Cited by 5Analog and Mixed-Signal Circuit DesignLow-power high-performance VLSI designAdvancements in Semiconductor Devices and Circuit Design

Feedback controlled pseudo resistor

Open access
Zhou, Zhijun, Warr, Paul·2020·Electronics Letters

Abstract

The pseudo resistor (PR) is widely used in integrated circuits. It comprises two transistors back‐to‐back to force them into the sub‐threshold region, which provides large resistance with a small die area. However, its linearity is limited by the non‐linear MOS transistors in weak inversion. In this Letter, a new PR topology is proposed, employing a feedback loop that continuously adjusts the voltage at the shared gate node of the PR with the input signal. The proposed architecture substantially increases the linearity and impedance of the PR.

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1049/el.2019.3779

Cites

6 of 6 references verified0 citation errors · 0 not checkable

Statistics

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

  • There are three categories of artifact suppression techniques in bidirectional interface systems.

    “There are three categories of artifact suppression techniques in bidirectional interface systems [188], [189].”

    From Active Neural Interface Circuits and Systems for Selective Control of Peripheral Nerves: A Review (2024) · cites this paper as [188]

    The Introduction (page not identified in our copy) discusses pseudo-resistor designs for biomedical applications, and the Conclusion describes a feedback-controlled pseudo resistor. Neither passage addresses categories of artifact-suppression techniques in bidirectional interface systems. Searches for the claimed three-category classification and related artifact-suppression terms found no supporting passage. (LLM, conf=0.76)

    Experimental — accuracy not yet measured

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Cites

Flagged first, then by citations

Cited by

Sorted by citations

Authors
Zhou, Z., & Warr, P.
Affiliations
  • Southeast University (CN)
  • University of Bristol (GB)
Corresponding author
Zhou, Zhijun
Venue
Electronics Letters
Published
2020-04
Volume
56
Issue
8
Pages
371-373
ISSN
  • 0013-5194 (ISSN-L)
  • 1350-911X
OpenAlex
W3001095253
Cited by
5
References
6
Citations by year
2024: 2 · 2022: 1 · 2021: 1 · 2020: 1
FWCI
0.24
Type
journal article
Language
en
Open access
Locations
  • Electronics Letters (publishedVersion)
  • Explore Bristol Research (submittedVersion)
  • Bristol Research (University of Bristol) (submittedVersion)
Funders
  • Natural Science Foundation of Jiangsu Province (BK20180363)
  • National Natural Science Foundation of China (61874024)
Topics
  • Physical Sciences › Engineering › Biomedical Engineering › Analog and Mixed-Signal Circuit Design
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Low-power high-performance VLSI design
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Advancements in Semiconductor Devices and Circuit Design
Keywords
pseudo-resistor, feedback control, weak inversion, subthreshold operation, linearity, impedance, MOS transistors

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review