The DOI matches its Crossref record; 15 of the 15 references it cites were found in a registry or an index.
Speed Control for PMSM Servo System Using Predictive Functional Control and Extended State Observer
Abstract
The speed regulation problem for permanent magnet synchronous motor (PMSM) servo system is studied in this paper. In order to optimize the control performance of the PMSM servo system, the predictive functional control (PFC) method is introduced in the control design of speed loop. The PFC-based speed control design consists of two steps. A simplified model is employed to predict the futureq-axis current of PMSM. Then, an optimal control law is obtained by minimizing a quadratic performance index. However, it is noted that the standard PFC method does not achieve a satisfying effect in the presence of strong disturbances. To this end, an improved PFC method, called the PFC+ESO method, is developed. It introduces extended state observer (ESO) to estimate the lumped disturbances and adds a feedforward compensation item based on the estimated disturbances to the PFC speed controller. Simulation and experiment comparisons are made for these PFC methods and proportional-integral method with antiwindup control method to verify the effectiveness of the proposed methods.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
From PID to Active Disturbance Rejection Control
Han, J. (2009) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.2011621 · Cited by 6,803 · cited 1×
“The detail principle of ESO can be found in [28], [29].”
BackgroundPredictive Control With Constraints
Maciejowski, J. M. (2001) · Cambridge University Engineering Department Publications Database · Cited by 4,368
Electric Motor Drivers: Modeling, Analysis, and Control
Krishnan, R. (2001) · Cited by 1,561
Adaptive Speed Control for Permanent-Magnet Synchronous Motor System With Variations of Load Inertia
Li, S., & Liu, Z. (2009) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2009.2024655 · Cited by 676
Self-citationDesign and Implementation of Model Predictive Control for Electrical Motor Drives
Bolognani, S., Bolognani, S., Peretti, L., & Zigliotto, M. (2009) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.2007547 · Cited by 452
Optimal control of nonlinear systems: a predictive control approach
Chen, W.-H., Ballance, D. J., & Gawthrop, P. J. (2003) · Automatica · doi:10.1016/s0005-1098(02)00272-8 · Cited by 418
A DSP-Based Active Disturbance Rejection Control Design for a 1-kW H-Bridge DC–DC Power Converter
Sun, B., & Gao, Z. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.855679 · Cited by 368
Baik, I.-C., Kim, K.-H., & Youn, M.-J. (2000) · IEEE Transactions on Control Systems Technology · doi:10.1109/87.817691 · Cited by 322
Su, Y. X., Zheng, C. H., & Duan, B. Y. (2005) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2005.847583 · Cited by 315
Disturbance-Rejection High-Precision Motion Control of a Stewart Platform
Su, Y. X., Duan, B. Y., Zheng, C. H., Zhang, Y. F., Chen, G. D., & Mi, J. W. (2004) · IEEE Transactions on Control Systems Technology · doi:10.1109/tcst.2004.824315 · Cited by 209
Cited by
Sliding-Mode Control for Systems With Mismatched Uncertainties via a Disturbance Observer
Yang, J., Li, S., & Yu, X. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2012.2183841 · Cited by 1,332
Self-citationYao, J., Jiao, Z., & Ma, D. (2014) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2014.2304912 · Cited by 708
Disturbance/Uncertainty Estimation and Attenuation Techniques in PMSM Drives—A Survey
Yang, J., Chen, W.-H., Li, S., Guo, L., & Yan, Y. (2017) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2016.2583412 · Cited by 695
Self-citationSliding Mode Control for Mismatched Uncertain Systems Using an Extended Disturbance Observer
Ginoya, D., Shendge, P. D., & Phadke, S. B. (2014) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2013.2271597 · Cited by 611
New Sliding-Mode Observer for Position Sensorless Control of Permanent-Magnet Synchronous Motor
Qiao, Z., Shi, T., Wang, Y., Yan, Y., Xia, C., & He, X. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2012.2206359 · Cited by 602
Continuous nonsingular terminal sliding mode control for systems with mismatched disturbances
Yang, J., Li, S., Su, J., & Yu, X. (2013) · Automatica · doi:10.1016/j.automatica.2013.03.026 · Cited by 587
Self-citationDesign and Implementation of Terminal Sliding Mode Control Method for PMSM Speed Regulation System
Li, S., Zhou, M., & Yu, X. (2013) · IEEE Transactions on Industrial Informatics · doi:10.1109/tii.2012.2226896 · Cited by 505
Self-citationAdaptive Robust Control of DC Motors With Extended State Observer
Yao, J., Jiao, Z., & Ma, D. (2014) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2013.2281165 · Cited by 435
Xue, W., Bai, W., Yang, S., Song, K., Huang, Y., & Xie, H. (2015) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2015.2435004 · Cited by 420
A New Reaching Law for Antidisturbance Sliding-Mode Control of PMSM Speed Regulation System
Wang, Y., Feng, Y., Zhang, X., & Liang, J. (2020) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2019.2933613 · Cited by 419
Active Disturbance Rejection Adaptive Control of Hydraulic Servo Systems
Yao, J., & Deng, W. (2017) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2017.2694382 · Cited by 418
Wang, J., Li, S., Yang, J., Wu, B., & Li, Q. (2015) · IET Control Theory & Applications · doi:10.1049/iet-cta.2014.0220 · Cited by 301
Self-citationYang, J., Su, J., Li, S., & Yu, X. (2014) · IEEE Transactions on Industrial Informatics · doi:10.1109/tii.2013.2279232 · Cited by 285
Self-citationFuzzy Adaptive Internal Model Control Schemes for PMSM Speed-Regulation System
Li, S., & Gu, H. (2012) · IEEE Transactions on Industrial Informatics · doi:10.1109/tii.2012.2205581 · Cited by 265
Self-citationRISE-Based Asymptotic Prescribed Performance Tracking Control of Nonlinear Servo Mechanisms
Wang, S., Na, J., & Ren, X. (2018) · IEEE Transactions on Systems, Man, and Cybernetics: Systems · doi:10.1109/tsmc.2017.2769683 · Cited by 159
Yang, C., Song, B., Xie, Y., Zheng, S., & Tang, X. (2023) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2023.3239609 · Cited by 37
“In the lumped-type identification, the friction and load torque are modeled as a lumped parameter, and then this parameter is determined in real time by means of a certain observer, such as sliding-mode observer (SMO) [6], [7], [8], [9], disturbance observer (DOB) [10], [11], and extended state observer (ESO) [12], [1…”
BackgroundYang, G. (2020) · Transactions of the Institute of Measurement and Control · doi:10.1177/0142331219883056 · Cited by 22
Metadata
- Authors
- Liu, H., & Li, S.
- Venue
- IEEE Transactions on Industrial Electronics
- Published
- 2012-02
- Volume
- 59
- Issue
- 2
- Pages
- 1171-1183
- ISSN
- 0278-0046 (ISSN-L)
- 1557-9948
- OpenAlex
- W2135216999
- Cited by
- 774
- References
- 15
- FWCI
- 22.95
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.