Integrated Receiver Including Both Receiver Channel and TDC for a Pulsed Time-of-Flight Laser Rangefinder With cm-Level Accuracy
The DOI matches its Crossref record.
Abstract
An integrated receiver that includes both the time-to-digital converter (TDC) and the receiver channel and is intended for a pulsed time-of-flight laser rangefinder with a measurement range of approximately 10 m has been designed and fabricated in a standard 0.13 mum CMOS process. The receiver operates by detecting the current pulse of an optical detector and producing a stop timing mark for the TDC by means of a leading edge timing discriminator. The TDC is used to measure the actual time interval between the start and stop pulses and the slew-rate of the stop pulse, to compensate for a walk error produced in the discriminator. The single-shot precision of the whole receiver is 250 ps for a minimum detectable signal, and its accuracy and power consumption are plusmn 37 ps with compensation within a dynamic range of at least 1:10,000 and less than 45 mW, respectively. The size of the die is 1300 mum times1300 mum including pads.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Wideband Receiver for a Three-Dimensional Ranging LADAR System
Ngo, T.-H., Kim, C.-H., Kwon, Y. J., Ko, J. S., Kim, D.-B., & Park, H.-H. (2013) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2012.2215800 · Cited by 68
“Namely, pulse length [4], amplitude [6], slew rate [7], or unipolar-to-bipolar pulse shaping [8] has been used to reduce this error.”
MethodA Linear-Mode LiDAR Sensor Using a Multi-Channel CMOS Transimpedance Amplifier Array
Hong, C., Kim, S.-H., Kim, J.-H., & Park, S. M. (2018) · IEEE Sensors Journal · doi:10.1109/jsen.2018.2852794 · Cited by 64
“As photodetectors, avalanche photodiodes (APDs) with high responsivity (∼50 A/W) have been extensively exploited to acquire the detection range up to several tens of meters [6]–[10].”
BackgroundInfluentialA Linear Dynamic Range Receiver with Timing Discrimination for Pulsed TOF Imaging LADAR Application
Zheng, H., Ma, R., Liu, M., & Zhu, Z. (2018) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2018.2826860 · Cited by 46
“Although [1], [4], [19], and [21] have a wider DRand lower walk error than the proposed receiver, however, the above-mentioned work cannot linearly capture the pulsed echo intensity signal for imaging LADAR application.”
Mirrored Current-Conveyor Transimpedance Amplifier for Home Monitoring LiDAR Sensors
Yoon, D., Joo, J.-E., & Park, S. M. (2021) · IEEE Sensors Journal · doi:10.1109/jsen.2020.3043797 · Cited by 23
“For these purposes, a small, low-power, low-cost LiDAR sensor can be a feasible solution not only because its blurred images can easily avoid portrait right violation, but also because it can provide strong immunity against ambient RF interferences from electronic devices at home [9]–[14].”
BackgroundMethodA CMOS AFE With 37-nA rms Input-Referred Noise and Marked 96-dB Timing DR for Pulsed LiDAR
Li, K., Guo, J., & Zhao, Y. (2022) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2022.3181133 · Cited by 14
“For the single-shot measurement application scenarios, the width [18], [22] or slew rate [23] of the echo pulse, or both of them [12], [24] can be measured and utilized to compensate for the walk”
Method
Metadata
- Authors
- Nissinen, J., Nissinen, I., & Kostamovaara, J.
- Venue
- IEEE Journal of Solid-State Circuits
- Published
- 2009-05
- Volume
- 44
- Issue
- 5
- Pages
- 1486-1497
- ISSN
- 0018-9200 (ISSN-L)
- OpenAlex
- W2113222684
- Cited by
- 103
- References
- 0
- FWCI
- 12.27
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Integrated Receiver Including Both Receiver Channel and TDC for a Pulsed Time-of-Flight Laser Rangefinder With cm-Level Accuracy. https://app.cochat.ai/papers/10.1109/jssc.2009.2017006
- The paper
- Nissinen, J., Nissinen, I., & Kostamovaara, J. (2009). Integrated Receiver Including Both Receiver Channel and TDC for a Pulsed Time-of-Flight Laser Rangefinder With cm-Level Accuracy. IEEE Journal of Solid-State Circuits. https://doi.org/10.1109/jssc.2009.2017006
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.