The DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Bridgeless SEPIC PFC Rectifier With Reduced Components and Conduction Losses
Abstract
In this paper, a new bridgeless single-ended primary inductance converter power-factor-correction rectifier is introduced. The proposed circuit provides lower conduction losses with reduced components simultaneously. In conventional PFC converters (continuous-conduction-mode boost converter), a voltage loop and a current loop are required for PFC. In the proposed converter, the control circuit is simplified, and no current loop is required while the converter operates in discontinuous conduction mode. Theoretical analysis and simulation results are provided to explain circuit operation. A prototype of the proposed converter is realized, and the results are presented. The measured efficiency shows 1% improvement in comparison to conventional SEPIC rectifier.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
An active power factor correction technique for three-phase diode rectifiers
Prasad, A. R., Ziogas, P. D., & Manias, S. (1991) · IEEE Transactions on Power Electronics · doi:10.1109/63.65006 · Cited by 522
The discontinuous conduction mode Sepic and Cuk power factor preregulators: analysis and design
Simonetti, D. S. L., Sebastion, J., & Uceda, J. (1997) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.633459 · Cited by 381
A high-performance single-phase rectifier with input power factor correction
Martinez, R., & Enjeti, P. N. (1996) · IEEE Transactions on Power Electronics · doi:10.1109/63.486181 · Cited by 279
A Bridgeless PFC Boost Rectifier With Optimized Magnetic Utilization
Jang, Y., & Jovanovic, M. M. (2009) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2008.2006054 · Cited by 263
Bridgeless SEPIC Rectifier With Unity Power Factor and Reduced Conduction Losses
Ismail, E. H. (2009) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.2007552 · Cited by 255
Analysis and design of a low-stress buck-boost converter in universal-input PFC applications
Chen, J., Maksimovic, D., & Erickson, R. W. (2006) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2005.869744 · Cited by 231
Comparison of basic converter topologies for power factor correction
Wei, H., & Batarseh, I. (2002) · Proceedings IEEE Southeastcon '98 'Engineering for a New Era' · doi:10.1109/secon.1998.673368 · Cited by 224
A novel active current waveshaping technique for solid-state input power factor conditioners
Kazerani, M., Ziogas, P. D., & Joos, G. (1991) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.103488 · Cited by 185
Su, B., & Lu, Z. (2010) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2010.2040633 · Cited by 172
A novel ZVT PWM Cuk power-factor corrector
Tseng, C.-J., & Chen, C. (1999) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.778240 · Cited by 73
Cited by
Mishra, A. K., Singh, A. K., & Kim, T. (2020) · IET Power Electronics · doi:10.1049/iet-pel.2020.0003 · Cited by 9
Metadata
- Authors
- Mahdavi, M., & Farzanehfard, H.
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 2011-09
- Volume
- 58
- Issue
- 9
- Pages
- 4153-4160
- ISSN
- 0278-0046 (ISSN-L)
- 1557-9948
- OpenAlex
- W2117998562
- Cited by
- 285
- References
- 14
- FWCI
- 6.98
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Bridgeless SEPIC PFC Rectifier With Reduced Components and Conduction Losses. https://app.cochat.ai/papers/10.1109/tie.2010.2095393
- The paper
- Mahdavi, M., & Farzanehfard, H. (2011). Bridgeless SEPIC PFC Rectifier With Reduced Components and Conduction Losses. IEEE Transactions on Industrial Electronics. https://doi.org/10.1109/tie.2010.2095393
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.
