A 77-dB Dynamic Range Low-Power Variable-Gain Transimpedance Amplifier for Linear LADAR
The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Abstract
An adjustable-gain transimpedance amplifier with a wide linear dynamic range, low power consumption, and low input impedance was designed for a pulsed linear laser detection and ranging system. To extend the linear dynamic range within a low power consumption, some specific techniques are presented. A low-power current-mirror amplifier with a level shifter was used to decrease the input impedance and keep it stable. Adjustable transimpedance gain extends the input dynamic range, and a high-pass filter eliminates the influence of dc operating point drift caused by the variable gain. When implemented in 0.18-μm standard CMOS technology, the receiver achieved a high gain of 106 dB with four configurable gain modes, a wide linear output swing of 1 V, an input-referred noise current of √ 1.52 pA/ Hz, and a minimum detectable signal of 400 nA at SNR = 5, leading to a linear dynamic range of 77 dB, and the power consumption in the highest gain mode was 8 mW with a 3.3-V supply.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wideband Receiver for a Three-Dimensional Ranging LADAR System
Ngo, T.-H., Kim, C.-H., Kwon, Y. J., Ko, J. S., Kim, D.-B., & Park, H.-H. (2013) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2012.2215800 · Cited by 68 · cited 5×
“Compared to [1], the proposed TIA achieved a lower input impedance, higher gain, TABLE II PERFORMANCE COMPARISONS OF RECENTLY PUBLISHED”
BackgroundMethodResultInfluential
Cited by
A Linear-Mode LiDAR Sensor Using a Multi-Channel CMOS Transimpedance Amplifier Array
Hong, C., Kim, S.-H., Kim, J.-H., & Park, S. M. (2018) · IEEE Sensors Journal · doi:10.1109/jsen.2018.2852794 · Cited by 64
“The CM-TIA in [18] was also a current-mode topology, thus suffering worse noise than a voltage-mode TIA.”
BackgroundA Linear Dynamic Range Receiver with Timing Discrimination for Pulsed TOF Imaging LADAR Application
Zheng, H., Ma, R., Liu, M., & Zhu, Z. (2018) · IEEE Transactions on Instrumentation and Measurement · doi:10.1109/tim.2018.2826860 · Cited by 46
“The average inputreferred noise current spectral density can be calculated as follows [21], [22]:”
Self-citationA CMOS AFE With 37-nA rms Input-Referred Noise and Marked 96-dB Timing DR for Pulsed LiDAR
Li, K., Guo, J., & Zhao, Y. (2022) · IEEE Transactions on Circuits and Systems I: Regular Papers · doi:10.1109/tcsi.2022.3181133 · Cited by 14
“12 presents the test setup for the frequency response of the AFE, where a vector network analyzer (VNA) (Keysight E5063A) was used to provide the frequency-swept voltage source and S21 measurement, while a resistor in series with a voltage source was adopted to emulate a current source [7], [8], [31] and [36].”
Method
Metadata
- Authors
- Ma, R., Liu, M., Zheng, H., & Zhu, Z.
- Venue
- IEEE Transactions on Circuits and Systems II: Express Briefs
- Published
- 2018-02
- Volume
- 65
- Issue
- 2
- Pages
- 171-175
- ISSN
- 1549-7747 (ISSN-L)
- 1558-3791
- OpenAlex
- W2598994065
- Cited by
- 42
- References
- 1
- FWCI
- 2.56
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A 77-dB Dynamic Range Low-Power Variable-Gain Transimpedance Amplifier for Linear LADAR. https://app.cochat.ai/papers/10.1109/tcsii.2017.2684822
- The paper
- Ma, R., Liu, M., Zheng, H., & Zhu, Z. (2018). A 77-dB Dynamic Range Low-Power Variable-Gain Transimpedance Amplifier for Linear LADAR. IEEE Transactions on Circuits and Systems II: Express Briefs. https://doi.org/10.1109/tcsii.2017.2684822
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.