic , Electrochem. Crash Course Eng , 2021 , pp. 27–30
  7. A.Duda and S.Penczek , Polymers from renewable resources: biopolyesters and biocatalysis , ACS symposium series , Washington DC , 2000
  8. Sangroniz, 2022, Polymers, 14, 1

Cited by

See all 13

Metadata

Authors
Neal, T. J., Neal, E. D., Cumby, J., & Garden, J. A.
Affiliations
  • University of Edinburgh (GB)
  • University of Bristol (GB)
Corresponding author
Garden, Jennifer A.
Venue
Polymer Chemistry
Published
2024
Volume
15
Issue
17
Pages
1704-1713
ISSN
  • 1759-9954 (ISSN-L)
  • 1759-9962
OpenAlex
W4393905611
Cited by
12
References
47
Citations by year
2026: 6 · 2025: 5 · 2024: 2
FWCI
1.31
Type
journal article
Language
en
Open access
Locations
  • Polymer Chemistry (publishedVersion, cc-by)
  • Edinburgh Research Explorer (University of Edinburgh) (submittedVersion, cc-by)
Funders
  • UK Research and Innovation (MR/T042710/1)
  • Engineering and Physical Sciences Research Council (EP/S023593/1)
  • Royal Society (RSG\R1\180101)
Topics
  • Physical Sciences › Materials Science › Biomaterials › biodegradable polymer synthesis and properties
  • Physical Sciences › Chemistry › Organic Chemistry › Advanced Polymer Synthesis and Characterization
  • Physical Sciences › Chemical Engineering › Process Chemistry and Technology › Carbon dioxide utilization in catalysis
Keywords
polycaprolactone, polylactic acid, block copolymers, transesterification, top-down approach, ring-opening polymerization

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-09-30, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-09-30 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.