High Step-Up Converter With Coupled-Inductor
The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Abstract
In this study, a high step-up converter with a coupled-inductor is investigated. In the proposed strategy, a coupled inductor with a lower-voltage-rated switch is used for raising the voltage gain (whether the switch is turned on or turned off). Moreover, a passive regenerative snubber is utilized for absorbing the energy of stray inductance so that the switch duty cycle can be operated under a wide range, and the related voltage gain is higher than other coupled-inductor-based converters. In addition, all devices in this scheme also have voltage-clamped properties and their voltage stresses are relatively smaller than the output voltage. Thus, it can select low-voltage low-conduction-loss devices, and there are no reverse-recovery currents within the diodes in this circuit. Furthermore, the closed-loop control methodology is utilized in the proposed scheme to overcome the voltage drift problem of the power source under the load variations. As a result, the proposed converter topology can promote the voltage gain of a conventional boost converter with a single inductor, and deal with the problem of the leakage inductor and demagnetization of transformer for a coupled-inductor-based converter. Some experimental results via examples of a proton exchange membrane fuel cell (PEMFC) power source and a traditional battery are given to demonstrate the effectiveness of the proposed power conversion strategy.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Power electronics converters, applications and design
Robinson, F. V. P. (1997) · Microelectronics Journal · doi:10.1016/s0026-2692(97)87859-7 · Cited by 5,075
Power Electronics: Converters, Applications and Design
Mohan, N., Undeland, T. M., & Robbins, W. P. (1989) · Cited by 4,771
High-efficiency, high step-up DC-DC converters
Zhao, Q., & Lee, F. C. (2003) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2002.807188 · Cited by 1,015
Fuel cell systems: efficient, flexible energy conversion for the 21st century
Ellis, M. W., Von Spakovsky, M. R., & Nelson, D. J. (2001) · Proceedings of the IEEE · doi:10.1109/5.975914 · Cited by 449
Fuel cells, an alternative to standard sources of energy
Boudghene Stambouli, A., & Traversa, E. (2002) · Renewable and Sustainable Energy Reviews · doi:10.1016/s1364-0321(01)00015-6 · Cited by 442
Novel high-efficiency step-up converter
Tseng, K. C., & Liang, T. J. (2004) · IEE Proceedings - Electric Power Applications · doi:10.1049/ip-epa:20040022 · Cited by 435
Ro, K., & Rahman, S. (1998) · IEEE Transactions on Energy Conversion · doi:10.1109/60.707608 · Cited by 224
Isolated DC-DC converters with high-output voltage for TWTA telecommunication satellite applications
Barbi, I., & Gules, R. (2003) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.813762 · Cited by 162
Muraoka, H., & Nakaoka, M. (2002) · PESC record · doi:10.1109/pesc.2001.954335 · Cited by 24
Cited by
Forouzesh, M., Siwakoti, Y. P., Gorji, S. A., Blaabjerg, F., & Lehman, B. (2017) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2017.2652318 · Cited by 2,123
Review of Nonisolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications
Li, W., & He, X. (2011) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2010.2049715 · Cited by 1,423
Voltage Multiplier Cells Applied to Non-Isolated DC–DC Converters
Prudente, M., Pfitscher, L. L., Emmendoerfer, G., Romaneli, E. F., & Gules, R. (2008) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2007.915762 · Cited by 750
Recent advances and challenges of fuel cell based power system architectures and control – A review
Das, V., Padmanaban, S., Venkitusamy, K., Selvamuthukumaran, R., Blaabjerg, F., & Siano, P. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.01.148 · Cited by 459
High-Performance Stand-Alone Photovoltaic Generation System
Wai, R.-J., Wang, W.-H., & Lin, C.-Y. (2008) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2007.896049 · Cited by 453
Self-citation
Metadata
- Authors
- Wai, R.-J., & Duan, R.-Y.
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2005-09
- Volume
- 20
- Issue
- 5
- Pages
- 1025-1035
- ISSN
- 0885-8993 (ISSN-L)
- OpenAlex
- W2147345509
- Cited by
- 611
- References
- 9
- FWCI
- 6.99
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.