The DOI matches its Crossref record; 47 of the 47 references it cites were found in a registry or an index.
Strain effects on the thermal conductivity of nanostructures
Abstract
Applying stress/strain on a material provides a mechanism to tune the thermal conductivity of materials dynamically or on demand. Experimental and simulation results have shown that thermal conductivity of bulk materials can change significantly under external pressure (compressive stress). However, stress/strain effects on the thermal conductivity of nanostructures have not been systematically studied. In this paper, equilibrium molecular-dynamics (EMD) simulation is performed to systematically study the strain effects on the lattice thermal conductivity of low-dimensional silicon and carbon materials: silicon nanowires (one dimensional) and thin-films (two dimensional), single-walled carbon nanotube (SWCNT, one dimensional) and single-layer graphene sheet (two dimensional). Spectral analysis of EMD is further developed and then applied to avoid the numerical artifacts such as the neglect of long-wavelength phonons that are often encountered when using EMD with periodic boundary conditions. Intrinsic thermal conductivity of the simulated bulk and nanostructures can be obtained using spectral analysis of EMD. The thermal conductivity of the strained silicon and diamond nanowires and thin films is shown to decrease continuously when the strain changes from compressive to tensile. However, for SWCNT and single-layer graphene, the thermal conductivity has a peak value, and the corresponding applied strain is at $\ensuremath{-}0.06$ or $\ensuremath{-}0.03$ for SWCNTs depending on the chirality and at zero for graphene, respectively. The following two reasons could explain well the effects of strains on the thermal conductivity of the nanowires and thin films that decreases continuously from compressive strain to tensile strain: (1) mode-specific group velocities of phonons decrease continuously from compressive strain to tensile strain and (2) the specific heat of each propagating phonon modes decrease continuously from compressive strain to tensile strain. However, for SWCNT and single-layer graphene, the mechanical instability induces buckling phenomenon when they are under compressive strains. The phonon-phonon scattering rate increases significantly when the structure buckles. This results in the decreasing behavior of thermal conductivity of SWCNT and graphene under compressive stress and explains the peak thermal conductivity value observed in SWCNT and single-layer graphene when they are under strain. The results obtained in this paper has important implications of challenging thermal management of electronics using advanced materials such as carbon nanotubes and graphene. It also points to a potentially new direction of dynamic thermal management.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Nano-sized transition-metal oxides as negative-electrode materials for lithium-ion batteries
Poizot, P., Laruelle, S., Grugeon, S., Dupont, L., & Tarascon, J.-M. (2000) · Nature · doi:10.1038/35035045 · Cited by 8,041
High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys
Poudel, B., Hao, Q., Ma, Y., Lan, Y., Minnich, A., Yu, B., Yan, X., Wang, D., Muto, A., Vashaee, D., et al. (2008) · Science · doi:10.1126/science.1156446 · Cited by 5,606
Computer simulation of local order in condensed phases of silicon
Stillinger, F. H., & Weber, T. A. (1985) · Physical Review B · doi:10.1103/physrevb.31.5262 · Cited by 5,302
Modeling solid-state chemistry: Interatomic potentials for multicomponent systems
Tersoff, J. (1989) · Physical Review B · doi:10.1103/physrevb.39.5566 · Cited by 4,134
Swope, W. C., Andersen, H. C., Berens, P. H., & Wilson, K. R. (1982) · The Journal of Chemical Physics · doi:10.1063/1.442716 · Cited by 4,051
The Art of Molecular Dynamics Simulation
Rapaport, D. C. (2004) · Cambridge University Press eBooks · doi:10.1017/cbo9780511816581 · Cited by 4,037
New Directions for Low‐Dimensional Thermoelectric Materials
Dresselhaus, M. S., Chen, G., Tang, M. Y., Yang, R. G., Lee, H., Wang, D. Z., Ren, Z. F., Fleurial, J. ‐., & Gogna, P. (2007) · Advanced Materials · doi:10.1002/adma.200600527 · Cited by 4,033
Self-citationA Note on the Generation of Random Normal Deviates
Box, G. E. P., & Muller, M. E. (1958) · The Annals of Mathematical Statistics · doi:10.1214/aoms/1177706645 · Cited by 3,401
Cahill, D. G., Ford, W. K., Goodson, K. E., Mahan, G. D., Majumdar, A., Maris, H. J., Merlin, R., & Phillpot, S. R. (2003) · Journal of Applied Physics · doi:10.1063/1.1524305 · Cited by 2,825
Quantum Dot Superlattice Thermoelectric Materials and Devices
Harman, T. C., Taylor, P. J., Walsh, M. P., & LaForge, B. E. (2002) · Science · doi:10.1126/science.1072886 · Cited by 2,495
Cited by
Thermal properties of graphene: Fundamentals and applications
Pop, E., Varshney, V., & Roy, A. K. (2012) · MRS Bulletin · doi:10.1557/mrs.2012.203 · Cited by 1,684
Transforming heat transfer with thermal metamaterials and devices
Li, Y., Li, W., Han, T., Zheng, X., Li, J., Li, B., Fan, S., & Qiu, C.-W. (2021) · Nature Reviews Materials · doi:10.1038/s41578-021-00283-2 · Cited by 676
Two‐Dimensional Fluorinated Graphene: Synthesis, Structures, Properties and Applications
Feng, W., Long, P., Feng, Y., & Li, Y. (2016) · Advanced Science · doi:10.1002/advs.201500413 · Cited by 640
Thermal Conductivity of Graphene and Graphite: Collective Excitations and Mean Free Paths
Fugallo, G., Cepellotti, A., Paulatto, L., Lazzeri, M., Marzari, N., & Mauri, F. (2014) · Nano Letters · doi:10.1021/nl502059f · Cited by 586
Wei, N., Xu, L., Wang, H.-Q., & Zheng, J.-C. (2011) · Nanotechnology · doi:10.1088/0957-4484/22/10/105705 · Cited by 428
Colloquium: Phononic thermal properties of two-dimensional materials
Gu, X., Wei, Y., Yin, X., Li, B., & Yang, R. (2018) · Reviews of Modern Physics · doi:10.1103/revmodphys.90.041002 · Cited by 378
Self-citationBending Rigidity and Gaussian Bending Stiffness of Single-Layered Graphene
Wei, Y., Wang, B., Wu, J., Yang, R., & Dunn, M. L. (2013) · Nano Letters · doi:10.1021/nl303168w · Cited by 370
Self-citationThermal and Thermoelectric Properties of Graphene
Xu, Y., Li, Z., & Duan, W. (2014) · Small · doi:10.1002/smll.201303701 · Cited by 300
Strong Thermal Transport Anisotropy and Strain Modulation in Single-Layer Phosphorene
Ong, Z.-Y., Cai, Y., Zhang, G., & Zhang, Y.-W. (2014) · The Journal of Physical Chemistry C · doi:10.1021/jp5079357 · Cited by 265
First-principles prediction of phononic thermal conductivity of silicene: A comparison with graphene
Gu, X., & Yang, R. (2015) · Journal of Applied Physics · doi:10.1063/1.4905540 · Cited by 256
Self-citation
Metadata
- Authors
- Li, X., Maute, K., Dunn, M. L., & Yang, R.
- Venue
- Physical Review B
- Publisher
- American Physical Society (APS)
- Published
- 2010-06-18
- Volume
- 81
- Issue
- 24
- ISSN
- 1098-0121 (ISSN-L)
- 1550-235X
- OpenAlex
- W2082763399
- Cited by
- 463
- References
- 47
- FWCI
- 10.66
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.